Department of Transportation January 5, 2022 – Federal Register Recent Federal Regulation Documents
Results 1 - 6 of 6
Youth Access to American Jobs in Aviation Task Force; Notice of Public Meeting
This notice announces a meeting of the Youth Access to American Jobs in Aviation Task Force (YIATF).
IFR Altitudes; Miscellaneous Amendments
This amendment adopts miscellaneous amendments to the required IFR (instrument flight rules) altitudes and changeover points for certain Federal airways, jet routes, or direct routes for which a minimum or maximum en route authorized IFR altitude is prescribed. This regulatory action is needed because of changes occurring in the National Airspace System. These changes are designed to provide for the safe and efficient use of the navigable airspace under instrument conditions in the affected areas.
Request for Comments on a Previously Approved Information Collection: Information Associated With the Aviation Manufacturing Jobs Protection (AMJP) Program
In compliance with the Paperwork Reduction Act of 1995, this notice announces that the Information Collection Request (ICR) abstracted below is being forwarded to the Office of Management and Budget (OMB) for review and comments. A Federal Register Notice with a 60-day comment period soliciting comments on the following information collection was published on September 21, 2021. No comments were received.
Joint Petition for Rulemaking To Establish a Voluntary Arbitration Program for Small Rate Disputes; Final Offer Rate Review; Expanding Access to Rate Relief
The Board grants, in part, a motion for an extension of time to file comments in Docket No. EP 765, extending the deadline for reply comments until April 15, 2021. The Board also will extend the deadline for reply comments in Docket Nos. EP 755 and EP 665 (Sub-No. 2) until April 15, 2022.
Airworthiness Directives; Airbus Helicopters
The FAA is superseding Airworthiness Directive (AD) 2020-21-01 for certain Airbus Helicopters Model AS-365N2, AS 365N3, EC 155B, EC155B1, and SA-365N1 helicopters. AD 2020-21-01 required modifying the main gearbox (MGB) tail rotor (T/R) drive flange installation. This AD was prompted by several reported occurrences of loss of tightening torque of the Shur-Lok nut, which serves as a retainer of the MGB T/R drive flange. This AD continues to require modifying the MGB T/R drive flange installation, and includes additional helicopters in the applicability for the required actions. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Airbus Helicopters
The FAA is superseding Airworthiness Directive (AD) 2018-11- 01, which applied to certain Airbus Helicopters Model AS332L2 and EC225LP helicopters. AD 2018-11-01 required installing a cut-out for the left-hand (LH) and right-hand (RH) rail support junction profiles and repetitively inspecting splices, frame 5295, and related equipment for a crack. Since the FAA issued AD 2018-11-01, the manufacturer has developed a modification for in-service helicopters for replacing aluminum splices with steel splices on frame 5295. This AD retains the requirements of AD 2018-11-01 and requires a modification for replacing aluminum splices with steel splices on frame 5295 if cracking is found. This AD also provides terminating action for the repetitive inspections. The FAA is issuing this AD to address the unsafe condition on these products.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
