Federal Aviation Administration July 10, 2008 – Federal Register Recent Federal Regulation Documents

We propose to adopt a new airworthiness directive (AD) for the products listed above. This proposed AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

We are adopting a new airworthiness directive (AD) for certain Cirrus Design Corporation (CDC) Models SR20 and SR22 airplanes. This AD requires you to replace the cabin door rod ends with new parts including a redesigned non-binding hinge pin that replaces the existing pin at the upper door hinge. This AD results from two known occurrences of in-flight cabin door separation (one total separation and one retained by the door strut). The rod ends, a component of the door hinges, may fail and result in a door separation from the airplane while in flight. We are issuing this AD to prevent in-flight failure of the cabin door, which could result in door separation from the airplane.

We are adopting a new airworthiness directive (AD) for all Boeing Model 747 airplanes listed above. This AD requires repetitive inspections for broken or missing fasteners in the single-row hinge fasteners of the forward and aft cargo doors, and related investigative/corrective actions. This AD results from reports of broken and missing fasteners in the hinges of the forward and aft cargo doors in both the body hinge segments and the door hinge segments. We are issuing this AD to detect and correct broken or missing fasteners in the hinge segments with a single fastener row, which could lead to opening of the cargo door during flight and result in rapid decompression of the airplane.

The FAA is superseding an existing airworthiness directive (AD) for certain fuel injected reciprocating engines manufactured by Lycoming Engines. That AD currently requires inspection, and replacement if necessary, of externally mounted fuel injector fuel lines. This AD requires the same actions but adds additional engine models and clarifies certain compliance time wording. This AD also exempts engines that have a Maintenance and Overhaul Manual with an Airworthiness Limitations Section that requires inspection and replacement, if necessary, of externally mounted fuel injector lines. This AD results from Lycoming Engines revising their Mandatory Service Bulletin to add new engine models requiring inspection, and from the need to clarify a repetitive inspection compliance time. We are issuing this AD to prevent failure of the fuel injector fuel lines that would allow fuel to spray into the engine compartment, resulting in an engine fire.

We are adopting a new airworthiness directive (AD) for the specified Bell Helicopter Textron Canada (BHTC) helicopters. This AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority to identify and correct an unsafe condition on an aviation product. The Aviation Authority of Canada with whom we have a bilateral agreement states in the MCAI: ``Horizontal stabilizers part numbers 206-023-119-167 and 407-023-801-109 may have manufacturing flaws on the inside surface of the upper and/or lower skin at the tailboom attachment inserts. These flaws may result in cracking of the skin and failure of the horizontal stabilizer.'' The manufacturer's service information states that in addition to cracks, the horizontal stabilizer may have deformation or debonding around and between the inserts. We are issuing this AD to require actions to correct the unsafe condition on these products.