Department of Transportation February 24, 2023 – Federal Register Recent Federal Regulation Documents

This rule establishes, amends, suspends, or removes Standard Instrument Approach Procedures (SIAPS) and associated Takeoff Minimums and Obstacle Departure procedures (ODPs) for operations at certain airports. These regulatory actions are needed because of the adoption of new or revised criteria, or because of changes occurring in the National Airspace System, such as the commissioning of new navigational facilities, adding new obstacles, or changing air traffic requirements. These changes are designed to provide safe and efficient use of the navigable airspace and to promote safe flight operations under instrument flight rules at the affected airports.

The FAA is revising a notice of proposed rulemaking (NPRM) that would have applied to certain Embraer S.A. Model ERJ 170 airplanes. This action revises the NPRM by adding airplanes to the applicability. The FAA is proposing this airworthiness directive (AD) to address the unsafe condition on these products. Since these actions would impose an additional burden over those in the NPRM, the FAA is requesting comments on this SNPRM.

The FAA proposes to adopt a new airworthiness directive (AD) for certain Bombardier, Inc., Model BD-700-2A12 airplanes. This proposed AD was prompted by a report that certain environmental control system (ECS) pre-cooler clamp assemblies may not conform to specifications. This proposed AD would require an inspection of the pre-cooler clamps and replacement of non-conforming pre-cooler clamps. The FAA is proposing this AD to address the unsafe condition on these products.

The FAA is superseding Airworthiness Directive (AD) 2004-04- 09, which applied to certain Pratt & Whitney Canada Corp. (P&WC) JT15D- 1, JT15D-1A, and JT15D-1B model turbofan engines. AD 2004-04-09 required a one-time borescope inspection (BSI) of the rear face of certain impellers for evidence of a machined groove or step, and repair or replacement of the impeller if a groove or step is found. Since the FAA issued AD 2004-04-09, the FAA was notified of an uncontained failure of an impeller installed on a P&WC JT15D-1A engine during takeoff and subsequent investigation by the manufacturer that discovered machining marks on the impeller. This AD was prompted by three prior reports of uncontained failure of the impeller, and one additional recent report of an in-service uncontained failure event. This AD requires borescope fluorescent penetrant inspection (FPI) of the rear face of certain impellers for evidence of machining witness lines and, depending on the results of the inspection, replacement of the impeller, as specified in a Transport Canada AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.

The FAA is adopting a new airworthiness directive (AD) for all Bombardier, Inc., Model BD-700-1A10 and BD-700-1A11 airplanes. This AD was prompted by the determination that radio altimeters cannot be relied upon to perform their intended function if they experience interference from wireless broadband operations in the 3.7-3.98 GHz frequency band (5G C-Band), and a recent determination that this interference can result in unavailable or misleading radio altimeter information, adversely affecting the performance of the automatic flight control system (AFCS) and resulting in increased flightcrew workload during takeoff, approach, and landing below 400 feet above ground level (AGL). This AD requires revising the existing airplane flight manual (AFM) with new limitations to mitigate identified hazards due to 5G C-Band interference as identified by Notices to Air Missions (NOTAMs). The FAA is issuing this AD to address the unsafe condition on these products.