May 2017 – Federal Register Recent Federal Regulation Documents

This action proposes to modify Class E airspace extending upward from 700 feet above the surface at Oskaloosa Municipal Airport, Oskaloosa, IA, to accommodate new standard instrument approach procedures for instrument flight rules (IFR) operations at the airport. This action is necessary due to the decommissioning of the Oskaloosa non directional radio beacon (NDB), and cancellation of the NDB approach procedure, and would enhance the safety and management of IFR operations at the airport.

We propose to adopt a new airworthiness directive (AD) for certain Rolls-Royce Deutschland Ltd & Co KG (RRD) model Tay 620-15 turbofan engines. This proposed AD was prompted by RRD recalculating the life limit for certain high-pressure compressor (HPC) stage 12 rotor disks. This proposed AD would require reducing the maximum approved life limit. We are proposing this AD to correct the unsafe condition on these products.

This action proposes to establish Class E airspace extending upward from 700 feet above the surface at Ashburn, GA, to accommodate new Area Navigation (RNAV) Global Positioning System (GPS) Standard Instrument Approach Procedures (SIAPs) serving Turner County Airport. Controlled airspace is necessary for the safety and management of instrument flight rules (IFR) operations at the airport.

This action proposes to establish Class E airspace at Johnson City, TN, to accommodate new Area Navigation (RNAV) Global Positioning System (GPS) standard instrument approach procedures (SIAPs) serving Johnson City Medical Center Heliport. Controlled airspace is necessary for the safety and management of instrument flight rules (IFR) operations at the heliport.

We propose to supersede Airworthiness Directive (AD) 2016-11- 20, which applies to certain B/E Aerospace protective breathing equipment (PBE) that is installed on airplanes. AD 2016-11-20 requires replacing part number (P/N) 119003-11 PBE units. Since we issued AD 2016-11-20, we received a report that PBE units, P/N 119003-21, within a certain serial number range are made with candle tube material determined to have a low yield strength and may be volatile upon use or disposal. This proposed AD would retain the actions required in AD 2016-11-20 and would require inspecting and replacing P/N 119003-11 and 119003-21 PBE units. We are proposing this AD to correct the unsafe condition on these products.

This regulation establishes tolerances for residues of isopyrazam in or on pepper, bell; tomato; and vegetable, cucurbit, subgroup 9A. Syngenta Crop Protection, LLC, requested these tolerances under the Federal Food, Drug, and Cosmetic Act (FFDCA).

This regulation establishes tolerances for residues of fenazaquin in or on hop, dried cones; nuts, tree, group 14-12; pineapple; and tea, dried. Gowan Company requested these tolerances under the Federal Food, Drug, and Cosmetic Act (FFDCA).

This technical amendment corrects an error in the final rule titled Safety Management System for Domestic, Flag and Supplemental Operations Certificate Holders, published on January 8, 2015. In that rule, the FAA amended its regulations to require air carriers conducting domestic, flag and supplemental operations to put a safety management system (SMS) in place by 2018.

The Coast Guard has issued a temporary deviation from the operating schedule that governs the Northwestern Pacific (Haystack Landing) railroad bridge across Petaluma River, mile 12.4 at Haystack Landing (Petaluma), CA. The deviation is necessary to allow the bridge owner to perform necessary bridge maintenance. This deviation allows the bridge to remain in the closed-to-navigation position during the deviation period.

NMFS proposes to modify recreational management measures for Gulf of Maine cod and haddock for the 2017 fishing year. This action proposes to prohibit recreational possession of cod, reduce the haddock bag limit, and implement a new closed season for haddock in the fall. The intended effect of this action is to reduce catch of cod and haddock. This action is necessary to ensure fishing year 2017 recreational catch limits are not exceeded.

This rule identifies communities where the sale of flood insurance has been authorized under the National Flood Insurance Program (NFIP) that are scheduled for suspension on the effective dates listed within this rule because of noncompliance with the floodplain management requirements of the program. If the Federal Emergency Management Agency (FEMA) receives documentation that the community has adopted the required floodplain management measures prior to the effective suspension date given in this rule, the suspension will not occur and a notice of this will be provided by publication in the Federal Register on a subsequent date. Also, information identifying the current participation status of a community can be obtained from FEMA's Community Status Book (CSB). The CSB is available at https:// www.fema.gov/national-flood-insurance-program-community-statu s-book.

