Department of Transportation 2016 – Federal Register Recent Federal Regulation Documents

This action proposes to establish Class E airspace extending upward from 700 feet above the surface at Manti-Ephraim Airport, Manti, UT, to accommodate new Instrument Flight Rules (IFR) operations for standard instrument approach and departure procedures. The establishment of Class E airspace is necessary to support the safety and management of IFR operations at the airport.

We are adopting a new airworthiness directive (AD) for various restricted category helicopters. This AD requires cleaning and visually inspecting certain main rotor (M/R) blades and, depending on the outcome of the inspections, repairing or replacing the M/R blades. This AD was prompted by a report of an M/R blade with multiple fatigue cracks around the blade retention bolt hole. The actions are intended to detect a crack in the M/R blade, and prevent failure of the M/R blade and subsequent loss of helicopter control.

This rule establishes, amends, suspends, or removes Standard Instrument Approach Procedures (SIAPs) and associated Takeoff Minimums and Obstacle Departure Procedures (ODPs) for operations at certain airports. These regulatory actions are needed because of the adoption of new or revised criteria, or because of changes occurring in the National Airspace System, such as the commissioning of new navigational facilities, adding new obstacles, or changing air traffic requirements. These changes are designed to provide safe and efficient use of the navigable airspace and to promote safe flight operations under instrument flight rules at the affected airports.

We are adopting a new airworthiness directive (AD) for certain Bombardier, Inc. Model CL-600-2C10 (Regional Jet Series 700, 701, and 702), CL-600-2D15 (Regional Jet Series 705), CL-600-2D24 (Regional Jet Series 900), and CL-600-2E25 (Regional Jet Series 1000) airplanes. This AD was prompted by a determination that wear and possible leakage of the high-pressure seal in the cylinder of the No. 3 hydraulic system reservoir could occur and cause high hydraulic fluid temperature and/or prevent the system from reaching normal operating pressure. This AD requires repetitive operational checks for wear and leakage of the high-pressure seal in the cylinder of the reservoir of the No. 3 hydraulic system, and corrective actions if necessary. We are issuing this AD to address the unsafe condition on these products.

We propose to supersede Airworthiness Directive (AD) 2008-12- 04, which applies to certain Boeing Model 737-600, -700, -700C, -800, and -900 series airplanes. AD 2008-12-04 currently requires various repetitive inspections to detect cracks along the chem-milled steps of the fuselage skin, and to detect missing or loose fasteners in the area of the preventive modification or repairs, replacement of the time- limited repair with the permanent repair if applicable, and applicable corrective actions, if necessary, which would end certain repetitive inspections. Since we issued AD 2008-12-04, an evaluation by the design approval holder (DAH) has indicated that the upper skin panel at the chem-milled step above the lap joint is subject to widespread fatigue damage (WFD) if the modification was installed after 30,000 total flight cycles. This proposed AD would reduce the post-modification inspection compliance times, limit installation of the preventive modification to airplanes with fewer than 30,000 total flight cycles, and add repetitive inspections for modified airplanes. We are proposing this AD to detect and correct cracking of the upper skin panel at the chem-milled step above the lap joint, which could result in reduced structural integrity of the airplane.

We are adopting a new airworthiness directive (AD) for certain Gulfstream Aerospace Corporation Model GV and GV-SP airplanes. This AD was prompted by a new revision to the Airworthiness Limitations Section (ALS) of the Aircraft Maintenance Manual (AMM) based on fatigue and damage tolerance testing, and updated analysis. This AD requires revising the maintenance or inspection program to incorporate updated inspection requirements and life limits that address fatigue cracking of principal structural elements (PSEs). We are issuing this AD to ensure that fatigue cracking of PSEs is detected and corrected; such fatigue cracking could result in reduced structural integrity of the PSEs and critical components.

This notice contains a summary of a petition seeking relief from specified requirements of Title 14, Code of Federal Regulations (14 CFR). The purpose of this notice is to improve the public's awareness of, and participation in, this aspect of the FAA's regulatory activities. Neither publication of this notice nor the inclusion or omission of information in the summary is intended to affect the legal status of the petition or its final disposition.

The Surface Transportation Board (Board) hereby gives notice of one vacancy on its Rail Energy Transportation Advisory Committee (RETAC) for a representative of private railcar owners, lessors, or manufacturers. The Board is soliciting suggestions from the public for a candidate to fill this vacancy.

This notice provides information regarding FHWA's finding that a Buy America waiver is appropriate for the use of non-domestic iron and steel components in brake assembly with 5'' mill duty shoe, machinery rod ends with 2'' bore, static load capacity 378955 lb. for rehabilitation of Cow Bayou Swing Bridge in the State of Texas.

This notice announces the first meeting of the National Advisory Committee on Travel and Tourism Infrastructure (NACTTI). At the meeting, members will be sworn-in and begin a discussion of the work they will undertake during their appointment term. The agenda and any additional information for the meeting will be posted, at least one week in advance of the meeting, on the Department of Transportation Web site at https://www.transportation.gov/NACTTI.

