Federal Aviation Administration March 12, 2020 – Federal Register Recent Federal Regulation Documents
Results 1 - 5 of 5
Airworthiness Directives; Robinson Helicopter Company Helicopters
The FAA is adopting a new airworthiness directive (AD) for Robinson Helicopter Company Model R44 and R44 II helicopters with an agricultural spray system installed by Supplemental Type Certificate (STC) SR00286BO (spray system). This spray system is also known as a Simplex Manufacturing Company (Simplex) Model 244 spray system. This AD was prompted by a report of an in-flight failure of the spray system elbow pump fitting (pump fitting). This AD requires repetitive inspections of the spray system pump fitting, corrective action if necessary, replacement of the spray system pump fitting, and installation of hose supports and a pump outlet cover. The FAA is issuing this AD to address the unsafe condition on these products.
Proposed Establishment of Class E Airspace; Wiggins, MS
This action proposes to establish Class E airspace extending upward from 700 feet above the surface at Dean Griffin Memorial Airport, Wiggins, MS. Controlled airspace is necessary to accommodate new standard instrument approach procedures developed at Dean Griffin Memorial Airport, for the safety and management of instrument flight rules (IFR) operations.
Airworthiness Directives; Airbus SAS Airplanes
The FAA is adopting a new airworthiness directive (AD) for all Airbus SAS Model A330-941 airplanes. This AD was prompted by reports indicating premature aging of certain chemical oxygen generators. This AD requires repetitively removing the affected chemical oxygen generators and replacing them with serviceable parts, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; CFM International, S.A., Turbofan Engines
The FAA is adopting a new airworthiness directive (AD) for all CFM International S.A. (CFM) LEAP-1B21, -1B23, -1B25, -1B27, -1B28, - 1B28B1, -1B28B2, -1B28B2C, -1B28B3, -1B28BBJ1, and -1B28BBJ2 model turbofan engines. This AD was prompted by reports of two new unsafe conditions and the need to supersede corrective actions for two previously addressed unsafe conditions. This AD supersedes AD 2018-25- 09 and AD 2019-12-01, which apply to the affected LEAP-1B model turbofan engines. This AD requires revising the Airworthiness Limitations Section (ALS) of the applicable CFM LEAP-1B Engine Shop Manual and the operator's approved continuous airworthiness maintenance program. The FAA is issuing this AD to address the unsafe conditions on these products.
Airworthiness Directives; De Havilland Aircraft of Canada Limited (Type Certificate Previously Held by Bombardier, Inc.) Airplanes
The FAA proposes to supersede Airworthiness Directive (AD) 2010-23-04, which applies to all De Havilland Aircraft of Canada Limited Model DHC-8-400 series airplanes. AD 2010-23-04 requires repetitive detailed inspections of the nacelle attachment fittings for cracks, a conductivity inspection of the nacelle attachment fittings, and replacement if necessary. Since AD 2010-23-04 was issued, the FAA has determined that it is necessary to do a replacement with new nacelle attachment fittings. This proposed AD would retain the requirements of AD 2010-23-04, remove a certain inspection requirement for certain airplanes, and add a new requirement to replace the rear spar fitting and nacelle attaching structure with a new nacelle attachment fitting. The FAA is proposing this AD to address the unsafe condition on these products.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
