National Highway Traffic Safety Administration December 2015 – Federal Register Recent Federal Regulation Documents

This document grants in full the Maserati North America, Inc.'s, (Maserati) petition for an exemption of the Levante sports utility vehicle (SUV) line in accordance with 49 CFR part 543, Exemption from Vehicle Theft Prevention Standard. This petition is granted because the agency has determined that the antitheft device to be placed on the line as standard equipment is likely to be as effective in reducing and deterring motor vehicle theft as compliance with the parts-marking requirements of the 49 CFR part 541, Federal Motor Vehicle Theft Prevention Standard (Theft Prevention Standard).

NHTSA seeks comments on the economic impact of its regulations on small entities. As required by Section 610 of the Regulatory Flexibility Act, we are attempting to identify rules that may have a significant economic impact on a substantial number of small entities. We also request comments on ways to make these regulations easier to read and understand. The focus of this notice is rules that specifically relate to passenger cars, multipurpose passenger vehicles, trucks, buses, trailers, motorcycles, and motor vehicle equipment.

In accordance with 49 CFR part 555, NHTSA seeks comments on a petition for exemption from Federal Motor Vehicle Safety Standard (FMVSS) No. 224, Rear impact protection by Columbia Body Manufacturing Co. (``Columbia Body'' or ``petitioner'') of Clackamas, Oregon. Columbia Body is seeking a three year exemption from the standard, asserting that compliance with the standard would cause substantial economic hardship to a manufacturer that has tried in good faith to comply with the standard. We are publishing this notice of receipt of the application in accordance with our exemption regulations. This action does not mean that we have made a judgment about the merits of the application.

In compliance with the Paperwork Reduction Act of 1995 (44 U.S.C. 3501 et seq.), this notice announces that the Information Collection Request (ICR) abstracted below is being forwarded to the Office of Management and Budget (OMB) for review and comments.

This NPRM proposes to upgrade the Federal motor vehicle safety standards that address rear underride protection in crashes into trailers and semitrailers. NHTSA is proposing to adopt requirements of Transport Canada's standard for underride guards, which require rear impact guards to provide sufficient strength and energy absorption to protect occupants of compact and subcompact passenger cars impacting the rear of trailers at 56 kilometers per hour (km/h) (35 miles per hour (mph)). NHTSA is issuing this NPRM in response to a petition for rulemaking from the Insurance Institute for Highway Safety (IIHS), and from Ms. Marianne Karth and the Truck Safety Coalition (TSC). This is the second of two documents issued in response to the Karth/TSC petition. Earlier, NHTSA published an advanced notice of proposed rulemaking requesting comment on strategies pertaining to underride protection afforded by single unit trucks.

Bridgestone Americas Tire Operations, LLC (BATO), has determined that certain Bridgestone bus tires do not fully comply with paragraph S6.5(e) of Federal Motor Vehicle Safety Standard (FMVSS) No. 119, New Pneumatic Tires for Motor Vehicles With a GVWR of More than 4,536 kilograms (10,000 pounds) and Motorcycles. BATO has filed an appropriate report dated July 7, 2015, pursuant to 49 CFR part 573, Defect and Noncompliance Responsibility and Reports.

Before a Federal agency can collect certain information from the public, it must receive approval from the Office of Management and Budget (OMB). Under procedures established by the Paperwork Reduction Act of 1995, before seeking OMB approval, Federal agencies must solicit public comment on proposed collections of information, including extensions and reinstatements of previously approved collections. This document describes one collection of information for which NHTSA intends to seek OMB approval.

The Department of Transportation (DOT) invites public comments about our intention to request the Office of Management and Budget (OMB) approval to renew an information collection. Before a Federal agency can collect certain information from the public, it must receive approval from the Office of Management and Budget (OMB). Under procedures established by the Paperwork Reduction Act of 1995, before seeking OMB approval, Federal agencies must solicit public comment on proposed collections of information, including extensions and reinstatement of previously approved collections.