Department of Transportation May 9, 2024 – Federal Register Recent Federal Regulation Documents
Results 1 - 9 of 9
Commercial Driver's License Standards: Application for Exemption; Pitt Ohio Express, LLC
FMCSA announces its denial of the application from Pitt Ohio Express, LLC (Pitt Ohio) to exempt its drivers from one of the requirements in the Agency's Safe Driver Apprenticeship Pilot (SDAP) program. Pitt Ohio requests an exemption allowing it to use drivers under the age 21, who hold a Commercial Learner's Permit (CLP) to operate commercial motor vehicles (CMVs) in interstate commerce, to participate in the SDAP program. FMCSA analyzed the application and determined that there is insufficient basis to conclude that the exemption would likely achieve a level of safety that is equivalent to, or greater than, the level that would be achieved absent such exemption.
Special Conditions: The Boeing Model 737-8 Airplane; Dynamic Test Requirements for Single-Occupant Oblique Seats With 3-Point Seat Belt With Pretensioner
These special conditions are issued for The Boeing Company (Boeing) Model 737-8 series airplane. This airplane, as modified by HAECO Cabin Solutions, LLC. (HAECO), will have a novel or unusual design feature when compared to the state of technology envisioned in the airworthiness standards for transport-category airplanes. This design feature is single-occupant oblique (side-facing) seats equipped with a 3-point seat belt with pretensioner. The applicable airworthiness regulations do not contain adequate or appropriate safety standards for this design feature. These special conditions contain the additional safety standards that the Administrator considers necessary to establish a level of safety equivalent to that established by the existing airworthiness standards.
Agency Information Collection Activities: Request for Comments for a New Information Collection
The FHWA invites public comments about our intention to request the Office of Management and Budget's (OMB) approval for a new information collection, which is summarized below under SUPPLEMENTARY INFORMATION. We are required to publish this notice in the Federal Register by the Paperwork Reduction Act of 1995.
Agency Information Collection Activities: Request for Comments for a New Information Collection
The FHWA invites public comments about our intention to request the Office of Management and Budget's (OMB) approval for a new information collection, which is summarized below under SUPPLEMENTARY INFORMATION. We are required to publish this notice in the Federal Register by the Paperwork Reduction Act of 1995.
Hazardous Materials: Harmonization With International Standards; Correction
The Pipeline and Hazardous Materials Safety Administration is correcting a final rule that was published in the Federal Register on April 10, 2024. The final rule was published to maintain alignment with international regulations and standards by adopting various amendments, including changes to proper shipping names, hazard classes, packing groups, special provisions, packaging authorizations, air transport quantity limitations, and vessel stowage requirements. The corrections address several errors to the hazardous material entries in the hazardous materials table.
Federal Motor Vehicle Safety Standards; Automatic Emergency Braking Systems for Light Vehicles
This final rule adopts a new Federal Motor Vehicle Safety Standard to require automatic emergency braking (AEB), including pedestrian AEB (PAEB), systems on light vehicles. An AEB system uses various sensor technologies and sub-systems that work together to detect when the vehicle is in a crash imminent situation, to automatically apply the vehicle brakes if the driver has not done so, or to apply more braking force to supplement the driver's braking. This final rule specifies that an AEB system must detect and react to an imminent crash with both a lead vehicle or a pedestrian. This final rule fulfills a mandate under the Bipartisan Infrastructure Law (BIL) directing the Department to promulgate a rule to require that all passenger vehicles be equipped with an AEB system. The purpose of this final rule is to reduce the number of deaths and injuries that result from crashes in which drivers do not apply the brakes or fail to apply sufficient braking power to avoid or mitigate a crash, and to reduce the consequences of such crashes.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
