Department of Transportation October 22, 2018 – Federal Register Recent Federal Regulation Documents

This document announces the availability of the Airline Transport Pilot (ATP) and Type Rating for Airplane Airman Certification Standards (FAA-S-ACS-11) for public comment.

The Federal Aviation Administration is requesting public comment on a request by the City of Murfreesboro, to release approximately 1.28 acres of land at the Murfreesboro Municipal Airport from federal obligations. The request consists of 1.28 acres of parcel ``1'' as shown on the Approved Exhibit A property map. The parcel is situated westward from the terminal area, lying along the south side of the main access road to the airport from Memorial Boulevard (US Highway 231). Parcel ``1'' was acquired by the City of Murfreeboro by Deed dated May 26, 1947, which included 237.25 acres of the original airport. This request will release 1.28 acres of this property from federal obligations.

This action for NOA-18-01 corrects the designation for one of the consensus standards. NOA-18-01 announced the availability and requests comments on two new and two revised consensus standards relating to the provisions of the Sport Pilot and Light-Sport Aircraft rule.

This document corrects information in the proposed rule published in the August 24, 2018 issue of the Federal Register entitled The Safer Affordable Fuel-Efficient (SAFE) Vehicles Rule for Model Years 2021-2026 Passenger Cars and Light Trucks. Specifically, a table in the Paperwork Reduction Act section is corrected; two minor changes are made to one amendatory instruction in NHTSA's regulatory text, and the coefficients specifying the proposed carbon dioxide standards in EPA's regulatory text have been corrected to reflect EPA's proposal to exclude credits for direct A/C emissions for purposes of compliance with carbon dioxide standards after model year 2020, as explained in Section III of the proposed rule. This document contains only clerical corrections and makes no updates to either the proposal or to the analysis underlying the proposal. For the reader's information, an updated Preliminary Regulatory Impact Assessment (PRIA) will also be made available concurrent with this notice; that document will include descriptions starting on the second page detailing the corrections to various tables and figures therein.

These amended special conditions are issued for the Boeing Model 777 series airplanes. These special conditions are for oblique (side-facing) seats, installed in Boeing Model 777 series airplanes, at an angle of 18 to 45 degrees to the airplane centerline and which may include a 3-point or airbag restraint system, or both, for occupant restraint and injury protection. This amendment adds a note and one special condition to the Special Conditions section. This airplane will have novel or unusual design features when compared to the state of technology envisioned in the airworthiness standards for transport category airplanes. These design features are oblique (side-facing) single-occupant passenger seats equipped with or without airbag devices or 3-point restraints. The applicable airworthiness regulations do not contain adequate or appropriate safety standards for this design feature. These special conditions contain the additional safety standards that the Administrator considers necessary to establish a level of safety equivalent to that established by the existing airworthiness standards.

These special conditions are issued for the Bombardier, Inc., (Bombardier) BD-700-2A12 and BD-700-2A13 airplanes, marketed respectively as Global 7000 and Global 8000. These airplanes, as modified by Bombardier, will have novel or unusual design features when compared to the state of technology envisioned in the airworthiness standards for transport-category airplanes. These design features are multiple-place side-facing seats with active leg-flail restraint devices and shoulder-belt airbags. The applicable airworthiness regulations do not contain adequate or appropriate safety standards for this design feature. These special conditions contain the additional safety standards that the Administrator considers necessary to establish a level of safety equivalent to that established by the existing airworthiness standards.

The FAA published a document in the Federal Register on October 5, 2018, requesting comments on a petition for exemption seeking relief from specified requirements of Federal Aviation Regulations. The document contained one incorrect reference to the petitioner.

We are publishing a new airworthiness directive (AD) for Bell Helicopter Textron Canada Limited (Bell) Model 429 helicopters. This AD was sent previously to all known U.S. owners and operators of these helicopters as Emergency AD 2018-16-51, dated July 26, 2018, which superseded Emergency AD 2018-15-51, dated July 20, 2018. This AD requires inspecting the tail rotor (T/R) gearbox installation, inspecting the T/R gearbox retaining hardware and support attachment point areas, and replacing each nut. This AD is prompted by two reports of T/R gearbox assemblies loosely attached to the gearbox support. The actions of this AD are intended to address an unsafe condition on these products.

This rule amends, suspends, or removes Standard Instrument Approach Procedures (SIAPs) and associated Takeoff Minimums and Obstacle Departure Procedures for operations at certain airports. These regulatory actions are needed because of the adoption of new or revised criteria, or because of changes occurring in the National Airspace System, such as the commissioning of new navigational facilities, adding new obstacles, or changing air traffic requirements. These changes are designed to provide for the safe and efficient use of the navigable airspace and to promote safe flight operations under instrument flight rules at the affected airports.