August 17, 2012 – Federal Register Recent Federal Regulation Documents

In accordance with the procedures governing the application for, and the processing of, special permits from the Department of Transportation's Hazardous Material Regulations (49 CFR part 107, subpart B), notice is hereby given that the Office of Hazardous Materials Safety has received the applications described herein. This notice is abbreviated to expedite docketing and public notice. Because the sections affected, modes of transportation, and the nature of application have been shown in earlier Federal Register publications, they are not repeated here. Requests for modification of special permits (e.g. to provide for additional hazardous materials, packaging design changes, additional mode of transportation, etc.) are described in footnotes to the application number. Application numbers with the suffix ``M'' denote a modification request. These applications have been separated from the new application for special permits to facilitate processing.

We are adopting a new airworthiness directive (AD) for all The Boeing Company Model 707 airplanes, and Model 720 and 720B series airplanes. This AD was prompted by reports of cracking of the midspar fittings, and of the engine and nacelle strut separating from the airplane. This AD requires performing a detailed inspection of the midspar fittings of the nacelle strut to confirm that the correct part number is installed, and installing the correct part number if necessary; performing repetitive high frequency eddy current (HFEC) inspections of the midspar fittings of the nacelle strut for cracks, and repair if necessary; and performing repetitive general visual inspections of the nacelle struts to verify that the nacelle strut has not drooped below its normal position, applying the droop stripe to the nacelle strut and sailboat fairing if necessary, and performing repair if necessary. We are issuing this AD to detect and correct cracking of the midspar fitting, which could result in separation of the nacelle strut and engine from the airplane while in flight, and consequent loss of controllability of the airplane.

The Dixie Resource Advisory Committee will meet in Panguitch, Utah. The committee is meeting as authorized under the Secure Rural Schools and Community Self-Determination Act (Pub. L. 112-141) and in compliance with the Federal Advisory Committee Act. The purpose of the committee is to improve collaborative relationships and to provide advice and recommendations to the Forest Service concerning projects and funding consistent with the title II of the Act. The meeting is open to the public. The purpose of the meeting is to review and recommend projects authorized under title II of the Act.

We are superseding two existing airworthiness directives (AD) for all Embraer S.A. Model ERJ 170 and ERJ 190 airplanes. Those ADs currently require revising the airplane flight manual (AFM) to introduce limitations for the use of auxiliary power unit (APU) bleed and to prohibit dispatch with a failed air management system (AMS) controller card. This new AD requires replacing the AMS controller processor module with one containing new software, and a new AFM revision. This AD was prompted by reports of the possible loss of automatic activation of the engine inlet ice protection system. We are issuing this AD to prevent the possibility of a right-hand (RH) engine compressor stall after the APU becomes the active bleed source for the left side, which may result in an engine failure; and to prevent the intermittent communication failure between the AMS controller cards and both secondary power distribution assemblies (SPDAs), which could lead to the loss of automatic activation of the engine inlet ice protection system when flying in icing conditions, which could result in ice accretion in the engine inlet and subsequent dual engine failure.