Department of Transportation September 26, 2022 – Federal Register Recent Federal Regulation Documents

In accordance with the Paperwork Reduction Act of 1995, FAA invites public comments about our intention to request the Office of Management and Budget (OMB) approval to renew an information collection. The collection involves planned routes of flight and aircraft avionics equipment. The information that is collected will be used to predict whether an aircraft flying the proposed route of flight will have sufficient position accuracy and integrity for the following: (1) Navigation, via the Receiver Autonomous Integrity Monitoring (RAIM) SAPT; (2) Surveillance, via the Automatic Dependent Surveillance Broadcast (ADS-B) SAPT. In addition, the website will allow operators to request authorization to operate in ADS-B-Out rule airspace with aircraft that do not fully meet the ADS-B Out requirements via: (3) ADS-B Deviation Authorization Pre-flight Tool (ADAPT)

The FHWA invites public comments about our intention to request the Office of Management and Budget's (OMB) approval to submit one information collection, which is summarized below under SUPPLEMENTARY INFORMATION. We published a Federal Register Notice with a 60-day public comment period on this information collection on June 17, 2022. We are required to publish this notice in the Federal Register by the Paperwork Reduction Act of 1995.

The FAA is adopting a new airworthiness directive (AD) for certain The Boeing Company Model 767-2C series airplanes. This AD was prompted by a report that insufficient clearance was found between the right stabilizer trim shut-off control wire (bundle W0589) and an elevator control cable. This AD requires a one-time inspection for insufficient clearance between the elevator control cable and wire bundle W0589 on the airplane's left crown, and applicable on-condition actions. The FAA is issuing this AD to address the unsafe condition on these products.

This rule establishes, amends, suspends, or removes Standard Instrument Approach Procedures (SIAPS) and associated Takeoff Minimums and Obstacle Departure procedures (ODPs) for operations at certain airports. These regulatory actions are needed because of the adoption of new or revised criteria, or because of changes occurring in the National Airspace System, such as the commissioning of new navigational facilities, adding new obstacles, or changing air traffic requirements. These changes are designed to provide safe and efficient use of the navigable airspace and to promote safe flight operations under instrument flight rules at the affected airports.

In accordance with the Paperwork Reduction Act of 1995, FAA invites public comments about our intention to request the Office of Management and Budget (OMB) approval to renew an information collection. The Federal Register Notice with a 60-day comment period soliciting comments on the following collection of information was published on January 13, 2022. The FAA collects information from applicants for experimental permits in order to determine whether they satisfy the requirements for obtaining an experimental permit.

The FAA proposes to supersede Airworthiness Directive (AD) 2013-05-13, which applies to certain Rolls-Royce Deutschland Ltd & Co KG (RRD) BR700-710 series turbofan engines. AD 2013-05-13 requires replacing the affected fuel pump splined couplings. Since the FAA issued AD 2013-05-13, the manufacturer has revised the time limits manual (TLM), introducing new and more restrictive instructions, including the replacement of the fuel pump splined coupling. This proposed AD would expand the applicability by adding a model turbofan engine to the applicability and would also require revisions to the airworthiness limitations section (ALS) of the operator's existing approved aircraft maintenance program (AMP), as specified in a European Union Aviation Safety Agency (EASA) AD, which is proposed for incorporation by reference (IBR). The FAA is proposing this AD to address the unsafe condition on these products.