Federal Aviation Administration June 10, 2016 – Federal Register Recent Federal Regulation Documents

We are superseding Airworthiness Directive (AD) 2011-17-10, for all Fokker Services B.V. Model F.28 Mark 1000, 2000, 3000, and 4000 airplanes. AD 2011-17-10 required inspecting for a by-pass wire between the housing of each in-tank fuel quantity indication (FQI) cable plug and the cable shield, and corrective actions if necessary. AD 2011-17- 10 also required revising the airplane maintenance program. This new AD removes certain airplanes from the applicability. This new AD applies only to Model F.28 Mark 1000 airplanes and also requires revising the airplane maintenance or inspection program by incorporating the instructions in revised service information. This AD was prompted by the issuance of revised service information to update the critical design configuration control limitations (CDCCLs) that address potential ignition sources inside fuel tanks. We are issuing this AD to prevent potential ignition sources inside the fuel tanks, which, in combination with flammable fuel vapors, could result in fuel tank explosions and consequent loss of the airplane.

We are adopting a new airworthiness directive (AD) for PILATUS AIRCRAFT LTD. Models PC-12, PC-12/45, PC-12/47, and PC-12/47E airplanes. This AD results from mandatory continuing airworthiness information (MCAI) issued by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as incorrect installation instructions of the torlon plates in the airplane maintenance manual resulting in the incorrect installation of the torlon plates in the forward wing-to-fuselage attachment. We are issuing this AD to require actions to address the unsafe condition on these products.

We are superseding Airworthiness Directive (AD) 99-16-01 for certain Airbus Model A300 B4-600, B4-600R, and F4-600R series airplanes, and Model A300 C4-605R Variant F airplanes (collectively called Model A300-600 series airplanes). AD 99-16-01 required repetitive inspections of certain bolt holes where parts of the main landing gear (MLG) are attached to the wing rear spar, and repair if necessary. Since we issued AD 99-16-01, we have determined that the risk of cracking in the wing rear spar is higher than initially determined. This new AD adds airplanes to the applicability, reduces the compliance times and repetitive intervals for the inspections, and changes the inspection procedures. This AD was prompted by a determination that the risk of cracking in the wing rear spar is higher than initially determined. We are issuing this AD to detect and correct cracking of the rear spar of the wing, which could result in reduced structural integrity of the airplane.