Federal Aviation Administration June 10, 2014 – Federal Register Recent Federal Regulation Documents

This action proposes special conditions for the Embraer S.A. Model EMB-550 airplane. This airplane will have a novel or unusual design feature when compared to the state of technology and design envisioned in the airworthiness standards for transport category airplanes. This design feature is a high incidence protection system that limits the angle of attack at which the airplane can be flown during normal low speed operation. The applicable airworthiness regulations do not contain adequate or appropriate safety standards for this design feature. These proposed special conditions contain the additional safety standards that the Administrator considers necessary to establish a level of safety equivalent to that established by the existing airworthiness standards.

The FAA will hold a public meeting to discuss its proposal to consider the impact of one engine inoperative procedures during aeronautical studies. This proposal was published in the Federal Register on April 28, 2014. During the meeting, the FAA will explain the proposal and respond to questions seeking clarification of the proposed policy. In addition, the FAA is extending the time period for which the public may submit written comments for an additional 30 days.

We are publishing a new airworthiness directive (AD) for certain Airbus Helicopters (previously Eurocopter France) Model AS350B, AS350BA, AS350B1, AS350B2, AS350B3, AS350C, AS350D, AS350D1, AS355E, AS355F, AS355F1, AS355F2, AS355N, and AS355NP helicopters, which was sent previously to all known U.S. owners and operators of these helicopters. This AD requires repetitively inspecting certain reinforcement angles of the rear structure to tailboom junction frame (reinforcement angles) for a crack, and repairing any cracked reinforcement angle. This AD is prompted by a report that cracks were found in the reinforcement angles on several AS355 helicopters. These actions are intended to detect a crack in the reinforcement angle, which if not corrected, could result in loss of the tailboom and subsequent loss of control of the helicopter.

We are adopting a new airworthiness directive (AD) for certain Airbus Model A330-200, A330-200 Freighter, and A330-300 series airplanes; and Model A340-200, A340-300, A340-500, and A340-600 series airplanes. This AD was prompted by a non-connection of the constant speed motor/generator (CSM/G) during a final assembly operational test. This AD requires a detailed inspection of the connector wires for connector 1XE-A of the generator control unit (GCU)-CSM/ G for discrepancies (evidence of arcing or overheating damage), and related investigative and corrective actions if necessary. We are issuing this AD to detect and correct incorrect locking of contacts into connector 1XE-A of the GCU-CSM/G, which could result in a loss of contact continuity and lead to the CSM/G not operating, which, in conjunction with an emergency electrical configuration loss of the main electrical system or total engine flameout, could adversely affect the airplane's safe flight.