Department of Transportation March 12, 2019 – Federal Register Recent Federal Regulation Documents

Airworthiness Directives; Airbus SAS Airplanes
Document Number: 2019-04479
Type: Rule
Date: 2019-03-12
Agency: Federal Aviation Administration, Department of Transportation
We are superseding Airworthiness Directive (AD) 2015-12-08, which applied to all Airbus SAS Model A318 and A319 series airplanes and all Model A320-211, A320-212, A320-214, A320-231, A320-232, A320- 233, A321-111, A321-112, A321-131, A321-211, A321-212, A321-213, A321- 231, and A321-232 airplanes. AD 2015-12-08 required an inspection to determine the batch number or installation date of the oxygen pipe assembly that is installed at the end of the right-hand crew distribution line, and replacement of the pipe if necessary. This AD revises the applicability to include additional airplane models and additional pipes to be replaced if necessary. This AD was prompted by further investigation that determined that affected oxygen pipes may have been installed on more airplanes than initially identified. We are issuing this AD to address the unsafe condition on these products.
Hazardous Materials: Notice of Applications for Special Permits
Document Number: 2019-04453
Type: Notice
Date: 2019-03-12
Agency: Pipeline and Hazardous Materials Safety Administration, Department of Transportation
In accordance with the procedures governing the application for, and the processing of, special permits from the Department of Transportation's Hazardous Material Regulations, notice is hereby given that the Office of Hazardous Materials Safety has received the application described herein. Each mode of transportation for which a particular special permit is requested is indicated by a number in the ``Nature of Application'' portion of the table below as follows: 1 Motor vehicle, 2Rail freight, 3Cargo vessel, 4Cargo aircraft only, 5Passenger-carrying aircraft.
Hazardous Materials: Notice of Applications for Special Permits
Document Number: 2019-04452
Type: Notice
Date: 2019-03-12
Agency: Pipeline and Hazardous Materials Safety Administration, Department of Transportation
In accordance with the procedures governing the application for, and the processing of, special permits from the Department of Transportation's Hazardous Material Regulations, notice is hereby given that the Office of Hazardous Materials Safety has received the application described herein.
Hazardous Materials: Notice of Applications for Special Permits
Document Number: 2019-04451
Type: Notice
Date: 2019-03-12
Agency: Pipeline and Hazardous Materials Safety Administration, Department of Transportation
In accordance with the procedures governing the application for, and the processing of, special permits from the Department of Transportation's Hazardous Material Regulations, notice is hereby given that the Office of Hazardous Materials Safety has received the application described herein. Each mode of transportation for which a particular special permit is requested is indicated by a number in the ``Nature of Application'' portion of the table below as follows: 1 Motor vehicle, 2Rail freight, 3Cargo vessel, 4Cargo aircraft only, 5Passenger-carrying aircraft.
Petition for Waiver of Compliance
Document Number: 2019-04446
Type: Notice
Date: 2019-03-12
Agency: Federal Railroad Administration, Department of Transportation
Petition for Special Approval of Alternative Compliance
Document Number: 2019-04445
Type: Notice
Date: 2019-03-12
Agency: Federal Railroad Administration, Department of Transportation
Notice of Application for Approval of Discontinuance or Modification of a Railroad Signal System
Document Number: 2019-04444
Type: Notice
Date: 2019-03-12
Agency: Federal Railroad Administration, Department of Transportation
National Advisory Committee on Travel and Tourism Infrastructure; Notice of Public Meeting
Document Number: 2019-04438
Type: Notice
Date: 2019-03-12
Agency: Department of Transportation
This notice announces a meeting of the National Advisory Committee on Travel and Tourism Infrastructure (NACTTI).
