Department of Transportation November 28, 2012 – Federal Register Recent Federal Regulation Documents

Twelfth Meeting: RTCA Special Committee 223, Airport Surface Wireless Communications
Document Number: 2012-28854
Type: Notice
Date: 2012-11-28
Agency: Federal Aviation Administration, Department of Transportation
The FAA is issuing this notice to advise the public of the meeting of the RTCA Special Committee 223, Airport Surface Wireless Communications.
Parts and Accessories Necessary for Safe Operation; Grant of Exemption for Transecurity LLC (Transecurity)
Document Number: 2012-28823
Type: Notice
Date: 2012-11-28
Agency: Federal Motor Carrier Safety Administration, Department of Transportation
The Federal Motor Carrier Safety Administration (FMCSA) announces its decision to grant an exemption to Transecurity LLC (Transecurity) that will allow the placement of an onboard safety monitoring system (OBMS) at the bottom of windshields on commercial motor vehicles (CMVs). The Federal Motor Carrier Safety Regulations (FMCSRs) currently require antennas, transponders, and similar devices to be located not more than 6 inches below the upper edge of the windshield, outside the area swept by the windshield wipers, and outside the driver's sight lines to the road and highway signs and signals. Transecurity is coordinating the development and installation of camera-based monitoring systems in up to 500 CMVs operating throughout the United States in support of research being conducted on behalf of FMCSA. The exemption would enable motor carriers to participate in a field operation test to evaluate the system and allow for on-road data collection. FMCSA believes that permitting the OBMS to be mounted lower than currently allowed, but still outside the driver's sight lines to the road and highway signs and signals, will maintain a level of safety that is equivalent to, or greater than, the level of safety achieved without the exemption.
Petition To Modify an Exemption of a Previously Approved Antitheft Device; Mitsubishi Motors R&D of America
Document Number: 2012-28813
Type: Notice
Date: 2012-11-28
Agency: National Highway Traffic Safety Administration, Department of Transportation
On February 2, 2009, the National Highway Traffic Safety Administration (NHTSA) granted in full Mitsubishi Motors R&D (Mitsubishi) of America's petition for an exemption in accordance with Sec. 543.9(c)(2) of 49 CFR part 543, Exemption From the Theft Prevention Standard for the Mitsubishi Outlander vehicle line beginning with its model year (MY) 2011 vehicles. On August 6, 2012, Mitsubishi submitted a petition to modify its previously approved exemption for the Outlander vehicle line beginning with its model year (MY) 2014 vehicles. Mitsubishi also requested confidential treatment of specific information in its petition. The agency will address Mitsubishi's request for confidential treatment by separate letter. NHTSA is granting Mitsubishi's petition to modify the exemption in full because it has determined that the modified device is also likely to be as effective in reducing and deterring motor vehicle theft as compliance with the parts-marking requirements of the Theft Prevention Standard.
Federal Motor Vehicle Safety Standards; Side Impact Protection
Document Number: 2012-28810
Type: Rule
Date: 2012-11-28
Agency: National Highway Traffic Safety Administration, Department of Transportation
On August 24, 2011 we published a final rule responding to a petition for reconsideration of a final rule on the Federal motor vehicle safety standard for side impact protection. In today's document, we correct a minor error in that rule. The agency is also correcting several typographical errors in the standard.
Special Conditions: Embraer S.A., Model EMB-550 Airplane; Interaction of Systems and Structures
Document Number: 2012-28768
Type: Proposed Rule
Date: 2012-11-28
Agency: Federal Aviation Administration, Department of Transportation
This action proposes special conditions for the Embraer S.A. Model EMB-550 airplane. This airplane will have a novel or unusual design feature(s) associated with the interaction of systems and structures. The applicable airworthiness regulations do not contain adequate or appropriate safety standards for this design feature. These proposed special conditions contain the additional safety standards that the Administrator considers necessary to establish a level of safety equivalent to that established by the existing airworthiness standards.
Notice of Application for Special Permits
Document Number: 2012-28590
Type: Notice
Date: 2012-11-28
Agency: Pipeline and Hazardous Materials Safety Administration, Department of Transportation
In accordance with the procedures governing the application for, and the processing of, special permits from the Department of Transportation's Hazardous Material Regulations (49 CFR part 107, Subpart B), notice is hereby given that the Office of Hazardous Materials Safety has received the application described herein. Each mode of transportation for which a particular special permit is requested is indicated by a number in the ``Nature of Application'' portion of the table below as follows: 1Motor vehicle, 2Rail freight, 3Cargo vessel, 4Cargo aircraft only, 5Passenger-carrying aircraft.
Notice of Applications for Modification of Special Permit
Document Number: 2012-28588
Type: Notice
Date: 2012-11-28
Agency: Pipeline and Hazardous Materials Safety Administration, Department of Transportation
In accordance with the procedures governing the application for, and the processing of, special permits from the Department of Transportation's Hazardous Material Regulations (49 CFR part 107, Subpart B), notice is hereby given that the Office of Hazardous Materials Safety has received the applications described herein. This notice is abbreviated to expedite docketing and public notice. Because the sections affected, modes of transportation, and the nature of application have been shown in earlier Federal Register publications, they are not repeated here. Requests for modification of special permits (e.g. to provide for additional hazardous materials, packaging design changes, additional mode of transportation, etc.) are described in footnotes to the application number. Application numbers with the suffix ``M'' denote a modification request. These applications have been separated from the new application for special permits to facilitate processing.
Notice of Delays in Processing of Special Permits Applications
Document Number: 2012-28585
Type: Notice
Date: 2012-11-28
Agency: Pipeline and Hazardous Materials Safety Administration, Department of Transportation
In accordance with the requirements of 49 U.S.C. 5117(c), PHMSA is publishing the following list of special permit applications that have been in process for 180 days or more. The reason(s) for delay and the expected completion date for action on each application is provided in association with each identified application.
Office of Hazardous Materials Safety; Actions on Special Permit Applications
Document Number: 2012-28583
Type: Notice
Date: 2012-11-28
Agency: Pipeline and Hazardous Materials Safety Administration, Department of Transportation
In accordance with the procedures governing the application for, and the processing of, special permits from the Department of Transportation's Hazardous Material Regulations (49 CFR Part 107, Subpart B), notice is hereby given of the actions on special permits applications in (October to November 2012). The mode of transportation involved are identified by a number in the ``Nature of Application'' portion of the table below as follows: 1Motor vehicle, 2Rail freight, 3Cargo vessel, 4Cargo aircraft only, 5Passenger-carrying aircraft. Application numbers prefixed by the letters EE represent applications for Emergency Special Permits. It should be noted that some of the sections cited were those in effect at the time certain special permits were issued.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.