Department of Transportation September 12, 2019 – Federal Register Recent Federal Regulation Documents

This amendment adopts miscellaneous amendments to the required IFR (instrument flight rules) altitudes and changeover points for certain Federal airways, jet routes, or direct routes for which a minimum or maximum en route authorized IFR altitude is prescribed. This regulatory action is needed because of changes occurring in the National Airspace System. These changes are designed to provide for the safe and efficient use of the navigable airspace under instrument conditions in the affected areas.

This notice announces action taken by FHWA and other Federal agencies that are final. The actions relate to the Van Wyck Expressway Capacity and Access Improvements to John F. Kennedy (JFK) Airport Project located in Queens County, New York.

The FAA is correcting an airworthiness directive (AD) that published in the Federal Register. That AD applies to certain The Boeing Company Model 737-100, 737-200, 737-200C, 737-300, 737-400, and 737-500 series airplanes. As published, a paragraph reference specified in the regulatory text is incorrect. This document corrects that error. In all other respects, the original document remains the same.

FCA US LLC (f/k/a Chrysler Group LLC) (``FCA US''), has determined that certain MY 2014-2019 Fiat 500 motor vehicles do not comply with Federal Motor Vehicle Safety Standard (FMVSS) No. 138, Tire Pressure Monitoring Systems. FCA US filed a noncompliance report dated April 11, 2019 and subsequently petitioned NHTSA on May 3, 2019, for a decision that the subject noncompliance is inconsequential as it relates to motor vehicle safety. This document announces receipt of FCA US's petition.

The FAA is superseding Airworthiness Directive (AD) 2019-06- 09, which applied to certain Airbus SAS Model A350-941 airplanes. AD 2019-06-09 required repetitive tightness checks of the baby bassinet inserts installed on stowages and partitions and, depending on findings, accomplishment of applicable corrective actions, as specified in a European Aviation Safety Agency (EASA) AD, which was incorporated by reference. This new AD continues to require repetitive tightness checks of the baby bassinet inserts installed on stowages and partitions and, depending on findings, accomplishment of applicable corrective actions, and also requires modification of the baby bassinet inserts, which constitutes terminating action for the repetitive tightness checks; as specified in an EASA AD, which is incorporated by reference. This AD was prompted by reports that baby bassinet inserts installed on airplane stowages and partitions were found loose because a self-securing fixation device (Loctite) had not been applied. The FAA is issuing this AD to address the unsafe condition on these products.

The FAA is withdrawing the NPRM published in the Federal Register on August 14, 2019, to amend Class E airspace extending upward from 700 feet above the surface at Marshalltown Municipal Airport, Marshalltown, IA. Upon further consideration, the FAA has determined that an operational requirement for the airspace still exists; therefore, withdrawal of the proposed rule is warranted

FMCSA amends its hours-of-service (HOS) requirements applicable to drivers of property-carrying commercial motor vehicles (CMVs) to remove provisions requiring that a 34-hour restart include two periods between 1 a.m. and 5 a.m. and limiting use of a restart to once every 168 hoursprovisions that were promulgated in December 2011. In a series of Appropriations Acts, Congress suspended these provisions, pending completion of a naturalistic study comparing the effects of the restart provisions in effect under the 2011 rule versus provisions in effect prior to the 2011 rule's compliance date. The 2017 naturalistic study found no statistically significant benefits from the restart rule. Pursuant to a 2017 Appropriations Act, the 2011 restart rules are therefore void by operation of law. Although not in effect, the provisions remain in the Code of Federal Regulations (CFR), which could cause confusion for some stakeholders.

The FAA proposes to supersede Airworthiness Directive (AD) 2019-03-19, which applies to all Saab AB, Saab Aeronautics Model SAAB 2000 airplanes. AD 2019-03-19 requires a functional check of certain fuel probes, and replacement with a serviceable part if necessary. Since the FAA issued AD 2019-03-19, the agency has determined the definition of a ``serviceable part'' must be revised. This proposed AD would retain a functional check of certain fuel probes, and replacement with a serviceable part if necessary. The FAA is proposing this AD to address the unsafe condition on these products.