Department of Transportation October 21, 2022 – Federal Register Recent Federal Regulation Documents
Results 1 - 16 of 16
Airworthiness Directives; MHI RJ Aviation ULC (Type Certificate Previously Held by Bombardier, Inc.) Airplanes
The FAA is adopting a new airworthiness directive (AD) for certain MHI RJ Aviation ULC Model CL-600-2B19 (Regional Jet Series 100 & 440) airplanes, Model CL-600-2C10 (Regional Jet Series 700, 701 & 702) airplanes, Model CL-600-2C11 (Regional Jet Series 550) airplanes, Model CL-600-2D15 (Regional Jet Series 705) airplanes, Model CL-600- 2D24 (Regional Jet Series 900) airplanes, and Model CL-600-2E25 (Regional Jet Series 1000) airplanes. This AD was prompted by reports of corrosion on fuel clamshell couplings installed in the fuel tank, and a determination that new or more restrictive airworthiness limitations are necessary. This AD requires removing and replacing the fuel clamshell couplings on certain airplanes, and revising the existing maintenance or inspection program, as applicable, to incorporate new or more restrictive airworthiness limitations. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Bombardier, Inc., Airplanes
The FAA is adopting a new airworthiness directive (AD) for certain Bombardier, Inc., Model CL-600-1A11 (600), CL-600-2A12 (601), and CL-600-2B16 (601-3A, 601-3R, and 604 Variants) airplanes. This AD was prompted by a report that some rudder power control unit (PCU) load limiters were found in service with the crimping missing from the end cap; therefore, the pilot command from the load limiter might not transmit correctly. This AD requires a one-time inspection of the rudder PCU load limiters for correct crimping of the end cap, and replacing any defective rudder PCU load limiter. For certain airplanes, this AD would also require repetitive testing of the rudder PCU load limiter for correct functioning, and applicable corrective actions. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Airbus Canada Limited Partnership (Type Certificate Previously Held by C Series Aircraft Limited Partnership (CSALP); Bombardier, Inc.) Airplanes
The FAA is adopting a new airworthiness directive (AD) for certain Airbus Canada Limited Partnership Model BD-500-1A10 and BD-500- 1A11 airplanes. This AD was prompted by the discovery that overwing emergency exit door (OWEED) handle covers were difficult to open on some airplanes. This AD requires replacing the existing OWEED handle cover brackets with newly designed OWEED handle cover brackets and installing placards regarding this replacement, as specified in a Transport Canada Civil Aviation (TCCA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Airbus SAS Airplanes
The FAA is adopting a new airworthiness directive (AD) for all Airbus SAS Model A300 B2K-3C, B2-203, B4-2C, and B4-203 airplanes. This AD was prompted by reports of cracking of the flight compartment aft window frame and adjacent fuselage skin. This AD requires require a one-time check for previously accomplished repairs of the window pane and adjacent fuselage panel, and applicable corrective actions, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Bombardier, Inc., Airplanes
The FAA is adopting a new airworthiness directive (AD) for certain Bombardier, Inc., Model BD-700-2A12 airplanes. This AD was prompted by reports of insufficient clearance between the surrounding structure/skin of the aircraft and select bleed air ducts that supply the wing ice protection system (WIPS) in the rear fuselage. This AD requires inspecting the bleed air duct and surrounding structure for minimum clearance and damage, and applicable corrective actions. The FAA is issuing this AD to address the unsafe condition on these products.
Establishment of Class E Airspace; Ellsworth, KS
This action establishes Class E airspace at Ellsworth, KS. This action is the result of new public instrument procedures being established at Ellsworth Municipal Airport, Ellsworth, KS.
BNSF Railway Company's Request To Amend Its Positive Train Control Safety Plan and Positive Train Control System
This document provides the public with notice that, on October 5, 2022, BNSF Railway Company (BNSF) submitted an updated request for amendment (RFA) to its FRA-approved Positive Train Control Safety Plan (PTCSP). As this RFA may involve a request for FRA's approval of proposed material modifications to an FRA-certified positive train control (PTC) system, FRA is publishing this notice and inviting public comment on the railroad's RFA to its PTCSP.
