Federal Aviation Administration 2007 – Federal Register Recent Federal Regulation Documents

This document contains a correction to the final rule (FAA- 2007-27262; 07-ASO-1), which was published in the Federal Register of May 8, 2007, (72 FR 25963), amending Class E airspace at Middlesboro, KY. This action corrects an error in the legal description for the Class E5 airspace at Middlesboro, KY.

The FAA is superseding an existing airworthiness directive (AD), which applies to certain transport category airplanes identified above. That AD currently requires modification of the reinforced flight deck door and other actions related to the reinforced flight deck door. Those other actions include modifying the door, inspecting and modifying wiring in the area, and revising the maintenance program to require more frequent testing of the decompression panels of the flight deck door. This new AD continues to require the existing requirements. This new AD adds airplanes to the existing requirement of a one-time inspection for chafing of wire bundles in the area of the flight deck door and corrective actions if necessary. This proposed AD also removes certain airplanes from the applicability. This AD results from a report of smoke and fumes in the cockpit of a Model 737-300 series airplane. We are issuing this AD to prevent inadvertent release of the decompression latch and consequent opening of the decompression panel in the flight deck door, or penetration of the flight deck door by smoke, any of which could result in injury to the airplane flightcrew. We are also proposing this AD to detect and correct wire chafing, which could result in arcing, fire, and/or reduced controllability of the airplane.

The FAA is adopting a new airworthiness directive (AD) for all Airbus Model A300-600 series airplanes. This AD requires revising the Airworthiness Limitations section of the Instructions for Continued Airworthiness to incorporate new limitations for fuel tank systems. This AD results from fuel system reviews conducted by the manufacturer. We are issuing this AD to prevent the potential of ignition sources inside fuel tanks, which, in combination with flammable fuel vapors caused by latent failures, alterations, repairs, or maintenance actions, could result in fuel tank explosions and consequent loss of the airplane.

The FAA is considering rulemaking to change the packing interval for certain types of parachutes. Currently, the FAA requires that most parachutes may not be used or carried aboard an aircraft and available for emergency use unless they have been packed within the previous 120 days. New reliability data from the parachute industry and other sources indicate it is time to review the packing interval, and the FAA is asking for public comment on a proposal to lengthen the interval from 120 to 180 days. The effect of the proposal is to ensure the rules reflect the safest parachute packing interval. In this rulemaking, we are also proposing several correcting amendments to the rules related to parachute operations.

The FAA is superseding an existing airworthiness directive (AD) that applies to all Boeing Model 727 airplanes. The existing AD requires a boost pump dry bay inspection to detect leakage of fuel through an arced-through conduit, and corrective action as necessary. The existing AD also requires repetitive inspections of the in-tank fuel boost pump wiring to detect chafing of the wire insulation, evidence of electrical arcing, or arc-through of the conduit wall, and applicable corrective action; and installation of sleeving over the in- tank fuel boost pump wires as a method to protect the wiring from chafing. This new AD removes certain inspection requirements from the existing AD. This new AD adds new repetitive inspections for damage of the electrical wire and sleeve that run to the fuel boost pump through a conduit in the fuel tank, and arcing damage of the conduit and signs of fuel leakage into the conduit; applicable investigative and corrective actions; and a new repetitive engine fuel suction feed operational test. Initiation of the new inspections terminates the requirements of the existing AD. This AD results from reports of a fuel tank explosion on a Model 727-200F airplane on the ground; and of chafed wires and a damaged power cable sleeve of a fuel boost pump that were discovered during an inspection required by an existing AD on a Model 737-300 airplane. We are issuing this AD to detect and correct chafing of the fuel boost pump electrical wiring and leakage of fuel into the conduit, and to prevent electrical arcing between the wiring and the surrounding conduit, which could result in arc-through of the conduit, and consequent fire or explosion of the fuel tank.

This action proposes to establish a low altitude Global Positioning System (GPS)/Global Navigation Satellite System (GNSS) area navigation (RNAV) route, designatedT-209, in the vicinity of Augusta, GA. The FAA is proposing this action to enhance the safe and efficient use of the navigable airspace. The proposed route would reduce air traffic controller workload and provide a nonradar route that ensures clearance from the Bulldog A Military Operations Area (MOA).

