Department of Transportation April 20, 2020 – Federal Register Recent Federal Regulation Documents

Airworthiness Directives; The Boeing Company Airplanes
Document Number: 2020-08406
Type: Proposed Rule
Date: 2020-04-20
Agency: Federal Aviation Administration, Department of Transportation
The FAA proposes to adopt a new airworthiness directive (AD) for all The Boeing Company Model 737-8 and 737-9 airplanes. This proposed AD was prompted by a report that, after the removal of a spring door opening system (SDOS) actuator with a certain part number, the actuator came apart, injuring one of the maintenance personnel. A design that obscures the SDOS actuator safety marker when the fan cowls are opened contributed to this incident. This proposed AD would require replacing each affected SDOS actuator with a new SDOS actuator and verifying that new safety markers are installed in the proper locations. The FAA is proposing this AD to address the unsafe condition on these products.
Hours of Service of Drivers: Pronto.ai, Inc. (Pronto); Application for Exemption
Document Number: 2020-08343
Type: Notice
Date: 2020-04-20
Agency: Federal Motor Carrier Safety Administration, Department of Transportation
FMCSA announces that it has received an application from Pronto.ai, Inc. (``Pronto'') on behalf of its interstate motor carrier customers, for a renewable five-year exemption from the 11-hour driving limit and the 14-hour driving window in the Agency's hours-of-service (HOS) requirements. Pronto is requesting that drivers operating commercial motor vehicles (CMVs) equipped with the Copilot by Pronto advanced driver assistance systems (ADAS), the SmartDrive[supreg] Video Safety Program, and operating under certain other safeguards, be allowed to drive up to 13 hours during a period of 15 consecutive hours after coming on duty following 10 consecutive hours off duty. FMCSA requests public comment on Pronto's application for exemption.
Airworthiness Directives; PZL Swidnik S.A. Helicopters
Document Number: 2020-08297
Type: Rule
Date: 2020-04-20
Agency: Federal Aviation Administration, Department of Transportation
The FAA is adopting a new airworthiness directive (AD) for PZL Swidnik S.A. (PZL) Model PZL W-3A helicopters. This AD requires inspecting the main gearbox (MGB) bolts and washers to determine if they are properly locked and, depending on the inspection outcome, removing the engine, removing certain bolts from service, and performing more in-depth inspections; and depending on the outcome of those inspections, replacing the graphite seal assembly or removing it from service. Finally, this AD prohibits installing any affected MGB on a helicopter unless it has met the requirements of this AD. This AD was prompted by reports that the bolts securing the input quill and graphite seal assembly of the MGB were not properly locked. The actions of this AD are intended to address an unsafe condition on these products.
Rescission of the Notice of Intent for an Environmental Impact Statement: Hartford County, Connecticut
Document Number: 2020-08273
Type: Notice
Date: 2020-04-20
Agency: Federal Highway Administration, Department of Transportation
The FHWA is issuing this notice to advise the public that we are rescinding the Notice of Intent (NOI) to prepare an Environmental Impact Statement (EIS) for the I-84 Hartford Project in Hartford County, Connecticut.
Agency Information Collection Activities; Renewal of a Currently-Approved Information Collection Request: Annual Report of Class I and Class II For-Hire Motor Carriers
Document Number: 2020-08262
Type: Notice
Date: 2020-04-20
Agency: Federal Motor Carrier Safety Administration, Department of Transportation
In accordance with the Paperwork Reduction Act of 1995, FMCSA announces its plan to submit the Information Collection Request (ICR) described below to the Office of Management and Budget (OMB) for its review and approval and invites public comment. FMCSA requests approval to renew the previously approved ICR now titled, ``Annual Report of Class I and Class II For-Hire Motor Carriers,'' OMB Control No. 2126- 0032. This ICR is necessary to comply with FMCSA's financial and operating statistics requirements at chapter III of title 49 CFR part 369 titled, ``Reports of Motor Carriers.''
