Department of Transportation September 8, 2021 – Federal Register Recent Federal Regulation Documents
Results 1 - 24 of 24
Qualification of Drivers; Exemption Applications; Vision
FMCSA announces receipt of applications from six individuals for an exemption from the vision requirement in the Federal Motor Carrier Safety Regulations (FMCSRs) to operate a commercial motor vehicle (CMV) in interstate commerce. If granted, the exemptions will enable these individuals to operate CMVs in interstate commerce without meeting the vision requirement in one eye.
Hazardous Materials: Notice of Actions on Special Permits
In accordance with the procedures governing the application for, and the processing of, special permits from the Department of Transportation's Hazardous Material Regulations, notice is hereby given that the Office of Hazardous Materials Safety has received the application described herein.
Hazardous Materials: Notice of Applications for Modifications to Special Permit
In accordance with the procedures governing the application for, and the processing of, special permits from the Department of Transportation's Hazardous Material Regulations, notice is hereby given that the Office of Hazardous Materials Safety has received the application described herein. Each mode of transportation for which a particular special permit is requested is indicated by a number in the ``Nature of Application'' portion of the table below as follows: 1 Motor vehicle, 2Rail freight, 3Cargo vessel, 4Cargo aircraft only, 5Passenger-carrying aircraft.
Entry-Level Driver Training: Application for Exemption; Oak Harbor Freight Lines, Inc.
FMCSA announces that Oak Harbor Freight Lines, Inc., (Oak Harbor) has applied for an exemption from the qualification requirements pertaining to entry-level driver training (ELDT) theory instructors, as set forth in the definition of ``theory instructor''. Oak Harbor requests the exemption so that the company's safety supervisor, Mr. Jeff McLaughlin, will be able to conduct classroom (theory) training for entry-level drivers who intend to operate commercial motor vehicles (CMV) used in the transportation of hazardous materials (HM). The company states the exemption is warranted due to Mr. McLaughlin's experience and expertise related to the transportation of HM. Oak Harbor also states that the road portion of the training would be completed by behind-the-wheel (BTW) instructors that meet the ELDT requirements.
Agency Information Collection Activities: Requests for Comments; Clearance of Renewed Approval of Information Collection: Training and Qualification Requirements for Check Airmen and Flight Instructors
In accordance with the Paperwork Reduction Act of 1995, FAA invites public comments about our intention to request the Office of Management and Budget (OMB) approval to renew an information collection. The collection involves the reporting requirements to ensure the check pilots and instructors are adequately trained and checked/evaluated to ensure they are capable and competent to perform the duties and responsibilities required by the air carrier to meet the regulations. Experienced pilots who would otherwise qualify as flight instructors or check airmen, but who may not medically eligible to hold the requisite medical certificate are mandated to keep records that may be inspected by the FAA to certify eligibility to perform flight instructor or check airmen functions.
Airworthiness Directives; Rolls-Royce Deutschland Ltd & Co KG (Type Certificate Previously Held by Rolls-Royce plc) Turbofan Engines
The FAA is superseding Airworthiness Directive (AD) 2020-13-07 for all Rolls-Royce Deutschland Ltd & Co KG (RRD) Trent 1000-D2, Trent 1000-J2, and Trent 1000-K2 model turbofan engines with a certain part- numbered fuel pump installed. AD 2020-13-07 required removal and replacement of the fuel pump with a part eligible for installation. This AD was prompted by the manufacturer's investigation into an unexpected reduction in fuel pump performance in certain high life fuel pumps and subsequent determination that an additional part-numbered fuel pump is subject to the same unsafe condition. This AD requires new and reduced life limits for certain part-numbered fuel pumps, depending on the engine model the fuel pump is installed on. The FAA is issuing this AD to address the unsafe condition on these products.
Amendment of Class E Airspace; Scott City, KS
This action amends the Class E airspace extending upward from 700 feet above the surface at Scott City Municipal Airport, Scott City, KS. This action is the result of an airspace review due to the decommissioning of the Scott City non-directional beacon (NDB). The geographical coordinates of the airport are also updated to coincide with the FAA's aeronautical database.
Amendment of Class E Airspace; Sac City, IA
This action amends the Class E airspace extending upward from 700 feet above the surface at Sac City Municipal Airport, Sac City, IA. This action is the result of an airspace review caused by the decommissioning of the Sac City non-directional beacon (NDB).
