Federal Aviation Administration June 1, 2021 – Federal Register Recent Federal Regulation Documents
Results 1 - 9 of 9
Notice of Intent To Release Certain Properties From All Terms, Conditions, Reservations and Restrictions of a Quitclaim Deed Agreement Between City of Tallahassee and the Federal Aviation Administration for the Tallahassee International Airport, Tallahassee, FL
The FAA hereby provides notice of intent to release certain airport properties 44.66 acres at the Tallahassee International Airport, Tallahassee, FL from the conditions, reservations, and restrictions as contained in a Quitclaim Deed agreement between the FAA and the City of Tallahassee, dated March 14, 1990. The release of property will allow the City of Tallahassee to dispose of the property for non-aeronautical purposes. The City of Tallahassee requests the release of a 44.66 acre tract located along Capital Circle SW in Tallahassee, Florida to facilitate the widening of State Road 263 for municipal development. This capital improvement project is funded by the Florida Department of Transportation. The parcel is currently designated as aeronautical property. The property will be released of its federal obligations given the land is no longer required by The City of Tallahassee. The Fair Market Value (FMV) of this parcel has been determined to be $2,020,050.00. Documents reflecting the Sponsor's request are available, by appointment only, for inspection at the Tallahassee International Airport and the FAA Airports District Office.
Airworthiness Directives; Airbus SAS Airplanes
The FAA is adopting a new airworthiness directive (AD) for certain Airbus SAS Model A319-111, -112, -113, -114, -115, -131, -132, and -133 airplanes. This AD was prompted by a determination that the cabin swift broadband antenna doubler installation does not meet widespread fatigue damage (WFD) requirements. This AD requires a one- time special detailed inspection of certain fastener holes, replacement of the cabin swift broadband antenna doubler, and repair if necessary, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Bombardier, Inc., Airplanes
The FAA is adopting a new airworthiness directive (AD) for certain Bombardier, Inc., Model BD-700-1A10 airplanes. This AD was prompted by a report indicating that during installation, a fuel pipe bracket assembly on the intermediate rib in the center fuel tank was mislocated, resulting in an offset between the fitting assembly and the refuel/defuel tube assembly. This AD requires modification of the fuel pipe bracket assembly, including all related investigative actions and corrective actions, if necessary; and performing an operational test of the refuel and defuel system. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Bombardier, Inc., Airplanes
The FAA is adopting a new airworthiness directive (AD) for certain Bombardier, Inc., Model BD-100-1A10 airplanes. This AD was prompted by reports of DC motor pump (DCMP) failures during production flight tests. This AD requires installing a redesigned DCMP electric motor assembly. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Airbus Helicopters
The FAA is adopting a new airworthiness directive (AD) for certain Airbus Helicopters Model EC130B4 and EC130T2 helicopters. This AD was prompted by a report of cracks and geometrical non-conformities of the tail rotor blades (TRBs); all cracks initiated in the drain hole area at the blade root section. This AD requires cleaning affected parts, visual and dye penetrant inspections for cracks of affected parts, a dimensional inspection to verify conformity of affected parts, and corrective actions if necessary, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Airbus Helicopters Deutschland GmbH (AHD) Helicopters
The FAA is adopting a new airworthiness directive (AD) for Airbus Helicopters Deutschland GmbH (AHD) Model MBB-BK 117 D-2 helicopters. This AD was prompted by a report of a broken Titanium (Ti) bolt. This AD requires removing certain Ti-bolts from service and prohibits installing these Ti-bolts in a critical area. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Airbus Helicopters Deutschland GmbH Helicopters
The FAA is adopting a new airworthiness directive (AD) for certain Airbus Helicopters Deutschland GmbH Model MBB-BK117 D-2 helicopters. This AD was prompted by reports that collective lever switch units having certain part numbers did not have retaining rings installed in the cable cut switch guard. This AD requires inspecting certain collective lever switch units for discrepancies (missing retaining rings, incorrectly installed retaining rings, and a missing axis in the cable cut switch guard), doing all applicable corrective actions, and marking affected parts, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Airbus Helicopters
The FAA proposes to supersede Airworthiness Directive (AD) 2016-12-51, which applies to all Airbus Helicopters Model AS332L2 and Model EC225LP helicopters. AD 2016-12-51 prohibits all further flight of Model AS332L2 and Model EC225LP helicopters. AD 2016-12-51 was prompted by an accident in which the main rotor hub detached from the main gearbox (MGB). Since the FAA issued AD 2016-12-51, the design approval holder has developed procedures that address failure of the main rotor system. This proposed AD would require replacing certain second stage planet gear assemblies, removing certain epicyclic modules, installing a full flow magnetic plug (FFMP), revising the existing rotorcraft flight manual (RFM) for your helicopter, repetitively inspecting the MGB particle detectors, repetitively inspecting the MGB oil filter and oil cooler, and corrective action if necessary, as specified in a European Union Aviation Safety Agency (EASA) AD, which is proposed for incorporation by reference (IBR). The actions specified in the proposed AD would terminate the flight prohibition. The FAA is proposing this AD to address the unsafe condition on these products.
Airworthiness Directives; Airbus Helicopters Deutschland GmbH Helicopters
The FAA proposes to adopt a new airworthiness directive (AD) for certain Airbus Helicopters Deutschland GmbH Model EC135P1, EC135P2, EC135P2+, EC135P3, EC135T1, EC135T2, EC135T2+, and EC135T3 helicopters. This proposed AD was prompted by a report that geometrical non- conformities were found in the root section of the tail rotor blade (TRB). This proposed AD would require a one-time inspection (dimensional check) of the TRB for conformity and, depending on the findings, replacement of certain affected parts, as specified in a European Union Aviation Safety Agency (EASA) AD, which is proposed for incorporation by reference (IBR). This proposed AD would also prohibit rework, repair, or modification of affected parts in the affected area of the TRB assembly root. The FAA is proposing this AD to address the unsafe condition on these products.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