Airworthiness Directives; 328 Support Services GmbH (Type Certificate Previously Held by AvCraft Aerospace GmbH; Fairchild Dornier GmbH; Dornier Luftfahrt GmbH) Airplanes
Document Number: 2020-08229
Type: Rule
Date: 2020-04-20
Agency: Federal Aviation Administration, Department of Transportation
The FAA is superseding Airworthiness Directive (AD) 2004-06- 01, which applied to certain Dornier Model 328-100 series airplanes; and AD 2009-06-09, which applied to all Dornier Model 328-100 series airplanes. AD 2004-06-01 required replacement of the existing main landing gear (MLG) leg assembly with a modified assembly. AD 2009-06-09 required modifying the MLG main body and trailing arm bushings, and revising the existing maintenance or inspection program, as applicable, to incorporate new or more restrictive airworthiness limitations. This AD continues to require revising the existing maintenance or inspection program, as applicable, to incorporate new or more restrictive airworthiness limitations; as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. This AD was prompted by a determination that new or more restrictive airworthiness limitations are necessary. The FAA is issuing this AD to address the unsafe condition on these products.
Notice of Funding Opportunity for Consolidated Rail Infrastructure and Safety Improvements
Document Number: 2020-08226
Type: Notice
Date: 2020-04-20
Agency: Federal Railroad Administration, Department of Transportation
This notice details the application requirements and procedures to obtain grant funding for eligible projects under the Consolidated Rail Infrastructure and Safety Improvements (CRISI) Program. CRISI Program funding under this notice is provided by the Further Consolidated Appropriations Act, 2020 (2020 Appropriation). The opportunities described in this notice are made available under Catalog of Federal Domestic Assistance (CFDA) number 20.325, ``Consolidated Rail Infrastructure and Safety Improvements.''
Airworthiness Directives; ATR-GIE Avions de Transport Régional Airplanes
Document Number: 2020-08225
Type: Rule
Date: 2020-04-20
Agency: Federal Aviation Administration, Department of Transportation
The FAA is adopting a new airworthiness directive (AD) for certain ATRGIE Avions de Transport R[eacute]gional Model ATR72 airplanes. This AD was prompted by occurrences of smoke in the flight deck and flap extension difficulties due to wire chafing on the electrical harness under a certain panel. This AD requires modifying the clamp installation of the electrical routing on a certain rib of the left- and right-hand side of the wing rear spars, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Yaborã Indústria Aeronáutica S.A. (Type Certificate Previously Held by Embraer S.A.) Airplanes
Document Number: 2020-08219
Type: Rule
Date: 2020-04-20
Agency: Federal Aviation Administration, Department of Transportation
The FAA is adopting a new airworthiness directive (AD) for certain Yabor[atilde] Ind[uacute]stria Aeron[aacute]utica S.A. Model ERJ-170 airplanes and Model ERJ 190-100 STD, -100 LR, -100 ECJ, -100 IGW, -200 STD, -200 LR, and -200 IGW airplanes. This AD was prompted by a determination that certain main landing gear (MLG) aft pintle pins repaired using a sulphamate nickel plating have a life limit that is less than the certified life limit. This AD requires a one-time records review or a general visual inspection (GVI) of the MLG aft pintle pins to determine if certain repairs were done, and replacement of certain MLG aft pintle pins with serviceable MLG aft pintle pins, as specified in an Ag[ecirc]ncia Nacional de Avia[ccedil][atilde]o Civil (ANAC) Brazilian AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Hours of Service of Drivers: McKee Foods Transportation, LLC, Application for Exemption
Document Number: 2020-08207
Type: Notice
Date: 2020-04-20
Agency: Federal Motor Carrier Safety Administration, Department of Transportation
FMCSA announces its decision to renew McKee Foods Transportation, LLC's (MFT) exemption from the hours-of-service (HOS) regulation pertaining to the use of a sleeper berth. Current HOS rules require that all sleeper-berth rest regimens include, in part, the regular use of a sleeper-berth period for at least 8 hourscombined with a separate period of at least 2 hours, either in the sleeper berth, off duty, or some combination of bothto gain the equivalent of at least 10 consecutive hours off duty. The exemption enables MFT team drivers to take the equivalent of 10 consecutive hours off duty by splitting sleeper-berth time into two periods totaling 10 hours, provided neither of the two periods is less than 3 hours. FMCSA has analyzed the exemption application and the public comments and has determined that the exemption, subject to the terms and conditions imposed, will achieve a level of safety that is equivalent to, or greater than, the level that would be achieved absent such exemption.
