Department of Transportation July 30, 2014 – Federal Register Recent Federal Regulation Documents
Results 1 - 6 of 6
Airworthiness Directives; Airbus Airplanes
We propose to supersede Airworthiness Directive (AD) 2012-09- 07, for certain Airbus Model A319-111, -112, and -132 airplanes; Model A320-111, -211, -212, -214 and -232 airplanes; and Model A321-111, - 211, -212, and -231 airplanes. AD 2012-09-07 currently requires performing an electrical bonding test between the gravity fill re-fuel adaptor and the top skin panels on the left-hand and right-hand wings, and if necessary performing a general visual inspection for corrosion of the component interface and adjacent area, and repairing the gravity fuel adaptor if any corrosion is found. Since we issued AD 2012-09-07, we have determined that more airplanes are subject to the identified unsafe condition due to the installation of an incorrect repair intended to address the identified unsafe condition. This proposed AD would add airplanes to the applicability in AD 2012-09-07, and would require inspecting those airplanes to determine if a repair was done, and doing the electrical bonding test and corrective action if necessary. We are proposing this AD to detect and correct corrosion and improper bonding, which, in combination with a lightning strike in this area, could create a source of ignition in a fuel tank, resulting in a fire or explosion, and consequent loss of the airplane.
Airworthiness Directives; Airbus Helicopters (Previously Eurocopter France) Helicopters
We propose to supersede airworthiness directive (AD) 2010-21- 07 for Eurocopter France (now Airbus Helicopters) Model AS350B3 and EC130B4 helicopters. AD 2010-21-07 currently requires inspecting the pilot's and co-pilot's throttle twist for proper operation of the contactors. This proposed AD would retain the requirements of AD 2010- 21-07, include additional inspection procedures, and revise the inspection interval. These proposed actions are intended to prevent unintended touchdown during a practice autorotation at a flight-idle power setting, damage to the helicopter, and injury to occupants.
Bus and Bus Facilities Formula Program: Proposed Circular
The Federal Transit Administration (FTA) has placed in the docket and on its Web site, proposed guidance, in the form of a circular, to assist recipients in their implementation of the Section 5339 Bus and Bus Facilities Formula Program (Bus Program). The purpose of this proposed circular is to provide recipients of FTA financial assistance with instructions and guidance on program administration and the grant application process. This proposed circular is a result of the new Bus Program enacted through the Moving Ahead for Progress in the 21st Century Act (MAP-21). By this notice, FTA invites public comment on the proposed circular.
Airworthiness Directives; Bell Helicopter Textron Canada
We propose to adopt a new airworthiness directive (AD) for Bell Helicopter Textron Canada (BHTC) Model 430 helicopters to require inspecting the tail rotor control tube assembly (control tube) and either repairing or replacing the control tube. This proposed AD is prompted by two reports of failure of the control tube bonded clevis. The proposed actions are intended to prevent failure of a control tube bonded clevis, which could lead to failure of the control tube and subsequent loss of helicopter control.
Notice of Rail Energy Transportation Advisory Committee Vacancy
The Surface Transportation Board (Board) hereby gives notice of one vacancy on its Rail Energy Transportation Advisory Committee (RETAC) for a representative of a coal producer. The Board is soliciting suggestions from the public for a candidate to fill this vacancy.
Pipeline Safety: Request for Revision of a Previously Approved Information Collection-National Pipeline Mapping System Program (OMB Control No. 2137-0596).
In accordance with the Paperwork Reduction Act of 1995, PHMSA invites public comments on our intent to request the Office of Management and Budget's approval to revise and renew an information collection currently under OMB Control Number 2137-0596 titled: ``National Pipeline Mapping System Program.'' The collection currently requires operators to submit geospatial data, attributes, metadata, public contact information and a transmittal letter to the National Pipeline Mapping System (NPMS) program. The proposed revisions will require operators to submit additional information to the NPMS.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.