Department of Transportation January 30, 2015 – Federal Register Recent Federal Regulation Documents

The FAA is issuing this notice to advise the public of the fourth meeting of the 406 MHz Emergency Locator Transmitters (ELTs) Joint with EUROCAE WG-98 Committee.

The FAA is issuing this notice to advise the public of the fourth meeting of the RTCA Special Committee 231, TAWS.

The FAA is considering a proposal to change approximately 40 acres of airport land from aeronautical use to non-aeronautical use at Ted Stevens Anchorage International Airport, Anchorage, Alaska. It is determined through study and master planning that the property will not be needed for aeronautical purposes for the foreseeable future as this portion of the parcel is not contiguous with the airport proper and is significantly geographically separated from the operational areas of the airport. A change to non-aeronautical use does not exclude aeronautical activities in this area in the future.

The FAA is issuing this notice to advise the public of the fourteenth meeting of the RTCA NextGen Advisory Committee.

In compliance with the Paperwork Reduction Act of 1995 (44 U.S.C. 3501 et seq.), this notice announces that the Information Collection Request (ICR) abstracted below is being forwarded to the Office of Management and Budget (OMB) for review and comments. A Federal Register Notice with a 60-day comment period soliciting comments on the following information collection was published on November 25, 2014, 79 FR 70275-70276.

As required by the Moving Ahead for Progress in the 21st Century Act (MAP-21), the Pipeline and Hazardous Materials Safety Administration is proposing to amend the Hazardous Materials Regulations to adopt provisions contained in certain widely-used or long-standing special permits that have an established safety record. The proposed revisions are intended to provide wider access to the regulatory flexibility offered in special permits and eliminate the need for numerous renewal requests, thus reducing paperwork burdens and facilitating commerce while maintaining an appropriate level of safety. PHMSA conducted an extensive analysis of all active special permits and, in this rulemaking, those special permits deemed suitable are being proposed for adoption. PHMSA is inviting all interested persons to provide comments on both those special permits deemed suitable and proposed to be adopted into the HMR and those that are deemed not suitable for adoption. In addition, PHMSA is also requesting comments on a proposed requirement for special permit applicants to include regulatory text in their applications, when appropriate.

We are adopting a new airworthiness directive (AD) for certain Airbus Model A330-300, A340-200, and A340-300 series airplanes. This AD was prompted by a report of substantial inner skin disbonding damage found on a rudder. This AD requires performing an inspection for damage of certain rudders, and repair if necessary. We are issuing this AD to detect and correct damage of the rudder, which could result in reduced structural integrity of the rudder.

We are adopting a new airworthiness directive (AD) for certain Bombardier, Inc. Model DHC-8-400 series airplanes. This AD was prompted by reports of two in-service incidents where one side of the main landing gear (MLG) did not achieve down-lock. This AD requires doing a detailed inspection of the apex joints of the stabilizer brace lock link in the MLG for clearance; rectifying and repairing the clearance gap, if necessary; and lubricating the apex joints of the stabilizer brace lock link in the MLG. We are issuing this AD to detect and correct insufficiently greased stabilizer brace lock linkage of the MLG and over-torqued lock linkage attachment bolts, which could lead to the failure to extend and down-lock the MLG, and could affect the safe landing of the airplane.

We are adopting a new airworthiness directive (AD) for all Airbus Model A330-201, -202, -203, -301, -302, and -303 airplanes. This AD requires a one-time ultrasonic inspection for fractures of all aft mount-pylon bolts of each engine. This AD was prompted by a report of one bolt on the aft engine mount upper beam found totally broken. We are issuing this AD to detect and correct fracture of the aft mount- pylon bolts, which could result in failure of the engine mount and consequent detachment of the engine.

This rule establishes, amends, suspends, or removes Standard Instrument Approach Procedures (SIAPs) and associated Takeoff Minimums and Obstacle Departure Procedures (ODPs) for operations at certain airports. These regulatory actions are needed because of the adoption of new or revised criteria, or because of changes occurring in the National Airspace System, such as the commissioning of new navigational facilities, adding new obstacles, or changing air traffic requirements. These changes are designed to provide safe and efficient use of the navigable airspace and to promote safe flight operations under instrument flight rules at the affected airports.