Federal Aviation Administration June 15, 2021 – Federal Register Recent Federal Regulation Documents

The FAA is adopting a new airworthiness directive (AD) for all GE Aviation Czech s.r.o. (GEAC) M601D-11, M601E-11, M601E-11A, M601E- 11AS, M601E-11S, and M601F model turboprop engines. This AD was prompted by the manufacturer finding errors in the Airworthiness Limitation Section (ALS) of the Engine Maintenance Manual (EMM), including errors in the formula to determine the equivalent flight cycles (FCs) of critical parts and errors with certain part numbers (P/ Ns). The manufacturer also determined that the life limit of a certain compressor case is not listed in the ALS section of the applicable EMM. This AD requires recalculating the life of critical parts and, depending on the results of the recalculation, replacement of these critical parts. This AD also requires replacement of a certain compressor case. The FAA is issuing this AD to address the unsafe condition on these products.

The FAA is adopting a new airworthiness directive (AD) for Airbus Helicopters Model AS-365N2, AS 365 N3, SA-365N, and SA-365N1 helicopters. This AD requires replacing the main gearbox (MGB), or as an alternative, replacing the epicyclic reduction gear module for certain serial numbered planet gear assemblies installed on the MGB. This AD also requires inspecting the MGB magnetic plugs and oil filter for particles. Depending on the outcome of the inspections, this AD requires further inspections and replacing certain parts. This AD was prompted by failure of an MGB second stage planet gear. The FAA is issuing this AD to correct an unsafe condition on these products.

The FAA is adopting a new airworthiness directive (AD) for certain De Havilland Aircraft of Canada Limited Model DHC-8-400 series airplanes. This AD was prompted by a report that a number of nacelle A- frames were not manufactured in accordance with engineering drawings. This AD requires, depending on airplane configuration, removing the fasteners on the nacelle A-frame side brace sub-assemblies, doing an eddy current inspection for cracking, cold-working the holes, installing oversize fasteners, re-identifying the reworked side brace fitting and A-frame, and repair if necessary. The FAA is issuing this AD to address the unsafe condition on these products.