We propose to adopt a new airworthiness directive (AD) for Airbus Helicopters Deutschland GmbH (Airbus Helicopters) MBB-BK 117 D-2 helicopters. This proposed AD would require repetitively inspecting the bushings of the inner and outer forward trusses of both engines. This proposed AD is prompted by reports of delaminated and worn engine mount bushings. The proposed actions are intended to detect delaminated engine mount bushings, which can lead to excessive vibration, cracking, failure of the engine mount front support pins, and loss of helicopter control.

The FAA is issuing this notice to advise the public of a meeting of Ninety Seventh Plenary for RTCA SC-159 Navigation Equipment Using the Global Positioning System.

The FAA is issuing this notice to advise the public of a meeting of Thirteenth RTCA SC-231 TAWS Plenary.

The Maritime Administration (MARAD), in cooperation with Det Norske Veritas-Germanischer Lloyd, American Bureau of Shipping, and The American Society for Testing and Materials, will hold a workshop to share information and gather input related to the application of high- power batteries in maritime transportation. The workshop is being held as part of the Agency's Maritime Environmental and Technical Assistance (META) Program. Information received during the workshop will be used to enhance Agency and maritime industry stakeholders' understanding of the state of technology, potential design requirements for electric powered and hybrid electric vessels, and areas for future research, development and demonstration projects.

The FAA is issuing this notice to advise the public of a meeting of Forty Sixth RTCA SC-206 Aeronautical Information and Meteorological Data Link Services Plenary.

The FAA is issuing this notice to advise the public of the Sixteenth Meeting of the RTCA Tactical Operations Committee.

We propose to adopt a new airworthiness directive (AD) for certain Learjet Inc. Model 36A airplanes. This proposed AD was prompted by a report indicating that an aileron cable failed on an airplane during a tension check and a determination that Model 36A airplanes were not included in AD 2005-13-36, which addresses this issue for other Learjet Inc. airplanes. This proposed AD would require a one-time inspection of the center ball of the aileron control cables for a defective swage, and corrective actions if necessary. We are proposing this AD to prevent the unsafe condition on these products.

We are adopting a new airworthiness directive (AD) for various aircraft equipped with a BRP-Powertrain GmbH & Co KG (formerly Rotax Aircraft Engines) 912 A series engine. This AD results from mandatory continuing airworthiness information (MCAI) issued by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as a manufacturing defect found in certain carburetor floats where an in-flight engine shutdown and forced landing could occur when the affected cylinder had reduced or blocked fuel supply. We are issuing this AD to require actions to address the unsafe condition on these products.

This notice contains a summary of a petition seeking relief from specified requirements of Title 14, Code of Federal Regulations (14 CFR). The purpose of this notice is to improve the public's awareness of, and participation in, this aspect of the FAA's regulatory activities. Neither publication of this notice nor the inclusion or omission of information in the summary is intended to affect the legal status of the petition or its final disposition.

This notice contains a summary of a petition seeking relief from specified requirements of Title 14 of the Code of Federal Regulations. The purpose of this notice is to improve the public's awareness of, and participation in, the FAA's exemption process. Neither publication of this notice nor the inclusion or omission of information in the summary is intended to affect the legal status of the petition or its final disposition.

FMCSA announces its denial of 84 applications from individuals who requested an exemption from the Federal vision standard applicable to interstate truck and bus drivers and the reasons for the denials. FMCSA has statutory authority to exempt individuals from the vision requirement if the exemptions granted will not compromise safety. The Agency has concluded that granting these exemptions does not provide a level of safety that will be equivalent to, or greater than, the level of safety maintained without the exemptions for these commercial motor vehicle (CMV) drivers.

FMCSA announces its decision to renew exemptions of 36 individuals from its prohibition in the Federal Motor Carrier Safety Regulations (FMCSRs) against persons with insulin-treated diabetes mellitus (ITDM) from operating commercial motor vehicles (CMVs) in interstate commerce. The exemptions enable these individuals with ITDM to continue to operate CMVs in interstate commerce.

In compliance with the Paperwork Reduction Act of 1995 (44 U.S.C. 3501 et seq.), this notice announces that the Information Collection Requirements (ICRs) abstracted below have been forwarded to the Office of Management and Budget (OMB) for review and comment. The ICR describe the nature of the information collection and their expected burdens. The Federal Register notice with a 60-day comment period soliciting comments on the following collections of information was published on August 16, 2016 (81 FR 54658).

We propose to adopt a new Airworthiness Directive (AD) for all Fokker Services B.V. Model F28 Mark 0100 series airplanes. This proposed AD was prompted by an evaluation by the design approval holder (DAH) indicating that certain wing fuel tank access panels are subject to widespread fatigue damage (WFD). This proposed AD would require replacement of affected access panels and modification of the coamings of the associated access holes. We are proposing this AD to prevent the unsafe condition on these products.