Federal Aviation Administration December 17, 2019 – Federal Register Recent Federal Regulation Documents

This action proposes to amend the Class E airspace area, designated as a surface area, at Astoria Regional Airport, Astoria, OR by reducing the size of the Class E surface airspace. Also, this action proposes to amend the Class E airspace by adding two Class E airspace areas, designated as an extension to a Class D or Class E surface area, at the airport. Additionally, this action proposes to amend the Class E airspace areas extending upward from 700 feet or more above the surface of the earth, by reducing the dimensions of the area and sizing it to properly contain IFR arrivals and departures. Further, this action proposes to make several administrative corrections to the airport's legal descriptions. This action would ensure the safety and management of IFR operations at the airport.

The FAA proposes to adopt a new airworthiness directive (AD) for certain Embraer S.A. Model ERJ 190-100 STD, -100 LR, -100 ECJ, -100 IGW, -200 STD, -200 LR, and -200 IGW airplanes. This proposed AD was prompted by a report of erroneous indications of certain engine parameters and reports of ``pitch up'' and ``pitch down'' uncommanded attitudes with autopilot engaged in cruise flight. This proposed AD would require installing updated PRIMUS EPIC LOAD software, as specified in an Ag[ecirc]ncia Nacional de Avia[ccedil][atilde]o Civil (ANAC) Brazilian AD, which will be incorporated by reference. The FAA is proposing this AD to address the unsafe condition on these products.

The FAA proposes to supersede Airworthiness Directive (AD) 2018-16-05, which applies to all The Boeing Company Model 757-200, - 200PF, -200CB, and -300 series airplanes. AD 2018-16-05 requires repetitive inspections for skin cracking and shim migration at the upper link drag fittings, diagonal brace cracking, and fastener looseness; and applicable on-condition actions. Since the FAA issued AD 2018-16-05, an operator reported finding multiple cracks in the drag fitting at fastener holes while inspecting for cracking as required by AD 2018-16-05. This proposed AD would retain the actions required by AD 2018-16-05, reduce the compliance times for certain inspections, and add repetitive inspections at certain fastener hole locations and applicable on-condition actions. The FAA is proposing this AD to address the unsafe condition on these products.