Qualification of Drivers; Exemption Applications; Vision
Document Number: 2020-08206
Type: Notice
Date: 2020-04-20
Agency: Federal Motor Carrier Safety Administration, Department of Transportation
FMCSA announces its decision to renew exemptions for 114 individuals from the vision requirement in the Federal Motor Carrier Safety Regulations (FMCSRs) for interstate commercial motor vehicle (CMV) drivers. The exemptions enable these individuals to continue to operate CMVs in interstate commerce without meeting the vision requirements in one eye.
Airworthiness Directives; Saab AB, Support and Services (Formerly Known as Saab AB, Saab Aeronautics) Airplanes
Document Number: 2020-08202
Type: Rule
Date: 2020-04-20
Agency: Federal Aviation Administration, Department of Transportation
The FAA is adopting a new airworthiness directive (AD) for all Saab AB, Support and Services Model SAAB 2000 airplanes. This AD was prompted by a determination that new or more restrictive airworthiness limitations are necessary. This AD requires revising the existing maintenance or inspection program, as applicable, to incorporate new or more restrictive airworthiness limitations, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Airbus SAS Airplanes
Document Number: 2020-08201
Type: Rule
Date: 2020-04-20
Agency: Federal Aviation Administration, Department of Transportation
The FAA is superseding Airworthiness Directive (AD) 2017-05- 12, which applied to certain Airbus SAS Model A318-112 airplanes; Model A319-111, -112, -115, -132, and -133 airplanes; Model A320-214, -232, and -233 airplanes; and Model A321-211, -212, -213, -231, and -232 airplanes. AD 2017-05-12 required a one-time eddy current conductivity measurement of certain cabin, cargo compartment, and frame structural parts to determine if aluminum alloy with inadequate heat treatment was used, and replacement if necessary. This AD retains the requirements of AD 2017-05-12, and for certain airplanes, requires additional work, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. This AD was prompted by a determination that aluminum alloy with inadequate heat treatment had been used for additional structural parts. The FAA is issuing this AD to address the unsafe condition on these products.
Proposed Amendment of Class E Airspace; Glens Falls, NY
Document Number: 2020-08175
Type: Proposed Rule
Date: 2020-04-20
Agency: Federal Aviation Administration, Department of Transportation
This action proposes to amend Class E surface airspace, and Class E airspace extending upward from 700 feet above the surface at Floyd Bennett Memorial Airport, (previously Warren County Airport), Glens Falls, NY due to the decommissioning of the Glens Falls VORTAC, and cancellation of associated approaches. Controlled airspace is necessary for the safety and management of instrument flight rules (IFR) operations in the area. This action also would update the airport's name.
Pipeline Safety: Farm Taps Frequently Asked Questions
Document Number: 2020-07922
Type: Proposed Rule
Date: 2020-04-20
Agency: Pipeline and Hazardous Materials Safety Administration, Department of Transportation
The Pipeline and Hazardous Materials Safety Administration (PHMSA) is making available for comment a set of proposed frequently asked questions (FAQs) regarding individual service lines directly connected to production, gathering, or transmission pipelines, commonly referred to as farm taps. The proposed FAQs address the applicability of the Federal Pipeline Safety Regulations and include guidance related to the Exercise of Enforcement Discretion Regarding Farm Taps published in the Federal Register on March 26, 2019.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.