Federal Aviation Administration May 19, 2008 – Federal Register Recent Federal Regulation Documents

Airworthiness Directives; Engine Components Inc. (ECi) Reciprocating Engine Cylinder Assemblies
Document Number: E8-11116
Type: Proposed Rule
Date: 2008-05-19
Agency: Federal Aviation Administration, Department of Transportation
The FAA proposes to adopt a new airworthiness directive (AD) for Lycoming Engines (formerly Textron Lycoming) models 320, 360, and 540 series, ``Parallel Valve'' reciprocating engines, with certain Engine Components Inc. (ECi) cylinder assemblies, part number (P/N) AEL65102 series ``Titan'', installed. This proposed AD would require initial and repetitive visual inspections and compression tests to detect cracks at the head-to-barrel interface, replacement of cylinder assemblies found cracked, and replacement of certain cylinder assemblies, at new reduced times-in-service. This proposed AD results from reports of 45 failures with head separations of ECi cylinder assemblies. We are proposing this AD to prevent loss of engine power due to cracks at the head-to-barrel interface in the cylinder assemblies and possible engine failure caused by separation of a cylinder head, which could result in loss of control of the aircraft.
Airworthiness Directives; Bombardier Model CL-600-2C10 (Regional Jet Series 700 & 701) Series Airplanes and Model CL-600-2D24 (Regional Jet Series 900) Series Airplanes
Document Number: E8-11112
Type: Proposed Rule
Date: 2008-05-19
Agency: Federal Aviation Administration, Department of Transportation
The FAA proposes to revise an existing airworthiness directive (AD) that applies to certain Bombardier Model CL-600-2C10 (Regional Jet series 700 & 701) series airplanes and Model CL-600-2D24 (Regional Jet series 900) series airplanes. The existing AD currently requires revising the Airworthiness Limitations section of the Instructions of Continued Airworthiness by incorporating new repetitive inspections and an optional terminating action for the repetitive inspections, and repairing any crack. This proposed AD would clarify the applicability of the existing AD. This proposed AD results from reports of hydraulic pressure loss in either the number 1 or number 2 hydraulic system due to breakage or leakage of hydraulic lines in the aft equipment bay and reports of cracks on the aft pressure bulkhead web around these feed- through holes. We are proposing this AD to prevent loss of hydraulic pressure, which could result in reduced controllability of the airplane, and to detect and correct cracks on the aft pressure bulkhead web, which could result in reduced structural integrity of the aft pressure bulkhead.
Airworthiness Directives; Various Aircraft Equipped With Honeywell Primus II RNZ-850( )/-851(-) Integrated Navigation Units
Document Number: E8-11104
Type: Proposed Rule
Date: 2008-05-19
Agency: Federal Aviation Administration, Department of Transportation
The FAA proposes to supersede an existing airworthiness directive (AD) that applies to various aircraft equipped with certain Honeywell Primus II RNZ-850( )/-851( ) integrated navigation units (INUs). The existing AD, as one alternative for compliance, provides for a one-time inspection to determine whether a certain modification has been installed on the Honeywell Primus II NV-850 navigation receiver module (NRM), which is part of the INU. In lieu of accomplishing this inspection, and for aircraft found to have an affected NRM, that AD provides for revising the aircraft flight manual to include new limitations for instrument landing system approaches. That AD also requires an inspection to determine whether certain other modifications have been done on the NRM; and doing related investigative, corrective, and other specified actions, as applicable; as well as further modifications to address additional anomalies. This proposed AD would extend the compliance time for a certain inspection and associated actions. This proposed AD would also revise the applicability to include additional affected INUs. This proposed AD results from reports indicating that erroneous localizer and glideslope indications have occurred on certain aircraft equipped with the subject INUs. We are proposing this AD to ensure that the flight crew has accurate localizer and glideslope deviation indications. An erroneous localizer or glideslope deviation indication could lead to the aircraft making an approach off the localizer, which could result in impact with an obstacle or terrain.
Proposed Establishment of Class D Airspace; Victoria, TX
Document Number: E8-10953
Type: Proposed Rule
Date: 2008-05-19
Agency: Federal Aviation Administration, Department of Transportation
This action proposes to establish Class D airspace at Victoria Regional Airport, Victoria, TX. The establishment of an air traffic control tower has made this action necessary for the safety of Instrument Flight Rule (IFR) operations at Victoria Regional Airport.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.