Department of Transportation June 30, 2020 – Federal Register Recent Federal Regulation Documents

FMCSA announces its decision to exempt 11 individuals from the hearing requirement in the Federal Motor Carrier Safety Regulations (FMCSRs) to operate a commercial motor vehicle (CMV) in interstate commerce. The exemptions enable these hard of hearing and deaf individuals to operate CMVs in interstate commerce.

FMCSA announces its decision to renew exemptions for 58 individuals from the vision requirement in the Federal Motor Carrier Safety Regulations (FMCSRs) for interstate commercial motor vehicle (CMV) drivers. The exemptions enable these individuals to continue to operate CMVs in interstate commerce without meeting the vision requirement in one eye.

The Moving Ahead for Progress in the 21st Century Act (MAP-21) established the Surface Transportation Project Delivery Program that allows a State to assume FHWA's environmental responsibilities for environmental review, consultation, and compliance under the National Environmental Policy Act (NEPA) for Federal highway projects. When a State assumes these Federal responsibilities, the State becomes solely responsible and liable for carrying out the responsibilities it has assumed, in lieu of FHWA. This program mandates annual audits during each of the first 4 years of State participation to ensure compliance with program requirements. This notice makes available the final second audit report for the Alaska Department of Transportation and Public Facilities (DOT&PF).

The FAA proposes to adopt a new airworthiness directive (AD) for all The Boeing Company Model 747-100, 747-100B, 747-100B SUD, 747- 200B, 747-200C, 747-200F, 747-300, 747-400, 747-400D, 747-400F, 747SR, and 747SP series airplanes. This proposed AD was prompted by a determination that the upper wing skin at engine nacelle points may be subject to undetected cracking. This proposed AD would require repetitive ultrasonic inspections of the upper wing skin at certain engine strut positions for cracking; repetitive detailed and ultrasonic inspections of the strut lower spar fitting, diagonal brace strut end clevis, and diagonal brace wing attach end clevis for cracking; repetitive detailed inspections of lower link fitting at certain engine strut positions for cracking; and applicable on-condition actions. The FAA is proposing this AD to address the unsafe condition on these products.

This action proposes special conditions for the Boeing Commercial Airplanes (Boeing) Model 777-9 airplane. This airplane will have a novel or unusual design feature when compared to the state of technology envisioned in the airworthiness standards for transport- category airplanes. This design feature is an overhead flightcrew rest (OFCR) compartment occupiable during taxi, takeoff, and landing (TT&L). The applicable airworthiness regulations do not contain adequate or appropriate safety standards for this design feature. These proposed special conditions contain the additional safety standards that the Administrator considers necessary to establish a level of safety equivalent to that established by the existing airworthiness standards.