Department of Transportation May 17, 2005 – Federal Register Recent Federal Regulation Documents

Pipeline Safety: Public Meeting on Use of Excess Flow Valves in Gas Distribution Service Lines
Document Number: 05-9914
Type: Notice
Date: 2005-05-17
Agency: Pipeline and Hazardous Materials Safety Administration, Department of Transportation
The Pipeline and Hazardous Materials Safety Administration's (PHMSA) Office of Pipeline Safety (OPS) is sponsoring a public meeting on the use of Excess Flow Valves in gas distribution safety lines as a technique for mitigating the consequences of service line incidents. The meeting will be held on June 17, 2005, in Washington, DC.
Tariff of Tolls
Document Number: 05-9799
Type: Rule
Date: 2005-05-17
Agency: Saint Lawrence Seaway Development Corporation, Department of Transportation
The Saint Lawrence Seaway Development Corporation (SLSDC) and the St. Lawrence Seaway Management Corporation (SLSMC) of Canada, under international agreement, jointly publish and presently administer the St. Lawrence Seaway Tariff of Tolls in their respective jurisdictions. The Tariff sets forth the level of tolls assessed on all commodities and vessels transiting the facilities operated by the SLSDC and the SLSMC. The SLSDC is revising its regulations to reflect the fees and charges levied by the SLSMC in Canada starting in the 2005 navigation season, which are effective only in Canada. An amendment to increase the charge per pleasure craft per lock transited for full or partial transit of the Seaway will apply in the United States.
Qualification of Drivers; Exemption Applications; Vision
Document Number: 05-9795
Type: Notice
Date: 2005-05-17
Agency: Federal Motor Carrier Safety Administration, Department of Transportation
This notice publishes the FMCSA's receipt of applications from 30 individuals for an exemption from the vision requirement in the Federal Motor Carrier Safety Regulations. If granted, the exemptions will enable these individuals to qualify as drivers of commercial motor vehicles (CMVs) in interstate commerce without meeting the vision standard prescribed in 49 CFR 391.41(b)(10).
Proposed Agency Information Collection Activities: Comment Request
Document Number: 05-9787
Type: Notice
Date: 2005-05-17
Agency: Surface Transportation Board, Department of Transportation
The Surface Transportation Board (Board), as part of its continuing effort to reduce paperwork burdens, and as required by the Paperwork Reduction Act of 1995, 44 U.S.C. 3501 et seq. (PRA), gives notice that the Board proposes to request reinstatement without change of a previously approved information collection that has expired. Comments are requested concerning (1) Whether the particular collection of information described below is necessary for the proper performance of the functions of the Board, including whether the collection has practical utility; (2) the accuracy of the Board's burden estimates; (3) ways to enhance the quality, utility, and clarity of the information collected; and (4) ways to minimize the burden of the collection of information on the respondents, including the use of automated collection techniques or other forms of information technology, when appropriate. Submitted comments will be summarized and included in the Board's request for Office of Management and Budget (OMB) approval. In this notice the Board is requesting comments on the following information collection: Title: Application to Open an Account for Billing Purposes. OMB Control Number: 2104-0006. Form Number: STB Form 1032. Number of Respondents: 20. Affected Public: Mail carriers, shippers, and others doing business before the agency. Estimated Time Per Response: Less than .08 hours. This estimate is based on actual past survey information. Frequency of Response: The form will only have to be completed once by each account holder. Total Annual Burden Hours: Less than 1.6 hours. Total Annual ``Non-Hour Burden'' Cost: No ``non-hour cost'' burdens associated with this collection have been identified. Needs and Uses: The Board is, by statute, responsible for the economic regulation of surface transportation carriers operating in interstate commerce. This form is for use by applicants who wish to open an account with the Board to charge fees for records search, review, copying, certification of records, filing fees, and related services rendered. The account holder would be billed on a monthly basis for payment of accumulated fees. Data provided will also be used for debt collection activities. The form requests information as required by OMB and U.S. Department of Treasury regulations for the collection of fees. This information is not duplicated by any other agency. In accordance with the Privacy Act, 5 U.S.C. 552a, all taxpayer identification and social security numbers will be secured and used only for credit management and debt collection activities.
Airworthiness Directives; Eurocopter France Model AS355E, F, F1, F2, and N Helicopters
Document Number: 05-9766
Type: Rule
Date: 2005-05-17
Agency: Federal Aviation Administration, Department of Transportation
This amendment supersedes an existing airworthiness directive (AD) for the specified Eurocopter France (ECF) model helicopters. That AD currently requires replacing certain main or combiner gearboxes with airworthy gearboxes. Further investigation has shown that the main gearbox is not affected, and this amendment requires replacing a certain combiner gearbox with a modified airworthy gearbox. This amendment is prompted by a report of a freewheel unit slipping resulting in an engine overspeed and shutdown. Also, this amendment is prompted by the conclusion of the investigation, which finds the freewheel slippage is due to the surface treatment applied to certain freewheel rollers in the combiner gearbox. The actions specified by this AD are intended to prevent an engine overspeed, an engine shutdown, and subsequent loss of control of the helicopter.
