Federal Aviation Administration November 12, 2024 – Federal Register Recent Federal Regulation Documents

The FAA proposes to adopt a new airworthiness directive (AD) for certain The Boeing Company Model 747-400, 747-400F, 747-8F, and 747-8 series airplanes. This proposed AD was prompted by a report that, during potable water servicing, there were multiple engine indicating and crew alerting system messages. The cause was the separation of a fitting and steel water supply tube above an electronics equipment cooling air filter, behind the forward cargo compartment left sidewall. This proposed AD would require, depending on configuration, installing at certain locations: conduits on exposed potable water supply lines, envelope assemblies over all exposed potable water line fittings and exposed potable water supply lines, a slitted spray shield, a 2-piece deflector shield around the equipment cooling system air inlet, and/or a shroud on exposed potable water supply lines. The FAA is proposing this AD to address the unsafe condition on these products.

The FAA proposes to adopt a new airworthiness directive (AD) for all ATRGIE Avions de Transport R[eacute]gional Model ATR72 airplanes. This proposed AD was prompted by reports of the main landing gear (MLG) rear hinge pin being ruptured. This proposed AD would require replacing affected parts and prohibit the installation of affected parts, as specified in a European Union Aviation Safety Agency (EASA) AD, which is proposed for incorporation by reference (IBR). The FAA is proposing this AD to address the unsafe condition on these products.

The FAA is adopting a new airworthiness directive (AD) for all Bombardier, Inc., Model BD-100-1A10 airplanes. This AD was prompted by a determination that new or more restrictive maintenance tasks are necessary. This AD requires revising the existing maintenance or inspection program, as applicable, to incorporate new or more restrictive maintenance tasks. The FAA is issuing this AD to address the unsafe condition on these products.

The FAA is superseding Airworthiness Directive (AD) 2021-09- 03, which applied to certain Airbus Canada Limited Partnership Model BD-500-1A10 and BD-500-1A11 airplanes. AD 2021-09-03 required repetitive replacements of the emergency locator transmitter (ELT) antenna and repetitive inspections of the exterior fuselage skin around the ELT antenna attachment area. This AD was prompted by a report that there was an in-service failure of an ELT antenna that occurred before the repetitive replacement interval required by AD 2021-09-03, and that a terminating action was developed. This AD continues to require the actions in AD 2021-09-03 and requires replacement of the ELT antenna with a new ELT antenna, inspection of the exterior fuselage skin around the ELT antenna attachment holes, and repair if necessary; as specified in a Transport Canada AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.

The FAA proposes to adopt a new airworthiness directive (AD) for certain International Aero Engines (IAE AG) Model V2522-A5, V2524- A5, V2525-D5, V2527-A5, V2527E-A5, V2527M-A5, V2528-D5, V2530-A5, V2531-E5, and V2533-A5 engines. This proposed AD was prompted by further analysis of an event involving an IAE AG Model V2533-A5 engine that had an uncontained failure of a high-pressure turbine (HPT) 1st- stage hub that resulted in high-energy debris penetrating the engine cowling. This proposed AD would require revising the airworthiness limitations section (ALS) of the existing maintenance manual or instructions for continued airworthiness and the existing approved maintenance or inspection program, as applicable, to include new inspections of certain critical rotating parts. The FAA is proposing this AD to address the unsafe condition on these products.