Department of Transportation May 30, 2018 – Federal Register Recent Federal Regulation Documents

In accordance with the Paperwork Reduction Act of 1995, FAA invites public comments about our intention to request the Office of Management and Budget (OMB) approval for renewal and revision to an information collection. The Federal Register Notice with a 60-day comment period soliciting comments on the following collection of information was published on March 30, 2018. This information collection is used to allocate airport landing and takeoff slots and maintain accurate records of slot transfers at Ronald Reagan Washington National Airport (DCA) under the High Density Rule. The FAA is requesting a renewal for the DCA information collection and a revision to include six additional airports managed under similar FAA programs to manage congestion and delay: John F. Kennedy International Airport (JFK), LaGuardia Airport (LGA), Los Angeles International Airport (LAX), Newark Liberty International Airport (EWR), O'Hare International Airport (ORD), and San Francisco International Airport (SFO). The information collection is required from carriers and other operators at the airports to assist the FAA in reducing delays at congested airports.

This notice contains a summary of a petition seeking relief from specified requirements of Title 14 of the Code of Federal Regulations. The purpose of this notice is to improve the public's awareness of, and participation in, the FAA's exemption process. Neither publication of this notice nor the inclusion or omission of information in the summary is intended to affect the legal status of the petition or its final disposition.

These special conditions are issued for the Bombardier Inc. Model BD-700-2A12 and Model BD-700-2A13 airplanes. This airplane will have a novel or unusual design feature when compared to the state of technology envisioned in the airworthiness standards for transport category airplanes. This design feature is an autobrake system that allows earlier braking at landing without pedal input from the pilot. The applicable airworthiness regulations do not contain adequate or appropriate safety standards for this design feature. These special conditions contain the additional safety standards that the Administrator considers necessary to establish a level of safety equivalent to that established by the existing airworthiness standards.

We propose to adopt a new airworthiness directive (AD) for certain Bombardier, Inc., Model DHC-8-400 series airplanes. This proposed AD was prompted by reports of the nose landing gear (NLG) locking in a partially extended position due to loose bushings on the lock link of the NLG locking mechanism. This proposed AD would require inspecting the bushings and the lower lock link of the NLG for discrepancies, and corrective actions if necessary. We are proposing this AD to address the unsafe condition on these products.

We propose to adopt a new airworthiness directive (AD) for certain Dassault Aviation Model FALCON 900EX airplanes. This proposed AD was prompted by reports of rejected take-offs due to untimely inboard flap retraction. This proposed AD would require modification of the slat/flap control wiring and replacement of the slat/flap control box with an improved box. We are proposing this AD to address the unsafe condition on these products.

The Federal Transit Administration (FTA) is issuing a final rule describing new, experimental procedures to encourage increased project management flexibility, more innovation in project funding, improved efficiency, timely project implementation, and new project revenue streams for public transportation capital projects. A primary goal of this final rule is to address impediments to the greater use of public-private partnerships and private investment in public transportation capital projects. FTA anticipates using the lessons learned from these experimental procedures to develop more effective approaches to including private participation and investment in project planning, project development, finance, design, construction, maintenance, and operations.