Revocation of Class E Airspace; Standish, MI
This action revokes the Class E airspace extending upward from 700 feet above the surface at Standish Industrial Airport, Standish, MI. This action is the result of an airspace review caused by the closing of the Standish Industrial Airport and associated instrument procedures are no longer required.
Amendment of Class E Airspace; Yoakum, TX
This action amends the Class E airspace extending upward from 700 feet above the surface at Yoakum Municipal Airport, Yoakum, TX. The FAA is proposing this action as the result of an airspace review caused by the decommissioning of the Yoakum non-directional beacon (NDB).
Amendment Class D and Class E Airspace; South Florida
This action amends Class D and Class E airspace in the south Florida area, by updating the geographic coordinates of the following airports; Fort Lauderdale-Hollywood International Airport, Miami-Opa Locka Executive Airport, (formerly Opa Locka Airport), North Perry Airport, Pompano Beach Airpark, Miami International Airport, Homestead ARB, Boca Raton Airport, and Miami Executive Airport (formerly Kendall- Tamiami Executive Airport). This action also updates the geographic coordinates of the Fort Lauderdale Very High Frequency Omnidirectional Range collocated with Distance Measuring Equipment (VOR/DME), and the QEEZY Locator Outer Marker (LOM). Furthermore, this action makes an editorial change replacing the term Airport/Facility Directory with the term Chart Supplement in the legal descriptions of associated Class D and E airspace. Controlled airspace is necessary for the safety and management of instrument flight rules (IFR) in the area.
Airworthiness Directives; Leonardo S.p.a Helicopters
The FAA proposes to adopt a new airworthiness directive (AD) for certain Leonardo S.p.a. (Leonardo) Model AW109SP helicopters. This proposed AD was prompted by reports of an ineligible hydraulic pump being installed on Model AW109SP helicopters. This proposed AD would require inspecting each hydraulic pump for damage and, depending on the inspections results, removing parts from service and accomplishing other corrective actions. This proposed AD would also require removing certain parts from service before they exceed their life limits. The proposed corrective actions would be required to be accomplished as specified in a European Union Aviation Safety Agency (EASA) AD, which is proposed for incorporation by reference (IBR). The FAA is proposing this AD to address the unsafe condition on these products.
Airworthiness Directives; Airbus Helicopters Deutschland GmbH (AHD) Helicopters
The FAA is adopting a new airworthiness directive (AD) for Airbus Helicopters Deutschland GmbH (AHD) Model MBB-BK 117 D-2 helicopters. This AD was prompted by the discovery that certain parts that are approved for installation on multiple helicopter models are life limited parts when installed on Model MBB-BK 117 D-2 helicopters and some helicopter delivery documents excluded the life limit information. This AD requires determining the total hours time-in- service (TIS) of a certain part-numbered rotor mast nut and re- identifying a certain part-numbered rotor mast nut. This AD also requires establishing a life limit for a certain part-numbered rotor mast nut and helical gear support, and removing each part from service before reaching its life limit. Additionally, this AD requires replacing a certain part-numbered main gearbox (MGB) with a not affected MGB as specified in a European Aviation Safety Agency (now European Union Aviation Safety Agency) (EASA) AD, which is incorporated by reference (IBR). The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Airbus Helicopters
The FAA is adopting a new airworthiness directive (AD) for certain Airbus Helicopters Model AS350B, AS350BA, AS350B1, AS350B2, AS350B3, and AS350D helicopters; and Model AS355E, AS355F, AS355F1, AS355F2, AS355N, and AS355NP helicopters. This AD was prompted by reports that the lanyards (bead chain tethers), which hold the quick release pins to the forward bracket assembly of certain litter kits, can loop around the directional control pedal stubs, limiting the movement of the pedals. This AD requires modification of the lanyard attachment location for certain litter kit installations. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Bell Textron Canada Limited Helicopters
The FAA is adopting a new airworthiness directive (AD) for certain Bell Textron Canada Limited Model 505 helicopters. This AD was prompted by three occurrences of metallic debris in the engine oil lubrication system causing the 12 volts direct current (VDC) reference voltage to be shorted to ground and loss of important flight information to the pilot. This AD requires replacing a certain part- numbered relay panel assembly. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Airbus Helicopters Deutschland GmbH Helicopters
