Federal Aviation Administration September 14, 2023 – Federal Register Recent Federal Regulation Documents
Results 1 - 9 of 9
Airworthiness Directives; Bombardier, Inc., Airplanes
The FAA is adopting a new airworthiness directive (AD) for certain Bombardier, Inc., Model CL-600-1A11 (600), CL-600-2A12 (601), and CL-600-2B16 (601-3A, 601-3R, and 604 Variants) airplanes. This AD was prompted by an uncommanded flap extension accompanied by a flaps fail caution message during climb. This AD requires initial and repetitive operational tests of the flap control system. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; ATR-GIE Avions de Transport Régional Airplanes
The FAA is adopting a new airworthiness directive (AD) for all ATRGIE Avions de Transport R[eacute]gional Model ATR42 and ATR72 airplanes. This AD was prompted by a determination that some batches of nose landing gear (NLG) drag brace panels (DBP) having certain part numbers were affected by a quality deficiency that was not detected in production. This AD requires a measurement of the affected part and, depending on findings, accomplishment of applicable corrective actions, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. This AD also prohibits the installation of affected parts. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Saab AB, Support and Services (Formerly Known as Saab AB, Saab Aeronautics) Airplanes
The FAA is adopting a new airworthiness directive (AD) for certain Saab AB, Support and Services Model 340A (SAAB/SF340A) and SAAB 340B airplanes. This AD was prompted by reports of a high number of events related to stall warnings upon landing, following introduction of the ice speed function within the stall warning system. This AD requires modification of the stall warning/identification system, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Airbus SAS Airplanes
The FAA is adopting a new airworthiness directive (AD) for all Airbus SAS Model A330-200 series airplanes, Model A330-200 Freighter series airplanes, Model A330-300 series airplanes, Model A340-200 series airplanes, and Model A340-300 series airplanes. This AD was prompted by a report that certain overheat detection system (OHDS) sensing elements, produced before January 31, 2021, may not properly detect thermal bleed leak events due to a quality escape during the manufacturing process. This AD requires a one-time special detailed inspection (SDI) for discrepancies of each affected part installed at an affected position, and replacement of discrepant parts, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. This AD would also prohibit the installation of affected parts. The FAA is issuing this AD to address the unsafe condition on these products.
Airport Terminal Program; FY 2024 Funding Opportunity
The Department of Transportation (DOT), Federal Aviation Administration (FAA) announces the opportunity to apply for approximately $1 billion in FY 2024 discretionary funds for the Airport Terminal Program (ATP), made available under the Infrastructure Investment and Jobs Act of 2021 (IIJA), Public Law 117-58, herein referred to as the Bipartisan Infrastructure Law (BIL). The purpose of the ATP is to make annual grants available to eligible airports for airport terminal and airport-owned Airport Traffic Control Towers development projects that address the aging infrastructure of our nation's airports. In addition, ATP grants will align with DOT's Strategic Framework FY2022-2026 at https://www.transportation.gov/administrations/office- policy/fy2022-2026-strategic-frameworkhttps://www.transportat ion.gov/ administrations/office-policy/fy2022-2026-strategic-framework . The FY 2024 ATP will be implemented consistent with law and in alignment with the priorities in Executive Order 14052, Implementation of the Infrastructure Investments and Jobs Act (86 FR 64355), which are to invest efficiently and equitably; promote the competitiveness of the U.S. economy; improve job opportunities by focusing on high labor standards; strengthen infrastructure resilience to all hazards including climate change; and to effectively coordinate with State, local, Tribal, and territorial government partners.
Airworthiness Directives; General Electric Company Engines
The FAA is adopting a new airworthiness directive (AD) for certain General Electric Company (GE) Model CF6-80E1A2, CF6-80E1A3, CF6-80E1A4, and CF6-80E1A4/B engines. This AD was prompted by a manufacturer investigation that revealed that a certain forward outer seal and certain high-pressure turbine rotor (HPTR) stage 1 disks and rotating seals were manufactured from material suspected to contain iron inclusion, which may cause reduced material properties and a lower fatigue life capability. This AD requires the replacement of the affected forward outer seal, HPTR stage 1 disks, and rotating seals. The FAA is issuing this AD to address the unsafe condition on these products.
Notice of Withdrawal of the Record of Decision for the LaGuardia Airport Access Improvement Project
The FAA is withdrawing the July 2021 ROD for the Project. The Port Authority of New York and New Jersey has notified the FAA of its intent to terminate the Project and pursue alternative access improvements to LGA. Accordingly, the components identified in the LGA Access Improvement Project ROD are no longer needed at this time. Following the issuance of the ROD, New York Governor Kathy Hochul tasked the Port Authority of New York and New Jersey with reexamining alternative mass transit options to LGA. The resulting recommendations from the corresponding study identified improvements to an existing bus service and construction of a new non-stop airport shuttle service. On July 20, 2023, the Port Authority of New York and New Jersey, as the airport sponsor, notified the FAA of its intent to officially abandon the Project as approved by the FAA's ROD in favor of pursuing the recommended bus service and shuttle improvements. In response to this decision, the FAA has withdrawn the ROD for the LGA Access Improvement Project. Accordingly, all approvals for FAA actions within the ROD are also withdrawn. The Port Authority of New York and New Jersey must reinitiate any requests for FAA review and approval as necessary for all aspects of the Project contained within the now-withdrawn ROD should it wish to proceed with any component of the Project, in part or as a whole.
Airworthiness Directives; Deutsche Aircraft GmbH (Type Certificate Previously Held by 328 Support Services GmbH; AvCraft Aerospace GmbH; Fairchild Dornier GmbH; Dornier Luftfahrt GmbH) Airplanes
The FAA proposes to adopt a new airworthiness directive (AD) for all Deutsche Aircraft GmbH Model 328-100 and 328-300 airplanes. This proposed AD was prompted by a manufacturer's design review, which identified a potential risk of the rudder control rod buckling during operation with one engine inoperative during take-off and landing phases. This proposed AD would require visually inspecting the rudder control rod, performing a one-time functional check of the rudder control rod, performing corrective actions if necessary, and reporting the inspection results, as specified in a European Union Aviation Safety Agency (EASA) AD, which is proposed for incorporation by reference (IBR). This proposed AD would also limit the installation of affected parts under certain conditions. The FAA is proposing this AD to address the unsafe condition on these products.
Airworthiness Directives; Airbus Canada Limited Partnership (Type Certificate Previously Held by C Series Aircraft Limited Partnership (CSALP); Bombardier, Inc.) Airplanes
The FAA proposes to adopt a new airworthiness directive (AD) for certain Airbus Canada Limited Partnership Model BD-500-1A10 and BD- 500-1A11 airplanes. This proposed AD was prompted by damage found on two power-feeder harnesses due to chafing with wheel bins. An investigation found that the power-feeder harnesses were not adequately supported to protect from chafing due to vibration. This proposed AD would require modifying the variable frequency generator (VFG) power- feeder harness routing, as specified in a Transport Canada AD, which is proposed for incorporation by reference (IBR). The FAA is proposing this AD to address the unsafe condition on these products.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
