Federal Aviation Administration November 12, 2008 – Federal Register Recent Federal Regulation Documents
Results 1 - 7 of 7
15th Meeting: RTCA Special Committee 206/EUROCAE WG 76 Plenary
The FAA is issuing this notice to advise the public of a meeting of RTCA Special Committee 206: Aeronautical Information Services Data Link.
Airworthiness Directives; Airbus Model A330-200, A330-300, and A340-300 Series Airplanes
We are adopting a new airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:
Airworthiness Directives; Airbus Model A310 Series Airplanes
We are adopting a new airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:
Airworthiness Directives; Boeing Model 747SP Series Airplanes
We are adopting a new airworthiness directive (AD) for all Boeing Model 747SP series airplanes. This AD requires repetitive lubrication of the rudder tab hinges and repetitive replacement of the rudder tab control rods. This AD results from reports of freeplay- induced vibration on the control surfaces on Boeing Model 727, 737, 757, and 767 airplanes. We are issuing this AD to prevent damage to the control surface structure during flight, which could result in loss of control of the airplane.
Airworthiness Directives; Boeing Model 727 Airplanes
We are adopting a new airworthiness directive (AD) for all Boeing Model 727 airplanes. This AD requires repetitive inspections for any crack in the area of the elevator side fitting/hinge fitting joint and for any crack or elongation inside and outside of the holes in the clevis and in the lug, corrective actions if necessary, and other specified actions. This AD results from reports of elongated holes and cracks found in the lugs of the attachment fittings of the elevator quadrant upper support assembly at the tip of the vertical fin. We are issuing this AD to detect and correct damage to the aft attachment lugs of the elevator quadrant support assembly that could lead to failure of the lugs. This condition could accelerate wear elsewhere in the elevator control system, which could reduce the crew's ability to maintain safe flight.
Airworthiness Directives; Boeing Model 757-200 and 757-300 Series Airplanes
We are adopting a new airworthiness directive (AD) for certain Boeing Model 757-200 and 757-300 series airplanes. This AD requires installing a bonding jumper between a ground and the clamp on the tube of the forward and aft gray water composite drain masts. For certain airplanes, this AD requires inspecting existing aft bonding jumper assemblies that might be too short, repair if necessary, and replacing the bonding jumper assembly with a new, longer bonding jumper assembly if necessary. This AD results from a report of charred insulation blankets and burned wires around the forward gray water composite drain mast found during an inspection of the forward cargo compartment on a Model 767-300F airplane. We are issuing this AD to prevent a fire near a composite drain mast and possible disruption of the electrical power system due to a lightning strike on a composite drain mast, which could result in the loss of several functions essential for safe flight.
Airworthiness Directives; Boeing Model 767-200 and -300 Series Airplanes
We are adopting a new airworthiness directive (AD) for certain Boeing Model 767-200 and -300 series airplanes. This AD requires replacing the wire segments of the four Fuel Quantity Indicating System (FQIS) wire bundles with new, improved wire segments. This AD results from operator inspections of the FQIS wire bundles that revealed corrosion at the connections between the ground wire and shield of each of the four FQIS wire bundles. We are issuing this AD to prevent this corrosion, which could reduce system protection of the lightning shield and result in loss of the electrical grounding between the lightning shield and the airplane structure. This condition, in combination with flammable fuel vapors, could result in fuel tank explosions and consequent loss of the airplane.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
