Federal Aviation Administration September 26, 2024 – Federal Register Recent Federal Regulation Documents
Results 1 - 7 of 7
Establishment of Class E Airspace; Victoria, TX
This action proposes to establish Class E airspace at Victoria, TX. The FAA is proposing this action to support new instrument procedures at this airport.
Airworthiness Directives; Airbus SAS Airplanes
The FAA is withdrawing a notice of proposed rulemaking (NPRM) that proposed to adopt a new airworthiness directive (AD) that would have applied to all Airbus SAS Model A319-111, -112, -113, -114, -115, -131, -132, and -133 airplanes; Model A320-211, -212, -214, -216, -231, -232, and -233 airplanes; and Model A321-111, -112, -131, -211, -212, - 213, -231, -232, and -271N airplanes. The NPRM was prompted by a determination that a damage-tolerance and fatigue reassessment of nose landing gear (NLG) repairs is necessary for certain parts fitted on airplanes approved for operation in the Commonwealth of Independent States (CIS). The NPRM would have required repair and replacement of all affected parts, and would have limited installation of affected parts, as specified in a European Union Aviation Safety Agency (EASA) AD. Since issuance of the NPRM, the FAA has determined that the applicability as specified in the NPRM was incorrect; the FAA is issuing new rulemaking that corrects the applicability. Accordingly, the NPRM is withdrawn.
Airworthiness Directives; The Boeing Company Airplanes
The FAA proposes to supersede Airworthiness Directive (AD) 2022-15-06, which applies to all The Boeing Company Model 777-200, - 200LR, -300, -300ER, and 777F series airplanes. AD 2022-15-06 requires disconnecting certain connectors and capping and stowing the wires that had been attached to the affected transorb modules. Since the FAA issued AD 2022-15-06, the agency has determined additional connectors are affected. Also, a replacement has been developed to address the unsafe condition, which would terminate the existing actions. This proposed AD would continue to require the actions specified in AD 2022- 15-06 and would require those actions for additional connectors. This proposed AD would also require determining if affected transorb modules are installed, replacing or testing affected transorb modules, and applicable on-condition actions. This proposed AD would also prohibit the installation of affected parts. The FAA is proposing this AD to address the unsafe condition on these products.
Establishment of Class E Airspace; Brevard, NC
This action proposes to establish Class E airspace extending upward from 700 feet above the surface for Transylvania Community Hospital, Brevard, NC, to accommodate new area navigation (RNAV) global positioning system (GPS) standard instrument approach procedures serving the heliport. Controlled airspace is necessary for the safety and management of instrument flight rules (IFR) operations at this heliport.
Airworthiness Directives; Robinson Helicopter Company Helicopters
The FAA is adopting a new airworthiness directive (AD) for all Robinson Helicopter Company Model R44 and R44 II helicopters. This AD was prompted by reports of a fractured clutch shaft forward yoke (yoke) on the main rotor (M/R) drive due to fatigue cracking. This AD requires visually inspecting a certain part-numbered flex plate assembly (flex plate) and certain part-numbered yokes, including each flex plate bolt, and depending on the inspection results, removing an affected part from service and replacing an affected part with an airworthy part. This AD also requires removing a certain part-numbered yoke from service after accumulating a certain number of hours time-in-service (TIS) or a certain number of years, or as an alternative to removing the part from service, performing a 10x or higher power magnification visual inspection and, if needed, a magnetic particle inspection. The FAA is issuing this AD to address the unsafe condition on these products.
Establishment of Class D Airspace and Amendment of Class E Airspace; Auburn, AL
This action proposes to establish Class D airspace and amend Class E airspace extending upward from 700 feet above the surface for Auburn University Regional Airport, Auburn, AL, as a new air traffic control tower will service the airport. Controlled airspace is necessary for the safety and management of instrument flight rules (IFR) operations in the area.
Airworthiness Directives; Bell Textron Inc. and Various Restricted Category Helicopters
The FAA is adopting a new airworthiness directive (AD) for Bell Textron Inc. Model 204B, 205A, 205A-1, 205B, 210, and 212 helicopters and various restricted category helicopters with certain part-numbered tension torsion (TT) straps installed by supplemental type certificate (STC) No. SR03408CH. This AD was prompted by an accident involving failure of a TT strap. This AD requires removing the specified part-numbered TT straps from service and prohibits installing those TT straps. The FAA is issuing this AD to address the unsafe condition on these products.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
