Federal Aviation Administration February 2023 – Federal Register Recent Federal Regulation Documents

Results 101 - 110 of 110
Standard Instrument Approach Procedures, and Takeoff Minimums and Obstacle Departure Procedures; Miscellaneous Amendments
Document Number: 2023-02177
Type: Rule
Date: 2023-02-02
Agency: Federal Aviation Administration, Department of Transportation
This rule establishes, amends, suspends, or removes Standard Instrument Approach Procedures (SIAPS) and associated Takeoff Minimums and Obstacle Departure procedures (ODPs) for operations at certain airports. These regulatory actions are needed because of the adoption of new or revised criteria, or because of changes occurring in the National Airspace System, such as the commissioning of new navigational facilities, adding new obstacles, or changing air traffic requirements. These changes are designed to provide safe and efficient use of the navigable airspace and to promote safe flight operations under instrument flight rules at the affected airports.
Airworthiness Directives; Bombardier, Inc., Airplanes
Document Number: 2023-02009
Type: Rule
Date: 2023-02-02
Agency: Federal Aviation Administration, Department of Transportation
The FAA is adopting a new airworthiness directive (AD) for certain Bombardier, Inc., Model BD-700-1A10 and BD-700-1A11 airplanes. This AD was prompted by reports that the thrust reverser correction factors presented in certain airplane flight manual (AFM) performance charts for landing on contaminated runways do not provide sufficient margin for stopping distances in certain conditions. This AD requires revising the existing AFM to correct the affected performance charts. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Airbus SAS Airplanes
Document Number: 2023-02007
Type: Rule
Date: 2023-02-02
Agency: Federal Aviation Administration, Department of Transportation
The FAA is adopting a new airworthiness directive (AD) for all Airbus SAS Model A330-200, A330-200 Freighter, A330-300, A330-800, A330-900, A340-200, and A340-300 series airplanes. This AD was prompted by a determination that certain landing gear parts have been manufactured with improper material or using a deviating manufacturing process. This AD requires replacing each affected part with a serviceable part, and for certain airplanes, re-assessing any previously repaired main landing gear (MLG) sliding piston, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. This AD also limits the installation of affected parts under certain conditions. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Learjet, Inc., Airplanes
Document Number: 2023-02006
Type: Rule
Date: 2023-02-02
Agency: Federal Aviation Administration, Department of Transportation
The FAA is adopting a new airworthiness directive (AD) for certain Learjet, Inc., Model 45 airplanes. This AD was prompted by a determination that new or more restrictive airworthiness limitations are necessary. This AD requires revising the existing inspection program to incorporate reduced inspection intervals for the anti-ice manifold assembly. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Bombardier, Inc., Airplanes
Document Number: 2023-00261
Type: Proposed Rule
Date: 2023-02-02
Agency: Federal Aviation Administration, Department of Transportation
The FAA proposes to adopt a new airworthiness directive (AD) for certain Bombardier, Inc., Model CL-600-2B16 (604 Variant) airplanes. This proposed AD was prompted by a determination that during certain modes, the flight guidance/autopilot does not account for engine failure while capturing an altitude. This proposed AD would require revising the existing airplane flight manual (AFM) to add new limitation and procedures. The FAA is proposing this AD to address the unsafe condition on these products.
Airworthiness Directives; Airbus Helicopters
Document Number: 2023-01965
Type: Rule
Date: 2023-02-01
Agency: Federal Aviation Administration, Department of Transportation
The FAA is adopting a new airworthiness directive (AD) for all Airbus Helicopters Model AS350B, AS350BA, AS350B1, AS350B2, AS350B3, AS350D, AS355E, AS355F, AS355F1, AS355F2, AS355N, and AS355NP helicopters. This AD was prompted by an occurrence reported where during an inspection of a tail rotor head (TRH) pitch change spider, excessive play and excessive wear were detected, due to an unwanted rotating motion. This AD requires for helicopters with certain part- numbered TRH spider pitch change units installed, inspecting for correct installation of the spider pitch change nut (nut); marking a 2 to 5 mm wide black paint index mark and repetitively inspecting the alignment of the marking; and additional inspections and corrective actions if necessary. This AD also allows an affected part to be installed on a helicopter if certain requirements of this AD are met. The FAA is issuing this AD to address the unsafe condition on these products.
Noise Compatibility Program for San Diego International Airport, San Diego County, California
Document Number: 2023-02019
Type: Notice
Date: 2023-02-01
Agency: Federal Aviation Administration, Department of Transportation
The Federal Aviation Administration (FAA) announces its findings on the noise compatibility program submitted by the San Diego County Regional Airport Authority. These findings are made in recognition of the description of Federal and nonfederal responsibilities. On September 1, 2022, the FAA determined that the noise exposure maps submitted by the San Diego County Regional Airport Authority were in compliance with applicable requirements. On January 11, 2023, the FAA approved the San Diego International Airport noise compatibility program. Most of the recommendations of the program were approved.
Approval of Teterboro Airport (TEB) Noise Compatibility Program; Correction
Document Number: 2023-02068
Type: Notice
Date: 2023-02-01
Agency: Federal Aviation Administration, Department of Transportation
The Federal Aviation Administration published a document in the Federal Register of January 17, 2023, notifying the public of the approval of the noise compatibility program at Teterboro Airport (TEB). The document contained references to an incorrect airport.
Agency Information Collection Activities: Requests for Comments; Clearance of a Renewed Approval of Information Collection: Bird/Other Wildlife Strike Report
Document Number: 2023-02014
Type: Notice
Date: 2023-02-01
Agency: Federal Aviation Administration, Department of Transportation
In accordance with the Paperwork Reduction Act of 1995, FAA invites public comments about our intention to request the Office of Management and Budget (OMB) approval to renew an information collection. The collection involves voluntary reporting of bird/other wildlife strike information following a wildlife strike incident with aircraft. This data becomes part of the publicly available National Wildlife Strike Database. Strike reports provide critical information that allows the FAA to determine high-risk species, track national trends, evaluate the FAA's wildlife hazard management program, and provide scientific foundation for regulatory guidance. Additionally, this essential information allows engine and airframe manufacturers to evaluate the effectiveness of aircraft components. It also helps airports identify and mitigate hazardous species and the location of wildlife attractants, affords a better understanding of strike dynamics, and provides key metrics for an airport to evaluate the effectiveness of its wildlife management program.
Airworthiness Directives; Airbus SAS Airplanes
Document Number: 2023-02010
Type: Rule
Date: 2023-02-01
Agency: Federal Aviation Administration, Department of Transportation
The FAA is adopting a new airworthiness directive (AD) for all Airbus SAS Model A318 series airplanes; Model A319-111, -112, -113, - 114, -115, -131, -132, and -133 airplanes; Model A320-211, -212, -214, -216, -231, -232, and -233 airplanes; and Model A321-111, -112, -131, - 211, -212, -213, -231, and -232 airplanes. This AD was prompted by a report of a nose landing gear (NLG) sliding tube rupture that led to a NLG collapse. This AD requires inspection of certain NLG and main landing gear (MLG) sliding tubes and applicable corrective actions and eventual replacement of all affected parts, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference (IBR). This AD also prohibits the installation of affected parts under certain conditions. The FAA is issuing this AD to address the unsafe condition on these products.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.