Federal Aviation Administration February 27, 2009 – Federal Register Recent Federal Regulation Documents

We are adopting a new airworthiness directive (AD) to supersede AD 2008-06-28 R1, which applies to certain Avidyne Corporation (Avidyne) Primary Flight Displays (PFDs) (part numbers (P/Ns) 700-00006-000, -001, -002, -003, and -100) that are installed on airplanes. AD 2008-06-28 R1 currently requires you to do a check of the maintenance records and inspection of the PFD (if necessary) to determine if an affected serial number PFD is installed and incorporate (if necessary) operational limitations. Since we issued AD 2008-06-28 R1, Avidyne developed a factory modification that will correct the problems on these Avidyne PFDs and also factory modified certain serial number PFDs. To terminate the operational limitations of AD 2008-06-28 R1, this AD adds actions to assure any affected serial number PFD complies with one of the following: Passes the air data system performance verification test, receives the factory modification, or is replaced with a PFD that has complied with one of the previous two conditions or is not one of the affected serial number PFDs. Consequently, this AD will retain the actions from the previous AD until the added terminating action has been complied with. We are issuing this AD to prevent certain conditions from existing when PFDs display incorrect attitude, altitude, and airspeed information. This could result in airspeed/altitude mismanagement or spatial disorientation of the pilot with consequent loss of airplane control, inadequate traffic separation, or controlled flight into terrain.

We are adopting a new airworthiness directive (AD) for certain Boeing Model 727 airplanes. This AD requires among other actions, installing new ground fault interrupter (GFI) relays for the main fuel tanks and the auxiliary fuel tank pumps. This AD also requires revising the FAA-approved maintenance program to incorporate new Airworthiness Limitations for the GFI of the boost pumps and for the uncommanded on system for the auxiliary fuel tank pumps. This AD results from fuel system reviews conducted by the manufacturer. We are issuing this AD to prevent an electrical fault in the fuel pump system, which might cause a connector or end cap to burn through and a subsequent fire or explosion inside the fuel pump or wing spar area. We are also issuing this AD to prevent uncommanded operation of the auxiliary fuel tank pumps, which can cause them to run dry. This condition will increase pump temperature and could supply an ignition source to fumes in the fuel tank, which can result in a consequent fire or explosion.

The FAA is adopting a new airworthiness directive (AD) for certain Bombardier Model CL-215-6B11 (CL-215T variant) and CL-215-6B11 (CL-415 variant) airplanes. This AD requires repetitive inspections for contamination of grease, bearing wear checks, grease applications of the rudder lower torque tube upper bearing, and a rudder upper hinge gap check; and related investigative and corrective actions if necessary. This AD results from a report of corrosion on the rudder lower torque tube upper bearing. We are issuing this AD to detect and correct corroded bearings which could lead to hinge deformation, and could result in a rudder jam and consequent reduced controllability of the airplane.