Department of Transportation September 27, 2022 – Federal Register Recent Federal Regulation Documents
Results 1 - 7 of 7
Airworthiness Directives; Airbus SAS Airplanes
The FAA proposes to supersede Airworthiness Directive (AD) 2022-07-10, which applies to all Airbus SAS Model A350-941 and -1041 airplanes. AD 2022-07-10 requires revising the operator's existing FAA- approved minimum equipment list (MEL) to include dispatch restrictions. AD 2022-07-10 also allows operators to inspect affected parts for discrepancies, and do applicable replacements, in order to terminate the revision of the operator's existing MEL. AD 2022-07-10 also prohibits the installation of affected parts. Since the FAA issued AD 2022-07-10, a determination was made that the optional inspection and applicable replacements should be required. This proposed AD continues to require the actions in AD 2022-07-10, and would mandate the inspection of affected parts and applicable replacements, as specified in a European Union Aviation Safety Agency (EASA) AD, which was incorporated by reference. The FAA is proposing this AD to address the unsafe condition on these products.
Airworthiness Directives; De Havilland Aircraft of Canada Limited (Type Certificate Previously Held by Bombardier, Inc.) Airplanes
The FAA is adopting a new airworthiness directive (AD) for certain De Havilland Aircraft of Canada Limited Model DHC-8-400 series airplanes. This AD was prompted by reports of broken P-clamps on the pressure relief line and the motive flow line in the fuel tanks, and a subsequent determination that certain service information lacked instructions for maintaining appropriate clearance between certain fuel tubes and their support brackets, and may also have led to incorrect installation of certain TeflonTM sleeves. This AD was also prompted by a determination that new or more restrictive airworthiness limitations are necessary. This AD requires inspecting the motive flow line, vent line, and related parts, and adding support or additional clearance if necessary. This AD also requires inspection, and replacement or relocation if necessary, of affected TeflonTM sleeves on the vent line, and installation of TeflonTM sleeves on the vent line at additional wing stations. This AD also requires revising the existing maintenance or inspection program, as applicable, to incorporate new or more restrictive airworthiness limitations. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; GE Aviation Czech s.r.o. (Type Certificate Previously Held by WALTER Engines a.s., Walter a.s., and MOTORLET a.s.) Turboprop Engines
The FAA proposes to adopt a new airworthiness directive (AD) for certain GE Aviation Czech s.r.o. (GEAC) M601D-11, M601E-11, M601E- 11A, M601E-11AS, M601E-11S, M601F, H75-100, H75-200, H80, H80-100, H80- 200, H85-100, and H85-200 model turboprop engines. This proposed AD was prompted by reports of cracks in dilution tube weld areas of the combustion chamber outer liner. This proposed AD would require initial and repetitive borescope inspections (BSIs) of the dilution tube weld areas of the combustion chamber outer liner and, depending on the results of the inspections, replacement of the combustion chamber outer liner with a part eligible for installation. The FAA is proposing this AD to address the unsafe condition on these products.
Rescinding the Notice of Intent To Prepare Environmental Impact Statement (EIS): Hawaii County, Hawaii
The FHWA is issuing this notice to advise the public that it is rescinding its Notice of Intent (NOI) and will not be preparing an Environmental Impact Statement (EIS) for a proposed highway project in Hawaii County, Hawaii. A NOI to prepare an EIS was published in the Federal Register on March 18, 2014.
Airworthiness Directives; Airbus SAS Airplanes
The FAA proposes to adopt a new airworthiness directive (AD) for all Airbus SAS Model A300 series airplanes; Model A300 B4-600, B4- 600R, and F4-600R series airplanes, and Model A300 C4-605R Variant F airplanes (collectively called Model A300-600 series airplanes); and Model A310 series airplanes. This proposed AD was prompted by a report that a Model A319 airplane lost the right-hand front windshield in flight. Due to the design similarity, this condition can also exist or develop on Model A300, A300-600, and A310 series airplanes. This proposed AD would require repetitive inspections and electrical test measurements (ETMs) of the affected parts, and applicable corrective actions, and would prohibit the installation of affected parts under certain conditions; as specified in a European Union Aviation Safety Agency (EASA) AD, which is proposed for incorporation by reference. The FAA is proposing this AD to address the unsafe condition on these products.
Agency Information Collection Activity Under OMB Review: Passenger Ferry Grant Program, Electric or Low Emitting Ferry Pilot Program, and Ferry Service for Rural Communities Program
In accordance with the Paperwork Reduction Act of 1995, this notice announces the intention of the Federal Transit Administration (FTA) to request the Office of Management and Budget (OMB) to approve the extension of a currently approved information collection. FTA began the Passenger Ferry Grant Program, Electric or Low Emitting Ferry Pilot Program, and Ferry Service for Rural Communities Program in June 2022 under OMB emergency approval and is seeking renewal of this approval through OMB's standard PRA clearance process: Passenger Ferry Grant Program, Electric or Low Emitting Ferry Pilot Program, and Ferry Service for Rural Communities Program.
Agency Information Collection Activity Under OMB Review: All Stations Accessibility Program (ASAP)
In accordance with the Paperwork Reduction Act of 1995, this notice announces the intention of the Federal Transit Administration (FTA) to request the Office of Management and Budget (OMB) to approve the extension of a currently approved information collection. FTA began the All Stations Accessibility Program (ASAP) in June 2022 under OMB emergency approval and is seeking renewal of this approval through OMB's standard PRA clearance process: All Stations Accessibility Program (ASAP).
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
