Department of Transportation September 4, 2013 – Federal Register Recent Federal Regulation Documents

This action proposes to establish Class E Airspace at Star, NC, to accommodate a new Area Navigation (RNAV) Global Positioning System (GPS) Standard Instrument Approach Procedure (SIAP) serving Montgomery County Airport. This action would enhance the safety and airspace management of Instrument Flight Rules (IFR) operations within the National Airspace System.

The Federal Motor Carrier Safety Administration (FMCSA) announces an operational test of procedural changes to the New Entrant Safety Assurance Program. The operational test began in July 2013 and will be in effect for up to 12 months. It is applicable to new entrant motor carriers domiciled in the States of California, Florida, Illinois, Montana, New York and the Canadian Provinces contiguous to Montana and New York. The operational test procedures allow FMCSA to complete an off-site safety audit of eligible new entrant motor carriers that can demonstrate basic safety management controls by submitting compliance documentation as requested by FMCSA. The purpose of the operational test is to compare off-site and on-site new entrant safety audits in terms of resource allocation and subsequent safety performance of new entrant motor carriers.

We are superseding airworthiness directive (AD) 90-23-14 for certain The Boeing Company Model 747 series airplanes. AD 90-23-14 required inspections of the fuselage skin lap splice between body station (BS) 340 and BS 400 at stringers (S)-6L and S-6R, and repair if necessary. This new AD adds new repetitive inspections for cracking in the S-6 skin lap splice, which terminates the inspections required by AD 90-23-14; eventual modification of the lap splice, which terminates the repetitive inspections; post-modification inspections; and corrective actions if necessary. This AD also adds airplanes to the applicability. This AD was prompted by a report of cracks up to 18.5 inches that were found at S-6L and S-6R on several airplanes, and subsequent analysis results that indicated that the protruding head fastener modification and related post-modification inspections required by AD 90-23-14 are not adequate to prevent cracking at the upper row of fasteners in the S-6 lap joint before the cracks reach a critical length. We are issuing this AD to detect and correct cracking at the upper row of fasteners in the S-6 lap joint, which could result in a sudden loss of cabin pressurization and the inability of the fuselage to withstand failsafe loads.

We are adopting a new airworthiness directive (AD) for various aircraft equipped with Rotax Aircraft Engines 912 A Series Engine. This AD results from mandatory continuing airworthiness information (MCAI) issued by the aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as oil leaks in the intake channel in the area of the valve guide on some cylinder heads could increase the oil consumption and result in engine stoppage. We are issuing this AD to require actions to address the unsafe condition on these products.

We are adopting a new airworthiness directive (AD) for certain Eurocopter France (Eurocopter) Model AS350 and AS355 helicopters. This AD requires inspecting the tail rotor control stop screws to determine if they are correctly aligned and adjusting the screws if they are misaligned. This AD is prompted by the discovery of a loose nut on the tail rotor control stop and a misaligned tail rotor control stop screw. The actions of this AD are intended to detect a loose nut or a misaligned stop screw, which, if not corrected, could limit yaw authority, and consequently, result in a loss of helicopter control.