Federal Aviation Administration August 28, 2009 – Federal Register Recent Federal Regulation Documents
Results 1 - 4 of 4
Airworthiness Directives; Hawker Beechcraft Corporation Models 58, 58A, 58P, 58PA, 58TC, 58TCA, 95-B55, 95-B55A, A36, A36TC, B36TC, E55, E55A, F33A, and V35B Airplanes
We propose to supersede Airworthiness Directive (AD) 91-18-19, which applies to certain Hawker Beechcraft Corporation (Hawker) (Type Certificate Numbers 3A15, 3A16, and A23CE formerly held by Raytheon Aircraft Company; formerly held by Beech Aircraft Corporation) Models 58, 58A, 58P, 58PA, 58TC, 58TCA, 95-B55, 95-B55A, A36, A36TC, B36TC, E55, E55A, F33A, and V35B airplanes. AD 91-18-19 currently requires you to do a one-time inspection of the pilot and copilot shoulder harnesses for an incorrect washer and replace any incorrect washer with the correct washer. Since we issued AD 91-18-19, we have found that the applicability of AD 91-18-19 was incorrectly stated when the Model A36TC airplane was omitted from the Applicability section. Consequently, this proposed AD would retain the actions and the serial number (SN) applicability of AD 91-18-19 and realign the SN applicability for Models A36TC and B36TC airplanes. We are proposing this AD to detect and correct an incorrect washer installed in the pilot and copilot shoulder harnesses. This failure could result in a malfunctioning shoulder harness. Such a failure could lead to occupant injury.
Airworthiness Directives; Twin Commander Aircraft Corporation Models 690, 690A, and 690B Airplanes
We propose to adopt a new airworthiness directive (AD) for certain Twin Commander Aircraft Corporation Models 690, 690A, and 690B airplanes. This proposed AD would require you to inspect between the surface of the left-hand (LH) and right-hand (RH) upper wing skins and the engine mount beam support straps for any signs of corrosion, replace the upper steel straps with parts of improved design, and modify both wings. This proposed AD results from reports that corrosion was found between the mating surfaces of the wing upper skin surface and the engine mount beam support straps. We are proposing this AD to detect and correct corrosion on the engine mount beam support straps and the upper wing skins, which could result in failure of the engine mount beam support straps. This failure could lead to loss of the engine and possible loss of control of the airplane.
Agency Information Collection Activity Seeking OMB Approval
The FAA invites public comments about our intention to request the Office of Management and Budget's (OMB) revision of a current information collection. The Federal Register Notice with a 60-day comment period soliciting comments on the following collection of information was published on June 8, 2009, vol. 74, no. 108, page 27233-27234. Runway incursions are a risk to the public traveling in aircraft. Feedback from these surveys is used in the prevention of runway collisions and in the medication of the severity and frequency of runway incursions.
Special Conditions: Alenia Aeronautica Model C-27J Airplane; Interaction of Systems and Structures
These special conditions are issued for the Alenia Model C-27J airplane. This airplane will have novel or unusual design features when compared to the state of technology described in the airworthiness standards for transport-category airplanes. These special conditions pertain to the effects of novel or unusual design features such as effects on the structural performance of the airplane.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.