Federal Aviation Administration August 25, 2010 – Federal Register Recent Federal Regulation Documents

We propose to adopt a new airworthiness directive (AD) for all Diamond Aircraft Industries GmbH Models DA 40 and DA 40F airplanes. This proposed AD would change the emergency open doors procedure by incorporation of a temporary revision into the FAA-approved airplane flight manual for all airplanes. This proposed AD would also require replacement of the passenger door retaining bracket with an improved design retaining bracket for certain airplanes. This proposed AD results from several reports of the rear passenger door departing the airplane in flight. We are proposing this AD to change the emergency open doors procedure and retrofit the rear passenger door retaining bracket, which if not corrected could result in the rear passenger door departing the airplane in flight.

We are adopting a new airworthiness directive (AD) for the products listed above that will supersede an existing AD. This AD results from mandatory continuing airworthiness information (MCAI) issued by the aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

We are adopting a new airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

We are adopting a new airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

The FAA is superseding an existing airworthiness directive (AD) that applies to all Model 737-600, -700, -700C, -800, -900, and - 900ER series airplanes. The existing AD currently requires, for certain airplanes, a one-time detailed inspection of the inboard and outboard aft attach lugs of the left and right elevator tab control mechanisms for discrepancies, and replacement of any discrepant elevator tab control mechanism. For certain other airplanes, the existing AD requires that the inspections be done repetitively. Replacing the elevator tab control mechanism with a new Boeing-built mechanism terminates the repetitive inspections in the existing AD. This new AD requires that modified repetitive inspections be done on all airplanes, regardless of accomplishment of the terminating action specified in the existing AD. This AD results from reports of failure of the aft attach lugs on the elevator tab control mechanisms, which resulted in severe elevator vibration. This AD also results from reports of gaps in elevator tab control mechanisms and analysis that additional elevator tab control mechanisms might have bearings that will come loose. We are issuing this AD to detect and correct discrepancies in the aft attach lugs of the elevator tab control mechanism, which could result in elevator and tab vibration. Consequent structural failure of the elevator or horizontal stabilizer could result in loss of structural integrity and aircraft control.

We are adopting a new airworthiness directive (AD) for certain Hawker Beechcraft Corporation Model 390 airplanes. This AD requires you to inspect for installation of certain serial number (S/N) starter generators and replace the starter generator if one with an affected serial number is found. This AD results from reports that starter generators with deficient armature insulating materials may have been installed on certain airplanes. We are issuing this AD to detect and replace starter generators with defective armature insulating materials. This condition could result in the loss of operation of one or both starter generators with consequent loss of all non battery electrical power.