Federal Aviation Administration December 8, 2005 – Federal Register Recent Federal Regulation Documents

Standardization and Clarification of Application of 14 CFR Part 23, Sections 23.1301 and 23.1309, Regarding Environmental Qualification
Document Number: E5-7022
Type: Notice
Date: 2005-12-08
Agency: Federal Aviation Administration, Department of Transportation
This notice announces a Federal Aviation Administration (FAA) proposed policy that clarifies and standardizes the application of the subject sections on environmental qualification. This notice advises the public, especially manufacturers of normal, utility, and acrobatic category airplanes, and commuter category airplanes and their suppliers, that the FAA intends to adopt this policy. This notice is necessary to advise the public of this FAA policy and give all interested persons an opportunity to present their views on it.
Airworthiness Directives; BAE Systems (Operations) Limited Model BAe 146 Airplanes and Model Avro 146-RJ Airplanes
Document Number: 05-23778
Type: Proposed Rule
Date: 2005-12-08
Agency: Federal Aviation Administration, Department of Transportation
The FAA proposes to adopt a new airworthiness directive (AD) for all BAE Systems (Operations) Limited Model BAe 146 airplanes and Model Avro 146-RJ airplanes. This proposed AD would require repetitive replacement of the elevator servo tab hinge bearings, elevator servo tab mechanism bearings, elevator trim tab hinge bearings, and elevator trim tab drive rod bearings with new bearings. This proposed AD results from reported incidents of flight control surface restrictions due to the deterioration of flight control surface bearings. We are proposing this AD to prevent corrosion of flight control surface bearings and freezing of moisture inside the bearings, due to loss of lubrication in the bearings, which could lead to flight control restrictions and result in reduced controllability of the airplane.
Airworthiness Directives; Boeing Model 757 Series Airplanes
Document Number: 05-23777
Type: Proposed Rule
Date: 2005-12-08
Agency: Federal Aviation Administration, Department of Transportation
The FAA proposes to supersede an existing airworthiness directive (AD) that applies to certain Boeing Model 757 series airplanes. The existing AD currently requires revising the Airworthiness Limitations Section of the maintenance manual (757 Airworthiness Limitations Instructions (ALI)) to incorporate certain inspections and compliance times to detect fatigue cracking of principal structural elements (PSEs). This proposed AD would require incorporating a new revision to the Airworthiness Limitations section of the Instructions of Continued Airworthiness to mandate certain repetitive inspections for fatigue cracking of PSEs. This proposed AD also would add airplanes to the applicability in the existing AD. This proposed AD results from a new revision to the ALI. We are proposing this AD to ensure that fatigue cracking of various PSEs is detected and corrected; such fatigue cracking could adversely affect the structural integrity of these airplanes.
Airworthiness Directives; BAE Systems (Operations) Limited Model BAe 146 and Avro 146-RJ Airplanes
Document Number: 05-23776
Type: Proposed Rule
Date: 2005-12-08
Agency: Federal Aviation Administration, Department of Transportation
This document revises an earlier proposed airworthiness directive (AD), applicable to all BAE Systems (Operations) Limited Model BAe 146 and Avro 146-RJ airplanes, that would have required installation of a linear fluid-filled damper between each elevator surface and the airplane structure on both the left and right sides of the airplane, along with related structural and system modifications. This new action revises the proposed rule by updating and adding service information, and changing the compliance time. The actions specified by this new proposed AD are intended to prevent pitch oscillation (vertical bouncing) of the fuselage due to excessive ice buildup on the elevator servo tab, and consequent reduced controllability of the airplane. This action is intended to address the identified unsafe condition.
Airworthiness Directives; Cirrus Design Corporation Model SR20 and SR22 Airplanes
Document Number: 05-23772
Type: Proposed Rule
Date: 2005-12-08
Agency: Federal Aviation Administration, Department of Transportation
The FAA proposes to adopt a new airworthiness directive (AD) for certain Cirrus Design Corporation (CDC) Model SR20 and SR22 airplanes. This proposed AD would require you to inspect the fuel line and wire bundles for any chafing damage; if any chafing damage is found, replace any damaged fuel line and repair any damaged wires or sheathing of the wire harness; and install the forward loop clamp, fuel line shield, aft loop clamp, and anti-chafe tubing. This proposed AD results from reports of fuel line leaks resulting from wire chafing on the fuel lines. We are issuing this proposed AD to detect and correct damage to the fuel line and wire bundles, which could result in fuel leaks. This failure could lead to unsafe fuel vapor within the cockpit and possible fire.