Airworthiness Directives; Bell Helicopter Textron Model 206A and 206B Helicopters
Document Number: 05-9762
Type: Proposed Rule
Date: 2005-05-17
Agency: Federal Aviation Administration, Department of Transportation
This document proposes adopting a new airworthiness directive (AD) for Bell Helicopter Textron (Bell) Model 206A and 206B helicopters modified by Aeronautical Accessories, Inc. Supplemental Type Certificate (STC) SH1392SO with certain part-numbered high crosstubes. The AD would require inspecting at specified time intervals and replacing any cracked crosstubes. This proposal is prompted by the discovery of a cracked high forward crosstube. The actions specified by the proposed AD are intended to detect a crack in the crosstube which could lead to failure of the crosstube, collapse of the landing gear, and subsequent loss of control of the helicopter.
ArvinMeritor, Inc., Receipt of Petition for Decision of Inconsequential Noncompliance
Document Number: 05-9741
Type: Notice
Date: 2005-05-17
Agency: National Highway Traffic Safety Administration, Department of Transportation
Union Pacific Railroad Company-Temporary Trackage Rights Exemption-BNSF Railway Company
Document Number: 05-9683
Type: Notice
Date: 2005-05-17
Agency: Surface Transportation Board, Department of Transportation
Union Pacific Railroad Company-Temporary Trackage Rights Exemption-BNSF Railway Company
Document Number: 05-9682
Type: Notice
Date: 2005-05-17
Agency: Surface Transportation Board, Department of Transportation
Airworthiness Directives; Bombardier Model CL-600-2B19 (Regional Jet Series 100 & 440) Airplanes
Document Number: 05-9553
Type: Rule
Date: 2005-05-17
Agency: Federal Aviation Administration, Department of Transportation
The FAA is adopting a new airworthiness directive (AD) for certain Bombardier Model CL-600-2B19 (Regional Jet Series 100 & 440) airplanes. This AD requires revising the Airworthiness Limitations section of the Instructions for Continued Airworthiness of the Canadair Regional Jet Maintenance Requirements Manual by incorporating new repetitive detailed inspections of the secondary load path indicator for the horizontal stabilizer trim actuator (HSTA). This AD is prompted by a report of a potential failure of the horizontal stabilizer trim actuator (HSTA) secondary nut in conjunction with a latent failure of the HSTA primary load path discovered during sampling program activities. We are issuing this AD to detect and correct latent failure of the primary load path of the HSTA, which, in conjunction with a failure of the HSTA secondary nut, could result in loss of horizontal trim control and consequent reduced controllability of the airplane.
Airworthiness Directives; Saab Model SAAB SF340A and SAAB 340B Series Airplanes
Document Number: 05-9468
Type: Rule
Date: 2005-05-17
Agency: Federal Aviation Administration, Department of Transportation
The FAA is superseding an existing airworthiness directive (AD), which applies to certain Saab Model SAAB SF340A and SAAB 340B series airplanes. That AD currently requires repetitive detailed inspections of the windshield wiper assembly for discrepant conditions, and corrective actions if necessary. This new AD requires repetitive detailed inspections of the left and right wiper arm assemblies for damage, and corrective/related investigative actions if necessary. This AD is prompted by an additional incident of a windshield wiper blade separating from the wiper arm. We are issuing this AD to prevent separation of a wiper arm from the airplane, which could result in damage to the fuselage skin and propeller.
Airworthiness Directives; Bombardier Model DHC-8-102, -103, -106, -201, -202, -301, -311, and -315 Airplanes
Document Number: 05-9467
Type: Rule
Date: 2005-05-17
Agency: Federal Aviation Administration, Department of Transportation
The FAA is adopting a new airworthiness directive (AD) for certain Bombardier Model DHC-8-102, -103, -106, -201, -202, -301, -311, and -315 airplanes. This AD requires operators to install torque tube catchers on the control columns of the flight controls. This AD is prompted by the discovery that a single malfunction of the torque tube could result in both flight control columns being supported by only one self-aligning bearing. We are issuing this AD to prevent the torque tube from fouling against the underfloor control cables, which could result in reduced controllability of the airplane.
Airworthiness Directives; Fokker Model F.28 Series Airplanes
Document Number: 05-9466
Type: Rule
Date: 2005-05-17
Agency: Federal Aviation Administration, Department of Transportation
The FAA is adopting a new airworthiness directive (AD) for all Fokker Model F.28 series airplanes. This AD requires a one-time inspection of the area underneath the auxiliary power unit (APU) enclosure to determine if drain tubes in the area are correctly installed and to detect damaged wiring, and corrective action if necessary. This AD is prompted by a report of a fire under the APU enclosure. We are issuing this AD to prevent fuel from accumulating under the APU enclosure, which, in the presence of an ignition source, could result in a fire.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.