Notice of Availability for Proposed Voluntary Agreement at Statue of Liberty National Monument and Governors Island National Monument
The FAA, in cooperation with the National Park Service (NPS), has initiated development of a voluntary agreement pursuant to the National Parks Air Tour Management Act of 2000 (the Act) and its implementing regulations. The Act allows the FAA and NPS to enter into voluntary agreements with commercial air tour operators. A voluntary agreement manages commercial air tour operations over a national park by establishing conditions for the conduct of the commercial air tour operations. Implementation of a voluntary agreement helps protect park resources and the visitor experience without compromising aviation safety or the air traffic control system. This notice announces the public availability of the proposed voluntary agreement for Statue of Liberty National Monument and Governors Island National Monument (collectively referred to as the Parks).
Airworthiness Directives; MHI RJ Aviation ULC (Type Certificate Previously Held by Bombardier, Inc.) Airplanes
The FAA is revising a notice of proposed rulemaking (NPRM) that would have applied to all MHI RJ Aviation ULC Model CL-600-2B19 (Regional Jet Series 100 & 440) airplanes. This action revises the NPRM by proposing to require an inspection for correct installation of the flexible lamp assembly; trimming and reidentifying a bracket; and for certain airplanes, an inspection for damage of the wire harness assembly; and applicable corrective actions. The FAA is proposing this airworthiness directive (AD) to address the unsafe condition on these products. Since these actions would impose an additional burden over those in the NPRM, the FAA is requesting comments on this SNPRM.
Airworthiness Directives; Dassault Aviation Airplanes
The FAA proposes to adopt a new airworthiness directive (AD) for certain Dassault Aviation Model FALCON 7X airplanes. This proposed AD was prompted by a report of smoke in the flightdeck and loss of the right-hand (RH) primary display unit (PDU) and the secondary flight display (SFD). This proposed AD would require inspecting the two electrical power feeders for damage (deterioration), measuring the clearance between the two electrical power feeders and the forward lavatory bulkhead, and applicable corrective actions, as specified in a European Union Aviation Safety Agency (EASA) AD, which is proposed for incorporation by reference (IBR). The FAA is proposing this AD to address the unsafe condition on these products.
Airworthiness Directives; BAE Systems (Operations) Limited Airplanes
The FAA proposes to supersede Airworthiness Directives (ADs) 2005-15-11, 2016-07-09, and 2018-19-24, which apply to all BAE Systems (Operations) Limited Model 4101 airplanes. AD 2005-15-11 requires repetitive detailed and specialized inspections to detect fatigue damage in the fuselage, replacement of certain bolt assemblies, and corrective actions if necessary. AD 2016-07-09 requires a revision of the maintenance or inspection program, as applicable. AD 2018-19-24 requires a one-time detailed inspection of a certain fuselage frame and repair, if necessary, and a revision of the maintenance or inspection program, as applicable, to incorporate new or revised maintenance instructions and airworthiness limitations. Since the FAA issued those ADs, the FAA has determined that new or more restrictive airworthiness limitations are necessary. This proposed AD would continue to require the actions in AD 2016-07-09 and 2018-19-24 and require revising the existing maintenance or inspection program, as applicable, to incorporate new or more restrictive airworthiness limitations. The FAA is proposing this AD to address the unsafe condition on these products.
Airworthiness Directives; Airbus SAS Airplanes
The FAA proposes to adopt a new airworthiness directive (AD) for certain Airbus SAS Model A321-251NX, A321-252NX, A321-253NX, A321- 271NX and A321-272NX airplanes. This proposed AD was prompted by an emergency exit slide deployment test on an Airbus Cabin Flex (ACF) overwing emergency exit, the emergency exit slide did not deploy due to disconnected slide release cable junction. This proposed AD would require a one-time detailed inspection of the installation of the ACF overwing emergency exit slide release mechanism for discrepancies, and applicable corrective actions, as specified in a European Union Aviation Safety Agency (EASA) AD, which is proposed for incorporation by reference. The FAA is proposing this AD to address the unsafe condition on these products.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.