Federal Aviation Administration December 12, 2016 – Federal Register Recent Federal Regulation Documents

The Federal Aviation Administration (FAA) announces its determination that the Noise Exposure Maps (NEM's) submitted by the Melbourne Airport Authority (Authority, Melbourne, FL) for the Orlando Melbourne International Airport (MLB), Melbourne, FL under the provisions of 40 U.S.C. 47501 et seq. (Aviation Safety and Noise Abatement Act) and 14 CFR 150 are in compliance with applicable requirements. The FAA also announces that it is reviewing a proposed Noise Compatibility Program (NCP) that was submitted for the Orlando Melbourne International Airport under Part 150 in conjunction with the Noise Exposure Maps, and that this program will be approved or disapproved on or before May 30, 2017.

This action proposes to establish Class E airspace at Kill Devil Hills, NC, to accommodate new Area Navigation (RNAV) Global Positioning System (GPS) Standard Instrument Approach Procedures (SIAPs) serving First Flight Airport. Controlled airspace is necessary for the safety and management of instrument flight rules (IFR) operations at the heliport.

We are superseding Airworthiness Directive (AD) 2012-22-02 for certain The Boeing Company Model 747-400, -400D, and -400F series airplanes. AD 2012-22-02 required measuring the web at station (STA) 320 and, depending on findings, various inspections for cracks and missing fasteners, web and fastener replacement, and related investigative and corrective actions if necessary. This new AD requires, for certain airplanes, replacement of the web, including related investigative and corrective actions if necessary. This AD was prompted by a determination that there were no inspection or repair procedures included in AD 2012-22-02 for airplanes with a certain crown frame web thickness. We are issuing this AD to address the unsafe condition on these products.

We are adopting a new airworthiness directive (AD) for certain Bombardier, Inc. Model DHC-8-400 series airplanes. This AD was prompted by a determination by the manufacturer that shims might not have been installed between certain longerons and longeron joint fittings. This AD requires various repetitive and detailed visual inspections of the affected areas and corrective actions if necessary. This AD also provides terminating action for certain repetitive inspections. We are issuing this AD to address the unsafe condition on these products.