Federal Aviation Administration May 21, 2018 – Federal Register Recent Federal Regulation Documents

Proposed Establishment of Class E Airspace; Glen Ullin, ND
Document Number: 2018-10654
Type: Proposed Rule
Date: 2018-05-21
Agency: Federal Aviation Administration, Department of Transportation
This action proposes to establish Class E airspace extending upward from 700 feet above the surface at Glen Ullin Regional Airport, Glen Ullin, ND. Controlled airspace is necessary to accommodate new standard instrument approach procedures developed at Glen Ullin Regional Airport, for the safety and management of instrument flight rules (IFR) operations.
Airworthiness Directives; Sikorsky Aircraft Corporation
Document Number: 2018-10581
Type: Rule
Date: 2018-05-21
Agency: Federal Aviation Administration, Department of Transportation
We are adopting a new airworthiness directive (AD) for Sikorsky Aircraft Corporation (Sikorsky) Model S-76C helicopters. This AD requires inspecting the engine collective position transducer (CPT). This AD was prompted by reports of wear of the CPT that has resulted in several One Engine Inoperative (OEI) incidents. The actions of this AD are intended to detect and prevent an unsafe condition on these products.
Airworthiness Directives; Bell Helicopter Textron Canada Limited (Bell) Helicopters
Document Number: 2018-10491
Type: Rule
Date: 2018-05-21
Agency: Federal Aviation Administration, Department of Transportation
We are adopting a new airworthiness directive (AD) for Bell Model 407 helicopters. This AD requires repetitive inspections of the tail rotor (TR) driveshaft segment assemblies and a torque check of the TR adapter retention nuts. This AD was prompted by a report of an in- flight failure of the TR drive system. The actions of this AD are intended to detect and correct an unsafe condition on these products.
Airworthiness Directives; Bombardier, Inc., Airplanes
Document Number: 2018-09732
Type: Rule
Date: 2018-05-21
Agency: Federal Aviation Administration, Department of Transportation
We are adopting a new airworthiness directive (AD) for certain Bombardier, Inc., Model CL-600-1A11 (CL-600), CL-600-2A12 (CL-601 Variant), and CL-600-2B16 (CL-601-3A, CL-601-3R, and CL-604 Variants) airplanes. This AD was prompted by reports of fractured rudder pedal tubes on the pilot-side rudder bar assembly. This AD requires repetitive inspections of the rudder pedal tubes for cracking and corrective actions if necessary. Replacement of both pilot-side rudder bar assemblies terminates the inspections. We are issuing this AD to address the unsafe condition on these products.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.