Federal Aviation Administration November 29, 2007 – Federal Register Recent Federal Regulation Documents

This amendment adopts miscellaneous amendments to the required IFR (instrument flight rules) altitudes and changeover points for certain Federal airways, jet routes, or direct routes for which a minimum or maximum en route authorized IFR altitude is prescribed. This regulatory action is needed because of changes occurring in the National Airspace System. These changes are designed to provide for the safe and efficient use of the navigable airspace under instrument conditions in the affected areas.

This action proposes to modify the Class E airspace area at Hollister, CA. Establishment of an Area Navigation (RNAV) Global Positioning System (GPS) Standard Instrument Approach Procedure (SIAP) at Hollister Municipal Airport, Hollister, CA, has made this proposal necessary. Additional controlled airspace is needed for the safety and management of aircraft executing the new RNAV (GPS) SIAPs at Hollister Municipal Airport, Hollister, CA.

The FAA is adopting a new airworthiness directive (AD) for certain Cirrus Design Corporation (Cirrus) Model SR22 airplanes. This AD requires you to install a drain hole in the left and right outboard wing tips. This AD results from reports of pilots' inability to move the aileron control without using excessive force when flying in freezing conditions. Moisture from a prior rain shower entered through a gap at the interface of the left and right outboard wing tips and wing structure. The moisture traveled along the aft wing shear web, accumulated below the aileron control pulley, and froze at an altitude with an outside air temperature below freezing. When this moisture is exposed to freezing conditions, operation of the aileron control pulley is impaired. We are issuing this AD to prevent moisture from accumulating along the wing shear web where it may freeze in certain conditions. This condition could result in operational failure of the aileron control pulley, which could lead to loss of control.

The FAA is superseding an existing airworthiness directive (AD) for Rolls-Royce plc (RR) RB211 Trent 768-60, 772-60, and 772B-60 turbofan engines. That AD currently requires initial and repetitive on- wing or in-shop inspections of the high pressure/intermediate pressure (HP/IP) turbine bearing oil feed tube heat shield. This AD requires the same actions but introduces a terminating action to the repetitive inspections. This AD results from RR introducing a revised HP/IP turbine bearing support structure as terminating action to the repetitive inspections of the HP/IP turbine bearing oil feed tube heat shield. We are issuing this AD to prevent an uncontained failure of the HP turbine disc and damage to the airplane.

The Federal Aviation Administration (FAA) announces its findings on the noise compatibility program submitted by the Greater Baton Rouge Airport District under the provisions of 49 U.S.C. (the Aviation Safety and Noise Abatement Act, hereinafter referred to as ``the Act'') and 14 CFR part 150. These findings are made in recognition of the description of Federal and nonfederal responsibilities in Senate Report No. 96-52 (1980). On July 30, 2007, the FAA determined that the noise exposure maps submitted by the Greater Baton Rouge Airport District under part 150 were in compliance with applicable requirements. On November 13, 2007, the FAA approved the Baton Rouge Metropolitan Airport, Ryan Field noise compatibility program. Most of the recommendations of the program were approved. No program elements relating to new or revised flight procedures for noise abatement were proposed by the airport operator.