Airworthiness Directives; Bombardier, Inc., Airplanes
Document Number: 2019-04411
Type: Proposed Rule
Date: 2019-03-12
Agency: Federal Aviation Administration, Department of Transportation
We propose to adopt a new airworthiness directive (AD) for certain Bombardier, Inc., Model CL-600-2D15 (Regional Jet Series 705) airplanes, Model CL-600-2D24 (Regional Jet Series 900) airplanes, and Model CL-600-2E25 (Regional Jet Series 1000) airplanes. This proposed AD was prompted by reports that certain aft fuselage fittings are susceptible to cracking because they were not manufactured correctly. This proposed AD would require replacement of those fittings with correctly manufactured parts, an eddy current inspection of certain fastener holes for cracking, and corrective actions if necessary. We are proposing this AD to address the unsafe condition on these products.
Airworthiness Directives; Rolls-Royce plc Turbofan Engines
Document Number: 2019-04394
Type: Rule
Date: 2019-03-12
Agency: Federal Aviation Administration, Department of Transportation
We are superseding airworthiness directive (AD) 2017-22-13 for certain Rolls-Royce plc (RR) RB211-Trent 900 turbofan engine models. AD 2017-22-13 required an inspection of the drains mast and the replacement or repair of the drains mast if a crack is found. This AD retains this requirement, but adds repetitive inspections and expands the population of affected RR RB211-Trent 900 turbofan engine models. This AD was prompted by RR in-service findings that indicated a need to include part number (P/N) FW29847 drains mast and additional RR RB211- Trent 900 turbofan engines to the affected population. We are issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Pratt & Whitney Turbofan Engines
Document Number: 2019-04388
Type: Rule
Date: 2019-03-12
Agency: Federal Aviation Administration, Department of Transportation
We are superseding Airworthiness Directive (AD) 2017-11-06, for all Pratt & Whitney (PW) PW2037, PW2037D, PW2037M, PW2040, PW2040D, PW2043, PW2143, PW2643, and F117-PW-100 turbofan engine models. AD 2017-11-06 required initial and repetitive on-wing eddy current inspections (ECIs) of affected engines with certain diffuser and high- pressure turbine (HPT) cases installed. AD 2017-11-06 also required a fluorescent-penetrant inspection (FPI) of the diffuser case rear flange and the HPT case front flange. This AD requires an on-wing ECI of all diffuser case M-flange replacement repairs. This AD was prompted by a rupture of the diffuser-to-HPT case flange. We are issuing this AD to address the unsafe condition on these products.
Proposed Amendment of Class E Airspace; Manistique, MI
Document Number: 2019-04375
Type: Proposed Rule
Date: 2019-03-12
Agency: Federal Aviation Administration, Department of Transportation
This action proposes to amend the Class E airspace extending upward from 700 feet above the surface and the Class E airspace extending upward from 1,200 feet above the surface at Schoolcraft County Airport, Manistique, MI. The FAA is proposing this action as the result of an airspace review caused by the decommissioning of the Schoolcraft VHF omnidirectional range (VOR) navigation aid, which provided navigation information for the instrument procedures at these airports, as part of the VOR Minimum Operational Network (MON) Program. The geographic coordinates of the Schoolcraft County Airport would also be updated to coincide with the FAA's aeronautical database. Airspace redesign is necessary for the safety and management of instrument flight rules (IFR) operations at this airport.
Airworthiness Directives; Airbus SAS Airplanes
Document Number: 2019-03405
Type: Rule
Date: 2019-03-12
Agency: Federal Aviation Administration, Department of Transportation
We are adopting a new airworthiness directive (AD) for certain Airbus SAS Model A318 and A319 series airplanes, Model A320-211, -212, -214, -216, -231, -232, and -233 airplanes, and Model A321-111, -112, - 131, -211, -212, -213, -231, and -232 airplanes. This AD was prompted by a report that taperloks used in a certain wing-to-fuselage junction were found to be non-compliant with the applicable specification, resulting in a loss of pre-tension in the fasteners. This AD requires repetitive special detailed inspections of the center and outer wing box lower stiffeners and panels at a certain junction on the left- and right-hand sides for any cracking, and repair if necessary, as specified in an European Aviation Safety Agency (EASA) AD, which is incorporated by reference. This AD also provides an optional modification, which would terminate the repetitive inspections. We are issuing this AD to address the unsafe condition on these products.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.