Department of Transportation September 29, 2009 – Federal Register Recent Federal Regulation Documents

We propose to adopt a new airworthiness directive (AD) for certain Boeing Model 757 airplanes. This proposed AD would require inspecting to verify the part number of the low-pressure flex-hoses of the flightcrew and supernumerary oxygen system installed under the oxygen mask stowage box at a flightcrew and supernumerary oxygen mask location, and replacing with a new non-conductive low-pressure flex- hose of the oxygen system if necessary. This proposed AD results from reports of a low-pressure flex-hose of a flightcrew oxygen system that burned through due to inadvertent electrical current from a short circuit in an adjacent audio select panel. We are proposing this AD to prevent inadvertent electrical current which can cause the low-pressure flex-hose of a flightcrew or supernumerary oxygen system to melt or burn, resulting in oxygen system leakage and smoke or fire.

We are superseding an existing airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

We are adopting a new airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) issued by the aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

This amendment adopts a new airworthiness directive (AD), applicable to certain Boeing Model 767-200 and -300 series airplanes, that requires replacing certain door-mounted escape slides and slide- raft assemblies with new slide-raft assemblies. This AD also requires the following actions, as applicable: replacing certain escape system latches with new latches; modifying or replacing certain counterbalance assemblies with new counterbalance assemblies; and adjusting the door counterbalance system. The actions specified by this AD are intended to prevent the escape slides and slide-rafts of the forward and mid-cabin entry and service doors from being too steep for evacuation in the event that the airplane rotates onto the aft fuselage into the extreme tip-back condition. In the extreme tip-back condition, the forward and mid-cabin exits could result in steeper sliding angles, which could cause injury to passengers and crewmembers during an emergency