This action proposes to revise Class E airspace at Fort Yukon, AK. One Standard Instrument Approach Procedure (SIAP) is being amended and three new SIAPs are being developed for the Fort Yukon Airport. A Departure Procedure (DP) and a Direction Finding (DF) procedure (used by Flight Service Station personnel) is also being amended. Adoption of this proposal would result in revision of existing Class E airspace upward from the surface, from 700 feet (ft.) and 1,200 ft. above the surface, at Fort Yukon Airport, Fort Yukon, AK.

The FAA is superseding an existing airworthiness directive (AD) for Turbomeca Arrius 2F turboshaft engines. That AD currently requires removing from service certain serial number (SN) fuel control units (FCUs) or replacing the constant delta pressure (delta P) diaphragm in those FCUs. This AD requires replacing all FCUs not incorporating modification Tf 55 with FCUs that incorporate modification Tf 55. This AD results from the European Aviation Safety Agency (EASA) and Turbomeca expanding the applicability to the full population of FCUs installed on Arrius 2F turboshaft engines. FCUs not incorporating modification Tf 55 are susceptible to having an improperly assembled constant delta P diaphragm. We are issuing this AD to prevent an uncommanded engine in-flight shutdown on a single-engine helicopter, resulting in a forced autorotation landing or an accident.

We are adopting a new airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) issued by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

We are superseding an existing airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) issued by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

This notice proposed to establish Class E airspace at Centreville, AL. An Area Navigation (RNAV) Global Positioning System (GPS) Standard Instrument Approach Procedure (SIAP) Runway (RWY) 10 has been developed for Bibb County Airport. As a result, controlled airspace extending upward from 700 feet Above Ground Level (AGL) is needed to contain the SIAP and for Instrument Flight Rules (IFR) operations at Bibb County Airport. The operating status of the airport will change from Visual Flight Rules (VFR) to include IFR operations concurrent with the publication of the SIAP.

The Federal Aviation Administration (FAA) is considering a proposal to change a portion of the airport from aeronautical use to non-aeronautical use and to authorize the release of 188.653 acres of vacant airport property previously used for agricultural purposes for the proposed development of bulk warehouse/distribution facilities as a component of the Rickenbacker Global Logistics Park. The land was acquired by the Rickenbacker Port Authority through three Quitclaim Deeds from the United States of American dated March 30, 1984, September 22, 2004 (amended and restated August 26, 2005) and May 16, 2005. There are no impacts to the airport by allowing the airport to dispose of the property. Approval does not constitute a commitment by the FAA to financially assist in the disposal of the subject airport property nor a determination of eligibility for grant-in-aid funding from the FAA. The CRAA will receive $4,245,000 for the parcel. In accordance with section 47107(h) of title 49, United States Code, this notice is required to be published in the Federal Register 30 days before modifying the land-use assurance that requires the property to be used for an aeronautical purpose.

The FAA proposes to adopt a new airworthiness directive (AD) for PW PW4164, PW4168, and PW4168A turbofan engines with certain low pressure turbine (LPT) stage 4 disks, part number (P/N) 51N404, installed. This proposed AD would require removing certain LPT stage 4 disks, listed by serial number at the next piece-part exposure or within 7,500 cycles-since-new (CSN), whichever occurs first. This proposed AD results from a report of improperly manufactured LPT stage 4 disks. We are proposing this AD to prevent an uncontained engine failure due to low-cycle fatigue (LCF), which could result in damage to the airplane.

The FAA is issuing this notice to advise the public of a meeting of RTCA Special Committee 206: Aeronautical Information Services Data Link.

We propose to adopt a new airworthiness directive (AD) for the products listed above. This proposed AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

We propose to adopt a new airworthiness directive (AD) for the products listed above. This proposed AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

This notice contains a summary of a certain petition seeking relief from specified requirements of 14 CFR. The purpose of this notice is to improve the public's awareness of, and participation in, this aspect of FAA's regulatory activities. Neither publication of this notice nor the inclusion or omission of information in the summary is intended to affect the legal status of any petition or its final disposition.

