Department of Transportation March 11, 2024 – Federal Register Recent Federal Regulation Documents

This action amends the Class D and Class E airspace and revokes Class E airspace at Clarksburg, WV. This action is the result of a biennial airspace review. This action brings the airspace into compliance with FAA orders to support instrument flight rule (IFR) operations.

These special conditions are issued for the Gulfstream Aerospace Corporation (Gulfstream) Model GVIII-G700 and GVIII-G800 series airplanes. These airplanes will have a novel or unusual design feature when compared to the state of technology envisioned in the airworthiness standards for transport-category airplanes. This design feature is a high-incidence protection system that limits the angle of attack at which the airplane can be flown during normal low speed operation. The applicable airworthiness regulations do not contain adequate or appropriate safety standards for this design feature. These special conditions contain the additional safety standards that the Administrator considers necessary to establish a level of safety equivalent to that established by the existing airworthiness standards.

In accordance with the procedures governing the application for, and the processing of, special permits from the Department of Transportation's Hazardous Material Regulations, notice is hereby given that the Office of Hazardous Materials Safety has received the application described herein.

This notice contains a summary of a petition seeking relief from specified requirements of Federal Aviation Regulations. The purpose of this notice is to improve the public's awareness of, and participation in, the FAA's exemption process. Neither publication of this notice nor the inclusion nor omission of information in the summary is intended to affect the legal status of the petition or its final disposition.

The FAA proposes to adopt a new airworthiness directive (AD) for certain The Boeing Company Model 737-8, 737-9, and 737-8200 airplanes. This proposed AD was prompted by a report of a non- conforming installation of spoiler wire bundles that led to unintended spoiler motion, including one instance of spoiler hardover. Further investigation identified the potential for a hardover of more than one flight spoiler on the same wing, which can exceed full lateral control capability leading to loss of control of the airplane. This proposed AD would require a one-time inspection of the clearance between the spoiler control wire bundles and the adjacent structure, and applicable on-condition actions. The FAA is proposing this AD to address the unsafe condition on these products.

The FAA proposes to supersede Airworthiness Directive (AD) 2021-11-17 and AD 2021-11-22, which apply to all Airbus Helicopters Deutschland GmbH (AHD) Model EC135P1, EC135P2, EC135P2+, EC135P3, EC135T1, EC135T2, EC135T2+, and EC135T3 helicopters. AD 2021-11-17 requires a one-time visual inspection of certain part-numbered main rotor actuators (MRAs). AD 2021-11-22 requires revising the life limits of certain parts and removing each part that has reached its life limit. Since the FAA issued those ADs, it was determined that repetitive inspections of the MRAs are necessary, new and more restrictive tasks and limitations have been issued, and that it is necessary to expand the applicability. This proposed AD would continue to require the actions required by AD 2021-11-17 and AD 2021-11-22, except this proposed AD would require changing the one-time MRA inspection to a repetitive inspection and incorporating other new and more restrictive tasks and limitations by revising the airworthiness limitations section (ALS) of the existing helicopter maintenance manual or instructions for continued airworthiness and the existing approved maintenance or inspection program, as applicable. This proposed AD would also expand the applicability by adding Model EC635T2+ helicopters. These actions are specified in a European Union Aviation Safety Agency (EASA) AD, which is proposed for incorporation by reference. The FAA is proposing this AD to address the unsafe condition on these products.