Department of Transportation February 22, 2008 – Federal Register Recent Federal Regulation Documents

In compliance with the Paperwork Reduction Act of 1995, this notice announces that the Information Collection abstracted below will be submitted to the Office of Management and Budget (OMB) for review and approval. The nature of the information collection is described as well as its expected burden. The Federal Register Notice with a 60-day comment period soliciting comments on the following collection of information was published on November 29, 2007. No comments were received.

This document announces the scheduling of a teleconference by the National Safe Routes to School Task Force to the Secretary of Transportation. The purpose of the Task Force is to advise the Secretary of Transportation, through the Federal Highway Administration (FHWA) Office of Safety, on strategies to advance Safe Routes to School (SRTS) Programs nationwide and to encourage children, including those with disabilities, to walk and bicycle to school pursuant to section 1404(h) of the Safe, Accountable, Flexible, Efficient Transportation Equity Act: A Legacy for Users (SAFETEA-LU) (Pub. L. 109-59, Aug. 10, 2005). During this teleconference, the Task Force will discuss their draft report to the Secretary.

In accordance with the Paperwork Reduction Act of 1995, this notice announces the Maritime Administration's (MARAD's) intention to request extension of approval (with modifications) for three years of a currently approved information collection.

This notice announces that Federal actions taken by the California Department of Transportation (Department) pursuant to its assigned responsibilities under 23 U.S.C. 327, as well as actions by other Federal agencies, are final within the meaning of 23 U.S.C. 139 (l)(1). The actions relate to a proposed Interstate 80 Across the Top Bus/Carpool Lanes Project (Post Miles 0.3 to 10.4), from west of West El Camino Avenue to Watt Avenue in Sacramento County, State of California. This action grants approval for the project.

The FAA is adopting a new airworthiness directive (AD) for all Boeing Model 707 airplanes, and Model 720 and 720B series airplanes. This AD requires revising the FAA-approved maintenance program by incorporating new airworthiness limitations (AWLs) for fuel tank systems to satisfy Special Federal Aviation Regulation No. 88 requirements. This AD also requires the initial performance of certain repetitive AWL inspections to phase in those inspections, and repair if necessary. This AD results from a design review of the fuel tank systems. We are issuing this AD to prevent the potential for ignition sources inside fuel tanks caused by latent failures, alterations, repairs, or maintenance actions, which, in combination with flammable fuel vapors, could result in fuel tank explosions and consequent loss of the airplane.

We are adopting a new airworthiness directive (AD) to supersede AD 2007-16-14, which applies to all Taylorcraft (Taylorcraft) A, B, and F series airplanes. AD 2007-16-14 currently requires you to do an initial visual inspection of the left and right wing front and aft lift struts for cracks and corrosion and replace any cracked strut or strut with corrosion that exceeds certain limits. If the strut is replaced with an original design vented strut, AD 2007-16-14 requires you to repetitively inspect those struts thereafter. Since we issued AD 2007-16-14, we determined that the eddy current inspection method does not address the unsafe condition for the long term. We also determined that Models FA-III and TG-6 airplanes are not equipped with the affected struts. Consequently, this AD retains the actions required in AD 2007-16-14, except it removes the eddy current inspection method (provides 24-month credit if already done using this method), adds the radiograph method as an inspection method, changes the Applicability section, and changes the compliance time between the repetitive inspections. We are issuing this AD to detect and correct cracks and corrosion in the left and right wing front and aft lift struts. This condition, if not corrected, could result in failure of the lift strut and lead to in-flight separation of the wing.

We are adopting a new airworthiness directive (AD) for all Boeing Model 727 airplanes. This AD requires revising the FAA-approved maintenance program by incorporating new airworthiness limitations (AWLs) for fuel tank systems to satisfy Special Federal Aviation Regulation No. 88 requirements. This AD also requires the initial inspection of a certain repetitive AWL inspection to phase in that inspection, and repair if necessary. This AD results from a design review of the fuel tank systems. We are issuing this AD to prevent the potential for ignition sources inside fuel tanks caused by latent failures, alterations, repairs, or maintenance actions, which, in combination with flammable fuel vapors, could result in a fuel tank explosion and consequent loss of the airplane.

We are adopting a new airworthiness directive (AD) for all Boeing Model 707 airplanes and Model 720 and 720B series airplanes. This AD requires repetitive inspections for any cracking of or damage to the left side and right side flight deck No. 2, No. 4, and No. 5 windows, as necessary, and corrective actions if necessary. This AD results from reports of in-flight departure and separation of the flight deck windows. We are issuing this AD to detect and correct cracking in the vinyl interlayer or damage to the structural inner glass panes of the flight deck No. 2, No. 4, and No. 5 windows, which could result in loss of a window and rapid loss of cabin pressure. Loss of cabin pressure could cause crew communication difficulties or crew incapacitation.