Federal Aviation Administration February 17, 2009 – Federal Register Recent Federal Regulation Documents

We propose to adopt a new airworthiness directive (AD) for the products listed above. This proposed AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

The FAA is issuing this notice to advise the public of a meeting of RTCA Special Committee 221: Aircraft Secondary Barriers.

The FAA is superseding an existing airworthiness directive (AD) for Turbomeca Turmo IV A and IV C series turboshaft engines. That AD is applicable to engines with oil-tank-to-oil-cooler flexible lubrication pipes, part number (P/N) 0 249 92 813 0 or P/N 0 249 92 916 0, installed. That AD currently requires identifying, inspecting, and replacing affected flexible lubrication pipes manufactured after April 1, 2003. That AD also requires initial and repetitive borescope inspections of affected pipes, visual inspections for oil leakage, and visual inspections of the oil filter. That AD also requires that if both engines on the same helicopter each have an affected pipe, replacing one of the affected pipes before further flight. This AD does not contain that requirement. This AD requires the same inspections as the superseded AD and adds inspection of oil-pump-to-intermediate- bearing flexible lubricating pipe, P/N 0 249 92 808 0. This AD also requires all remaining affected flexible lubrication pipes, P/N 0 249 92 813 0, P/N 0 249 92 916 0, and P/N 0 249 92 808 to be replaced as terminating action to the repetitive inspections for those affected pipes. This AD results from additional shutdowns caused by pipes, P/N 0 249 92 808 0, and the introduction of Turbomeca Modifications TU 231 and TU 233 that replace pipes, P/N 0 249 92 813 0, P/N 0 249 92 916 0, and P/N 0 249 92 808. We are issuing this AD to prevent helicopter engine in-flight shutdown of one or both engines resulting in an emergency auto-rotation landing or accident.

The FAA is adopting a new airworthiness directive (AD) for Rolls-Royce Corporation (RRC) AE 3007A1E and AE 1107C turbofan/ turboshaft engines. This AD requires removal from service of certain 2nd stage, 3rd stage, and 4th stage compressor wheels, compressor cone shaft assemblies, and 1st to 2nd-stage turbine spacers at new, reduced, published life limits. This AD results from RRC applying an updated lifing methodology to the affected parts. We are issuing this AD to prevent low-cycle-fatigue failure of the parts listed in Table 1 of this AD, which could result in an uncontained engine failure and damage to the aircraft.