Department of Transportation September 25, 2008 – Federal Register Recent Federal Regulation Documents
Results 1 - 11 of 11
Agency Information Collection; Request for Comments; Clearance and Renewal of a Previously Approved Collection; Disclosure of Codesharing Arrangements and Long-Term Wet Leases
In compliance with the Paperwork Reduction Act of 1995, Public Law 104-13 (44 U.S.C. 3501 et seq.) this notice announces that the Information Collection Request, abstracted below, is being forwarded to the Office of Management and Budget for renewal and comment. The ICR describes the nature of the information collection and its expected cost burden. The Federal Register Notice with a 60-day comment period soliciting comments on the following collection of information was published on July 11, 2008 [FR Vol. 73, pages 4000840010]. No comments were received.
Reports, Forms, and Recordkeeping Requirements
Before a Federal agency can collect certain information from the public, it must receive approval from the Office of Management and Budget (OMB). Under procedures established by the Paperwork Reduction Act of 1995, before seeking OMB approval, Federal agencies must solicit public comment on proposed collections of information, including extensions and reinstatement of previously approved collections. This document describes one collection of information for which NHTSA intends to seek OMB approval.
Pipeline Safety: Workshop on Anomaly Assessment and Repair
Recent observations by PHMSA indicate possible inconsistencies in how natural gas transmission pipeline operators assess and repair anomalies, such as corrosion defects, and apply the results of calculations to their decision making for further action. Special permits granted by PHMSA over the past two years prescribe specific assessment and repair procedures for pipelines operating under a class location change and maximum allowable operating pressure special permit. Moreover, recent research indicating that existing methods of predicting the remaining strength of corroded pipe could provide non- conservative results (i.e., the pipe will fail at a pressure lower than that predicted) in some circumstances. Non-conservative results could be obtained even when the dimensions of pipeline anomalies are known with precision. PHMSA is sponsoring a Workshop on Assessment and Repair of Anomalies in Pipelines to allow stakeholders of the pipeline safety community to learn about and discuss these research results, current evaluation practices, and methods to assure pipeline safety. The discussion of current evaluation practices and methods to assure pipeline safety should include: A review of safety factors used to evaluate anomalies when assessing in-line tool and excavation results, review of how outside forces and overpressure may effect anomaly stresses, how ILI tool accuracy is applied to anomaly evaluation, and how anomaly growth rates in assessments are considered.
Airworthiness Standards; Aircraft Engine Standards for Pressurized Engine Static Parts
The FAA is amending the aircraft engine type certification standards by adding standards for pressurized engine static parts that are equivalent to those already adopted by the European Aviation Safety Agency. This rule establishes uniform standards for the certification of these parts in the United States and in Europe. U.S. manufacturers already meet the European requirements.
Proposed Agency Information Collection Activities; Comment Request
In accordance with the Paperwork Reduction Act of 1995 and its implementing regulations, the Federal Railroad Administration (FRA) hereby announces that it is seeking renewal of the following currently approved information collection activities. Before submitting these information collection requirements for clearance by the Office of Management and Budget (OMB), FRA is soliciting public comment on specific aspects of the activities identified below.
Airworthiness Directives; Honeywell International Inc. LTS101 Series Turboshaft and LTP101 Series Turboprop Engines
The FAA proposes to adopt a new airworthiness directive (AD) for Honeywell International Inc. LTS101 series turboshaft and LTP101 series turboprop engines with certain gas generator turbine discs installed. This proposed AD would require reducing the life limits for certain gas generator turbine discs. This proposed AD results from an error in a change to the engineering drawing for the gas generator turbine disc from which they manufactured 260 discs. We are proposing this AD to prevent rupture of the gas generator turbine disc, which could result in uncontained engine failure and damage to the aircraft.
Centennial Airport, Englewood, CO; FAA Approval of Noise Compatibility Program
The FAA's Federal Register Notice entitled ``Approval of Noise Compatibility Program; Centennial Airport, Englewood, CO;'' published August 21, 2008, published with several inaccuracies. Because of those inaccuracies we withdraw the August 21, 2008 notice (73 FR 49635) and are issuing this notice to replace the August 21, 2008 notice. The Federal Aviation Administration (FAA) announces its findings on the noise compatibility program submitted by the Arapahoe County Public Airport Authority for the Centennial Airport under the provisions of Title I of the Aviation Safety and Noise Abatement Act of 1979 (Pub. L. 96-193) and 14 CFR Part 150, Airport Noise Compatibility Planning. These findings are made in recognition of the description of federal and non-federal responsibilities in Senate Report No. 96-52 (1980). On August 12, 2008, FAA Airports Division Manager approved the Centennial Airport noise compatibility program. Of the twelve proposed program elements, FAA approved eight and reserved approval of another two measures pending further study. The remaining two measures were disapproved.
Agency Information Collection Activity Seeking OMB Approval
The FAA invites public comments about our intention to request the Office of Management and Budget's (OMB) revision of a current information collection. The Federal Register Notice with a 60-day comment period soliciting comments on the following collection of information was published on June 19, 2008, vol. 73, no. 119, page 34972-34973. The requested information is included in air carriers' applications for insurance when insurance is not available from private sources.
Establishment of Class D Airspace; San Bernardino International Airport, San Bernardino, CA
This rule establishes Class D airspace at San Bernardino International Airport, San Bernardino, CA. The FAA is taking this action to provide controlled airspace for the safety of aircraft executing Standard Instrument Approach Procedures (SIAPs) and other Instrument Flight Rules (IFR) operations at San Bernardino International Airport. The configuration of this airspace has been modified to accommodate airspace design changes that would enhance the safety and efficiency of air traffic operations at San Bernardino International Airport and continue general aviation access to Redlands Municipal Airport 4.5 nautical miles to the east.
Office of Hazardous Materials Safety; Notice of Delays in Processing of Special Permits Applications
In accordance with the requirements of 49 U.S.C. 5117(c), PHMSA is publishing the following list of special permit applications that have been in process for 180 days or more. The reason(s) for delay and the expected completion date for action on each application is provided in association with each identified application.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.