This proposed rule would implement a recommendation from the Peanut Standards Board (Board) to revise the minimum quality and handling standards for domestic and imported peanuts marketed in the United States (Standards). The Board advises the Secretary of Agriculture regarding potential changes to the Standards and is comprised of producers and industry representatives. This action would relax the allowance for damaged kernels in farmers stock peanuts when determining segregation. This change would increase the allowance for damaged kernels under Segregation 1 from not more than 2.49 percent to not more than 3.49 percent. The requirements for Segregation 2 would also be adjusted to reflect this change. The Board recommended this change to align the incoming standards with recent changes to the outgoing quality standards and to help increase returns to producers.

The Department of Agriculture (USDA) is adopting, as a final rule, without change, an interim rule that updated reporting and notification requirements associated with, and made clarifying changes to, the fruit, vegetable, and specialty crop import regulations for certain commodities regulated under section 608(e) (hereinafter referred to as ``8e'') of the Agricultural Marketing Agreement Act of 1937. The interim rule shifted the exempt reporting requirement for imported tomatoes destined for noncommercial outlets for experimental purposes from the tomato import regulations to the safeguard procedures section of the vegetable import regulations. In addition, the pistachio import regulations were updated by removing reference to a paper-based notification of entry process. Other administrative changes were made to several of the 8e regulations to replace outdated information. These changes to the import regulations support the International Trade Data System (ITDS), a system that streamlines and automates the filing of import and export information by the trade.

We are adopting as a final rule, without change, an interim rule that amended the Asian longhorned beetle (ALB) regulations by removing plants of the genus Celtis, which we have determined not to be a host plant of ALB, from the list of regulated articles. As a result of the interim rule, there are no longer any restrictions on the movement of Celtis spp. plants from areas quarantined for ALB.

We are adopting a new airworthiness directive (AD) for certain Piper Aircraft, Inc. Models PA-31, PA-31-300, PA-31-325, and PA-31-350 airplanes. This AD was prompted by fatigue cracking in the fuselage station (FS) 332.00 bulkhead common to the horizontal stabilizer front spar attachment. This AD requires repetitive inspections to detect cracks in the bulkhead and any necessary repairs. This AD also provides an optional modification if no cracks are found that will greatly reduce the likelihood of the specified cracks. We are issuing this AD to correct the unsafe condition on these products.

We are adopting a new airworthiness directive (AD) for DG Flugzeugbau GmbH Model DG-500MB gliders that are equipped with a Solo 2625 02 engine that has been modified with a fuel injection system following the instructions of Solo Kleinmotoren GmbH Service Bulletin (SB)/Technische Mitteilung (TM) 4600-3 ``Fuel Injection System'' and re-identified as Solo 2625 02i. This AD results from mandatory continuing airworthiness information (MCAI) issued by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as failure of the connecting rod bearing resulting from too much load on the rod bearings from the engine control unit. We are issuing this AD to require actions to address the unsafe condition on these products.

We are adopting a new airworthiness directive (AD) for certain Airbus Model A300 series airplanes; and Model A300 B4-600, B4-600R, and F4-600R series airplanes, and Model A300 C4-605R Variant F airplanes (collectively called Model A300-600 series airplanes). This AD was prompted by reports indicating that on airplanes that received a certain repair following crack findings, cracks can re-initiate. This AD requires repetitive inspections of the center wing frame (FR) 40 lower outboard radius for cracking, and related investigative and corrective actions if necessary. We are issuing this AD to address the unsafe condition on these products.

We are adopting a new airworthiness directive (AD) for certain The Boeing Company Model 787-8 and 787-9 airplanes. This AD was prompted by a report indicating that a portion of the sealant above the engine pylon between the wing skin and the vapor barrier might have been omitted. This AD requires an inspection for missing sealant in the seam on the outside and inside of the engine struts, and corrective actions if necessary. We are issuing this AD to address the unsafe condition on these products.