The FAA is adopting a new airworthiness directive (AD) to supersede AD 2006-06-06, which applies to certain Cessna Aircraft Company (Cessna) Models 208 and 208B airplanes. AD 2006-06-06 currently requires you to incorporate information into the applicable section of the Airplane Flight Manual (AFM) and Pilot's Operating Handbook (POH) and requires you to install placards. Since we issued AD 2006-06-06, Cessna issued new S1 Known Icing Equipment AFM supplements and developed a low airspeed awareness system. Consequently, this AD requires you to incorporate the applicable AFM supplement revision and temporarily retain the requirements of AD 2006-06-06 until the above revisions are incorporated. One of the AFM requirements is the installation of a functional low airspeed awareness system to operate the airplane in known icing conditions. We are issuing this AD to assure that the pilot has enough information and the necessary equipment to prevent loss of control of the airplane while in-flight during icing conditions.

We are adopting a new airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) issued by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

We propose to supersede Airworthiness Directive (AD) 82-07-04, which applies to certain Allied Ag Cat Productions, Inc. (Ag Cat) G-164 series airplanes. AD 82-07-04 currently requires you to modify the fuel shut-off valve control by installation of a new stop-plate. Since we issued AD 82-07-04, we have determined the need to add airplane models and serial numbers that were not previously included in the applicability. Consequently, this proposed AD would retain the actions of AD 82-07-04 and add airplane models and serial numbers to the applicability. We are proposing this AD to prevent turning the fuel shut-off valve clockwise past the ``ON'' position stop which, if not corrected, could allow the fuel valve to be rotated to an unplacarded ``OFF'' position. This condition could lead to reduced fuel flow and consequent loss of engine power.

The FAA proposes to supersede an existing airworthiness directive (AD) that applies to certain Airbus Model A300-600, A310-200, and A310-300 series airplanes. The existing AD currently requires inspecting for certain serial numbers on elevators, and doing a detailed inspection, visual inspection with a low-angle light, and tap- test inspection of the upper and lower surfaces of the external skins on certain identified elevators for any damage (i.e., debonding of the graphite fiber reinforced plastic/Tedlar film protection, bulges, debonding of the honeycomb core to the carbon fiber reinforced plastic, abnormal surface reflections, and torn-out plies), and doing corrective actions if necessary. This proposed AD would also require inspecting for damage of the identified elevators in accordance with a new repetitive inspection program, at new repetitive intervals; and would provide an optional terminating action for the repetitive inspections. This proposed AD results from reports of damage caused by moisture/water inside the elevator. We are proposing this AD to detect and correct debonding of the skins on the elevators, which could cause reduced structural integrity of an elevator and reduced controllability of the airplane.

This amendment establishes, amends, suspends, or revokes Standard Instrument Approach Procedures (SIAPs) and/or Weather Takeoff Minimums for operations at certain airports. These regulatory actions are needed because of the adoption of new or revised criteria, or because of changes occurring in the National Airspace System, such as the commissioning of new navigational facilities, addition of new obstacles, or changes in air traffic requirements. These changes are designed to provide safe and efficient use of the navigable airspace and to promote safe flight operations under instrument flight rules at the affected airports.

The FAA is announcing its Adoption of the United States Air Force (USAF) Final Environmental Impact Statement (FEIS) for the New Mexico Training Range Initiative and approval of the FAA Record of Decision (ROD). The New Mexico Training Range Initiative (NMTRI) is the USAF initiative to create airspace that allows mainly F-16 and aircrews to receive much needed realistic combat training while maximizing their training time. NMTRI includes the Pecos MOA complex.

This action amends Title 14 Code of Federal Regulations, part 71 (14 CFR 71) by modifying the legal description of Class D airspace and Class E airspace at Manhattan Municipal Airport, KS. The establishment of adjacent Class D airspace at Fort Riley, Marshall Army Airfield, KS requires this modification. The intended effect of this rule is to provide controlled airspace of appropriate dimensions to protect aircraft operating in these areas.

This action amends Title 14 Code of Federal Regulations, part 71q (14 CFR 71) by modifying the Class E airspace area at Marshalltown Municipal Airport, IA. The cancellation of the Non Directional Beacon (NDB) Instrument Approach Procedure (IAP) and subsequent decommissioning of the Marshalltown NDB requires modification of the Class E airspace area extending upward from 700 feet above the surface of the earth. The intended effect of this rule is to provide controlled airspace of appropriate dimensions to protect aircraft executing Standard Instrument Approach Procedures (SIAP) to Marshalltown Municipal Airport, IA.