Airworthiness Directives; Hamilton Sundstrand Model 14RF-19 Propellers
Document Number: 05-23770
Type: Proposed Rule
Date: 2005-12-08
Agency: Federal Aviation Administration, Department of Transportation
The FAA proposes to adopt a new airworthiness directive (AD) for Hamilton Sundstrand (formerly Hamilton Standard Division of United Technologies Corporation) Model 14RF-19 propellers. This proposed AD would require replacing certain actuator yokes with improved actuator yokes. This proposed AD results from certain propeller system actuator yoke arms breaking during flight. We are proposing this AD to prevent actuator yoke arms breaking during flight, which could cause high propeller vibration, requiring the pilot to feather the propeller, and could contribute to reduced controllability of the airplane.
Proposed Amendments to Colored Federal Airways; AK
Document Number: 05-23759
Type: Proposed Rule
Date: 2005-12-08
Agency: Federal Aviation Administration, Department of Transportation
This action proposes to revoke colored Federal Airway B-12, modify three colored Federal Airways B-4, R-50 and G-7, and establish colored Federal Airway R-4 in Alaska. These amendments would remove all airways and routes off the Bishop, AK, Nondirectional Radio Beacon (NDB) in preparation for the NDB's eventual decommissioning from the National Airspace System (NAS).
Amendment to Jet Route J-158; ID
Document Number: 05-23758
Type: Rule
Date: 2005-12-08
Agency: Federal Aviation Administration, Department of Transportation
This action revises a segment of Jet Route J-158 between the Malad City, ID, Very High Frequency Omni-directional Range/Distance Measuring Equipment (VOR/DME) and the Muddy Mountain, WY, Very High Frequency Omni-directional Range/Tactical Air Navigation (VORTAC). Specifically, the FAA is realigning the route from Malad City, ID, to Big Piney, WY, VOR/DME to Muddy Mountain, WY. This action replaces an airway segment taken out of service, reduces controller workload, and enhances the National Airspace System.
Proposed Modification of Offshore Airspace Areas: Gulf of Alaska Low and Control 1487L; AK
Document Number: 05-23757
Type: Proposed Rule
Date: 2005-12-08
Agency: Federal Aviation Administration, Department of Transportation
This action proposes to amend the Gulf of Alaska Low and Control 1487L Offshore airspace areas in Alaska. Specifically, this action proposes to modify the Gulf of Alaska Low and Control 1487L airspace areas in the vicinity of the Yakutat Airport, Yakutat, AK, by lowering the affected controlled airspace floor to 700 feet mean sea level (MSL) for the Gulf of Alaska Low, and 1,200 feet MSL for Control 1487L. The FAA is proposing this action to provide additional controlled airspace for the safety of aircraft executing instrument flight rules (IFR) operations at the Yakutat Airport.
Established Class D Airspace; Front Range Airport, Denver, CO
Document Number: 05-23756
Type: Rule
Date: 2005-12-08
Agency: Federal Aviation Administration, Department of Transportation
This action corrects an error in the altitude description of a final rule that was published in the Federal Register on June 28, 2005, (70 FR 37028), Airspace Docket No. 05-AWP-1.
Airworthiness Directives; Empresa Brasileira de Aeronautica S.A. (EMBRAER) Model EMB-135BJ, -135ER, -135KE, -135KL, -135LR, -145, -145ER, -145MR, -145LR, -145XR, -145MP, and -145EP Airplanes
Document Number: 05-23656
Type: Rule
Date: 2005-12-08
Agency: Federal Aviation Administration, Department of Transportation
The FAA is adopting a new airworthiness directive (AD) for all EMBRAER Model EMB-135BJ, -135ER, -135KE, -135KL, -135LR, -145, -145ER, -145MR, -145LR, -145XR, -145MP, and -145EP airplanes. This AD requires reviewing the airplane maintenance records for recent reports of vibration from the tail section or rudder pedals. This AD also requires repetitively inspecting the skin, attachment fittings, and control rods of rudder II to detect cracking, loose parts, wear, or damage; and related investigative/corrective actions if necessary. This AD results from reports of rudder vibration due to wear. We are issuing this AD to prevent failure of multiple hinge fittings, which could result in severe vibration, and to prevent failure of the rudder control rods, which could result in jamming of the rudder II; and possible structural failure and reduced controllability of the airplane.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.