We are superseding Airworthiness Directive (AD) 2014-16-19 for all Airbus Model A330-200 Freighter, -200, and -300 series airplanes. AD 2014-16-19 required revision of the maintenance or inspection program to include certain fuel airworthiness limitations. This new AD requires revision of the maintenance or inspection program, as applicable, to include new fuel airworthiness limitations. This new AD also removes certain airplanes from the applicability of AD 2014-16-19. This AD was prompted by the issuance of more restrictive fuel airworthiness limitations. We are issuing this AD to address the unsafe condition on these products.

We are superseding Airworthiness Directive (AD) 2011-17- 09 for all Airbus Model A330-200, -200 Freighter, and -300 series airplanes; and AD 2012-25-12 for all Airbus Model A330-200 and -300 series airplanes. AD 2011-17-09 required revisions to certain operator maintenance documents to include new inspections. AD 2012-25-12 required replacing certain main landing gear (MLG) bogie beams before reaching new reduced life limits. This new AD requires revising the maintenance or inspection program, as applicable, to incorporate new, more restrictive, or revised instructions and/or airworthiness limitation requirements. This AD was prompted by revisions to certain airworthiness limitation item (ALI) documents, which specify more restrictive instructions and/or airworthiness limitations. We are issuing this AD to address the unsafe condition on these products.

We are adopting a new airworthiness directive (AD) for certain Airbus Model A321 series airplanes. This AD was prompted by a determination that cracks could develop on holes at certain fuselage frame locations. This AD requires repetitive inspections for cracking on holes at certain fuselage frame locations, and repairs if necessary. We are issuing this AD to address the unsafe condition on these products.

The Environmental Protection Agency (EPA) is approving several different State Implementation Plan (SIP) revisions submitted to EPA by the New Hampshire Department of Environmental Services (NHDES). New Hampshire submitted to EPA on October 26, 2016, revisions satisfying the NHDES's earlier commitment to adopt and submit provisions that meet certain requirements of the federal Prevention of Significant Deterioration (PSD) and Nonattainment New Source Review (NNSR) air permit program regulations. This action will convert to full approval EPA's September 25, 2015 conditional approval of New Hampshire's PSD and NNSR permit programs. This action also will approve NHDES's SIP revisions relating to several New Hampshire infrastructure SIPs, which were conditionally approved by EPA on December 16, 2015 and July 8, 2016. Additionally, EPA is also approving: A January 31, 2017 SIP revision amending the public notice and hearing procedures for New Hampshire's NNSR, PSD, and minor NSR permit programs; a January 18, 2017 SIP revision withdrawing the State SIP's permit fee system; and a November 17, 2015 SIP revision that addresses the good neighbor provisions of New Hampshire's infrastructure SIP for the 2010 nitrogen oxide (NO2) national ambient air quality standard (NAAQS). This action is being taken in accordance with the Clean Air Act (CAA). Lastly, EPA issued a correcting amendment in the Federal Register on May 5, 2017. An error occurred in an amendatory instruction and the table entry for ``Infrastructure SIP for the 2010 SO2 NAAQS'' could not be incorporated into the CFR. The EPA is correcting that error.

The Commission proposes to delete its existing ethics rules to avoid duplication and those changes proposed to by the Commission with the concurrence of the Office of Government Ethics.

This is a correction to a Request for Information published by the Commodity Futures Trading Commission (``Commission'' or ``CFTC'') in the Federal Register of May 9, 2017 regarding the submission by the public of suggestions about how the Commission's existing rules, regulations, or practices could be applied in a simpler, less burdensome, and less costly manner. This correction changes the web address to which suggestions may be submitted. The incorrect web address appeared in two places in the original document. To avoid any confusion and to ensure the public has all necessary information in one place, the Request for Information is being republished in full with the corrected web address.

The Omnibus Electronic Vessel Trip Report Framework proposes management measures to increase the timeliness, accuracy, and quality of fisheries data submitted to NMFS while also reducing the burden on the charter and party fishing fleets. The electronic vessel trip report Framework would implement a requirement for charter and party vessels that hold a permit to fish for Atlantic bluefish, black sea bass, scup, summer flounder, tilefish, squid, Atlantic mackerel, and/or butterfish, while on a trip carrying passengers for hire, to submit required VTRs by electronic means. These proposed measures are intended to improve the timeliness and accuracy of charter and party vessel trip reporting.