Federal Aviation Administration December 2018 – Federal Register Recent Federal Regulation Documents

We are adopting a new airworthiness directive (AD) for all Airbus SAS Model A330-223F and Model A330-243F airplanes. This AD was prompted by a report of cracking at fastener holes located at a certain frame on the lower shell panel junction. This AD requires repetitive special detailed inspections (rototest) of certain fastener holes located at the lower shell junction of a certain frame on both left- hand (LH) and right-hand (RH) sides, and applicable related investigative and corrective actions. We are issuing this AD to address the unsafe condition on these products.

We are adopting a new airworthiness directive (AD) for certain Airbus SAS Model A350-941 airplanes. This AD was prompted by reports that, for multimaterial (hybrid) joints of the passenger door frame fittings, the interfay sealant was not applied between all surfaces of the joint parts. This AD requires modification of the hybrid joints of the passenger doors by applying additional corrosion protection to the hybrid joints of the passenger door frame fittings. We are issuing this AD to address the unsafe condition on these products.

We propose to supersede Airworthiness Directive (AD) 2016-16- 01, which applies to certain Airbus SAS Model A330-200 Freighter, -200, and -300 series airplanes. AD 2016-16-01 requires an inspection of affected structural parts in the cargo and cabin compartments to determine if proper heat treatment has been done, and replacement or repair if necessary. Since we issued AD 2016-16-01, we have determined that additional affected parts in the cabin compartment structure must also be inspected. This proposed AD would retain the requirements of AD 2016-16-01 and require inspection of additional locations of the cabin compartment structure. We are proposing this AD to address the unsafe condition on these products.

The FAA is considering a proposal to change 0.38 acres of Clear Zone Easement contained in Parcel 17 to Avigation Easement in exchange for converting 1.23 acres of Avigation Easement contained in Parcel 20 to Clear Zone Easement. Both Parcel 17 and Parcel 20 share a common boundary and are owned by Crossing Rivers Health Center located at Prairie du Chien Municipal Airport, Prairie du Chien, WI. The proposed release of 0.38 acres of Clear Zone Easement to Avigation Easement is not in the Runway Protection Zone (RPZ). Of the easement being converted to Clear Zone from Avigation Easement in exchange for the release, 0.89 acres (of the 1.23 acres) lies in the RPZ, which brings that portion of the RPZ into conformance with FAA standards and policies. The release of 0.38 acres from Clear Zone Easement to Avigation Easement is required to build an Access Road to the Crossing Rivers Health Center and install a sign for the hospital. The conversion from Clear Zone Easement to Avigation Easement will not result in any impact to surfaces protected by Part 77 or airport design surfaces. The Clear Zone Easement was originally purchased to enable the Airport to ensure airport compatible development. The proposed future use of 0.38 acres of the land as an access road will prevent any incompatible development of the surrounding area in the RPZ.

In accordance with the Paperwork Reduction Act of 1995, FAA invites public comments about our intention to request the Office of Management and Budget (OMB) approval for to renew an information collection. The Federal Register Notice with a 60-day comment period soliciting comments on the following collection of information was published on September 19, 2018. The commercial air tour operational data provided to the FAA and the National Park Service will be used by the agencies as background information useful in the development of air tour management plans and voluntary agreements for purposes of meeting the mandate of the National Parks Air Tour Management Act (NPATMA) of 2000.

We are adopting a new airworthiness directive (AD) for all The Boeing Company Model 737-8 and -9 airplanes. This emergency AD was sent previously to all known U.S. owners and operators of these airplanes. This AD requires revising certificate limitations and operating procedures of the airplane flight manual (AFM) to provide the flight crew with runaway horizontal stabilizer trim procedures to follow under certain conditions. This AD was prompted by analysis performed by the manufacturer showing that if an erroneously high single angle of attack (AOA) sensor input is received by the flight control system, there is a potential for repeated nose-down trim commands of the horizontal stabilizer. We are issuing this AD to address the unsafe condition on these products.

We are adopting a new airworthiness directive (AD) for certain Airbus SAS Model A318, A319, A320, and A321 series airplanes. This AD was prompted by an evaluation by the design approval holder (DAH) indicating that the principal structural elements and certain life- limited parts are subject to widespread fatigue damage (WFD). This AD requires revising the existing maintenance or inspection program to incorporate new or more restrictive airworthiness limitations. We are issuing this AD to address the unsafe condition on these products.

We propose to adopt a new airworthiness directive (AD) for certain Airbus SAS Model A330-201, -202, and -203, and Model A330-301, -302, and -303 airplanes. This proposed AD was prompted by reports of damaged drain pipes located above the lower aft pylon fairing (LAPF), caused by a contact between the drain pipe and the two u-shape ribs of the LAPF. This proposed AD would require a special detailed inspection for damage and corrective actions, if necessary. We are proposing this AD to address the unsafe condition on these products.

This rule establishes, amends, suspends, or removes Standard Instrument Approach Procedures (SIAPs) and associated Takeoff Minimums and Obstacle Departure Procedures (ODPs) for operations at certain airports. These regulatory actions are needed because of the adoption of new or revised criteria, or because of changes occurring in the National Airspace System, such as the commissioning of new navigational facilities, adding new obstacles, or changing air traffic requirements. These changes are designed to provide safe and efficient use of the navigable airspace and to promote safe flight operations under instrument flight rules at the affected airports.

In accordance with the Paperwork Reduction Act of 1995, FAA invites public comments about our intention to request the Office of Management and Budget (OMB) approval for [a new or to renew an] information collection. The Federal Register Notice with a 60-day comment period soliciting comments on the following collection of information was published on September 19, 2018. The information collected is used to allow some experienced pilots who would otherwise qualify as flight instructors or check airmen, but who are not medically eligible to hold the requisite medical certificate, to perform flight instructor or check airmen functions.

This action amends Class E surface area airspace at Kemmerer Municipal Airport, Kemmerer, WY, by enlarging the airspace area north of the airport and removing the Notice to Airmen (NOTAM) part-time status for the airspace. Also, this action reduces Class E airspace extending upward from 700 feet above the surface and removes Class E airspace extending upward from 1,200 feet above the surface.