The FAA is adopting a new airworthiness directive (AD) for certain Airbus Helicopters Deutschland GmbH Model EC135P1, EC135P2, EC135P2+, EC135P3, EC135T1, EC135T2, EC135T2+, and EC135T3 helicopters. This AD was prompted by a report that geometrical non-conformities were found in the root section of the tail rotor blade (TRB). This AD requires a one-time inspection (dimensional check) of the TRB for conformity and, depending on the findings, replacement of certain affected parts, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. This AD also prohibits rework, repair, or modification of affected parts in the affected area of the TRB assembly root. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Leonardo S.p.a. Helicopters
The FAA is adopting a new airworthiness directive (AD) for certain Leonardo S.p.a. Model AW189 helicopters. This AD was prompted by corrosion on the inlet check valve banjo fitting of emergency flotation system (EFS) float assemblies. This AD requires visually inspecting each banjo fitting installed on an affected EFS float assembly, and depending on the results, removing the banjo fitting from service. This AD also requires applying corrosion inhibiting compound and prohibits installing an affected EFS float assembly unless certain requirements have been accomplished as specified in a European Aviation Safety Agency (now European Union Aviation Safety Agency) (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Leonardo S.p.a. Helicopters
The FAA is adopting a new airworthiness directive (AD) for all Leonardo S.p.a. Model AB412 and AB412 EP helicopters. This AD was prompted by a report of the failure of both inverters in-flight, leading to an autopilot disconnection. This AD requires a one-time inspection of the clearance between a certain protective grommet installed in the emergency bus interlock compartment and the cable assemblies passing through it, and depending on the finding, applicable corrective actions, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Airbus Helicopters
The FAA is superseding Airworthiness Directive (AD) 2016-12- 51, which applied to all Airbus Helicopters Model AS332L2 and Model EC225LP helicopters. AD 2016-12-51 prohibited all further flight of Model AS332L2 and Model EC225LP helicopters. This AD requires replacing certain second stage planet gear assemblies, removing certain epicyclic modules, installing a full flow magnetic plug (FFMP), revising the existing rotorcraft flight manual (RFM) for your helicopter, repetitively inspecting the main gearbox (MGB) particle detectors, repetitively inspecting the MGB oil filter and oil cooler, and corrective action if necessary, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The actions specified in this AD terminate the flight prohibition. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Bell Textron Canada Limited Helicopters
The FAA is adopting a new airworthiness directive (AD) for certain Bell Textron Canada Limited Model 206, 206A, 206A-1 (OH-58A), 206B, 206B-1, 206L, 206L-1, 206L-3, 206L-4, 222, 222B, 222U, 230, 407, 427, 429, and 430 helicopters. This AD was prompted by a report of a shoulder harness seat belt comfort clip (comfort clip) interfering with the seat belt inertia reel. This AD requires removing each comfort clip from service, inspecting the shoulder harness seat belt for any rip and abrasion, and removing any shoulder harness seat belt from service that has a rip or abrasion. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Leonardo S.p.a. Helicopters
The FAA is adopting a new airworthiness directive (AD) for Leonardo S.p.a. Model AB139 and AW139 helicopters with certain main rotor blades installed. This AD was prompted by a report of an in- flight loss of a main rotor blade (MRB) tip cap. This AD requires inspecting the MRB tip cap for disbonding. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Bombardier, Inc., Airplanes
The FAA proposes to supersede Airworthiness Directive (AD) 2017-22-06, which applies to certain Bombardier, Inc., Model CL-600- 2B16 (601-3A, 601-3R, and 604 Variants) airplanes. AD 2017-22-06 requires repetitive inspections for fuel leakage at the engine and auxiliary power unit (APU) fuel pumps, and related investigative and corrective actions if necessary. Since the FAA issued AD 2017-22-06, terminating actions have been developed and additional airplanes have been determined to be affected by the unsafe condition. This proposed AD would retain the requirements of AD 2017-22-06, and require an inspection of the APU, repair if necessary, and modification of the engine electrical fuel pump (EFP) installation. This proposed AD would also add airplanes to the applicability. The FAA is proposing this AD to address the unsafe condition on these products.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
