Department of Transportation July 8, 2009 – Federal Register Recent Federal Regulation Documents

We propose to adopt a new airworthiness directive (AD) for the products listed above that would supersede an existing AD. This proposed AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

We are superseding an existing airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) issued by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

The FAA is superseding an existing airworthiness directive (AD), which applies to all Boeing Model 777 airplanes. That AD currently requires, for the drive mechanism of the horizontal stabilizer, repetitive detailed inspections for discrepancies, repetitive lubrication of the ballnut and ballscrew, repetitive measurements of the freeplay between the ballnut and the ballscrew, and corrective action if necessary. This new AD revises the compliance times of the existing AD. This AD results from a report of extensive corrosion of a ballscrew in the drive mechanism of the horizontal stabilizer on a Boeing Model 757 airplane, which is similar in design to the ballscrew on Model 777 airplanes. We are issuing this AD to prevent an undetected failure of the primary load path for the ballscrew in the drive mechanism of the horizontal stabilizer and subsequent wear and failure of the secondary load path, which could lead to loss of control of the horizontal stabilizer and consequent loss of control of the airplane.

We are adopting a new airworthiness directive (AD) for certain Boeing Model 737-100, -200, -200C, -300, -400, and -500 series airplanes. For certain airplanes, this AD requires deactivating or modifying the wiring to the outboard landing lights, until the wire bundles and electrical connectors have been replaced. For all airplanes, this AD also requires inspecting for any broken, damaged, or missing fairleads, grommets, and wires in the four electrical junction boxes of the main wheel well, and corrective actions if necessary. For certain airplanes, this AD also requires replacing certain wire bundles for the landing lights and fuel shutoff valves, and related investigative, other specified, and corrective actions if necessary. For certain airplanes, this AD also requires replacing of certain electrical connectors and backshell clamps. This AD results from reports of uncommanded engine shutdowns and burned and damaged wire bundles associated with the outboard landing lights and engine fuel shutoff valves. This AD also results from reports of damaged and missing grommets and broken and damaged fairleads in the electrical junction boxes of the main wheel well. We are issuing this AD to prevent a hot short between the outboard landing light and fuel shutoff valve circuits, which could result in an uncommanded engine shutdown. We are also issuing this AD to prevent corrosion of the electrical connectors of the wing rear spars, which could result in short circuits and consequent incorrect functioning of airplane systems needed for safe flight and landing.

We are adopting a new airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as: